全文获取类型
收费全文 | 11730篇 |
免费 | 2309篇 |
国内免费 | 2156篇 |
专业分类
化学 | 3272篇 |
晶体学 | 231篇 |
力学 | 4093篇 |
综合类 | 162篇 |
数学 | 1394篇 |
物理学 | 7043篇 |
出版年
2024年 | 22篇 |
2023年 | 99篇 |
2022年 | 261篇 |
2021年 | 378篇 |
2020年 | 359篇 |
2019年 | 321篇 |
2018年 | 317篇 |
2017年 | 473篇 |
2016年 | 591篇 |
2015年 | 533篇 |
2014年 | 709篇 |
2013年 | 1141篇 |
2012年 | 796篇 |
2011年 | 907篇 |
2010年 | 753篇 |
2009年 | 833篇 |
2008年 | 850篇 |
2007年 | 906篇 |
2006年 | 828篇 |
2005年 | 731篇 |
2004年 | 588篇 |
2003年 | 564篇 |
2002年 | 481篇 |
2001年 | 425篇 |
2000年 | 397篇 |
1999年 | 323篇 |
1998年 | 364篇 |
1997年 | 219篇 |
1996年 | 171篇 |
1995年 | 134篇 |
1994年 | 143篇 |
1993年 | 119篇 |
1992年 | 85篇 |
1991年 | 74篇 |
1990年 | 64篇 |
1989年 | 39篇 |
1988年 | 37篇 |
1987年 | 32篇 |
1986年 | 29篇 |
1985年 | 35篇 |
1984年 | 14篇 |
1983年 | 7篇 |
1982年 | 14篇 |
1981年 | 2篇 |
1980年 | 5篇 |
1979年 | 5篇 |
1978年 | 3篇 |
1976年 | 4篇 |
1959年 | 1篇 |
1957年 | 6篇 |
排序方式: 共有10000条查询结果,搜索用时 984 毫秒
51.
52.
电站锅炉系统性能仿真模型的建立 总被引:1,自引:0,他引:1
1引言根据热力学第二定律,燃料中的化学拥将近一半损失在锅炉的燃烧与传热过程中。因此,优化锅炉性能对降低整个火电机组的煤耗率具有明显效果。完整的锅炉系统由磨煤机、送风机、一次风机、弓讯机、炉膛、汽包、过热器、再热器、省煤器、空气预热器等单元组成,这些单元之间的联结错综复杂。本文建立了锅炉系统中通用单元的性能模型,并在此基础上,对锅炉系统的结构特点进行了分析,利用过程系统工程中的序贯模块法建立了整个锅炉系统的性能模型。对单元的划分、回路的切断及断裂流股的收敛与迭代策略提出了自己的观点。最后根据生产厂… 相似文献
53.
54.
We consider the isothermal flow through a cylindrical flat chamber, a model of some particular heat exchanger, for which LDV measurements and a numerical simulation have been performed. Experimental results show the establishment of an important vortex zone, the secondary flow extending all along the chamber radius. This observation leads to an expected significant increase of the fluid mixing. Results issued from the numerical simulation appear to be in close agreement with experimental data. Nevertheless, the k–ε model used here must be improved to obtain a better approach near the vortex centre. To cite this article: S. Petitot et al., C. R. Mecanique 330 (2002) 593–599. 相似文献
55.
脉冲压缩光栅光路调节新方法研究 总被引:2,自引:1,他引:1
介绍了一种简单而实用的大口径脉冲压缩光栅光路调节方法,有效解决了普通光路调节方法中轴向调节精度不高的问题。首先由全息透镜(光栅)成像公式出发,推导出了该光路调节的基本原理。并从光栅记录系统与光栅衍射波像差的关系,结合初级像差理论推导得出叠栅条纹像差为0.4786λ,大约是光栅衍射波像差(0.25λ)的两倍,利用此关系也可对光栅衍射波像差进行实时监测。从数值模拟结果可知,利用叠栅条纹法调节光路可将光栅波像差减至0.06λ,相应的轴向误差量为0.007 mm,可有效提高了轴向调节精度。 相似文献
56.
Quantitative H–Al distances in acid sites of two zeolites with MFI and IFR framework topology were obtained by numerical simulation of 1H{27Al} rotational echo adiabatic passage double resonance (REAPDOR) experiments. A 27Al offset-dependent data set yields for each resolved 1H NMR line a corresponding nuclear electric quadrupole coupling constant of the neighboring 27Al site. This information is used for analyzing a second data set for on-resonance irradiation, where the dipolar evolution time (number of rotor cycles) was varied, to yield the 1H–27Al dipolar coupling constant. Numerical simulations indicate that the REAPDOR method does not depend significantly on the polar angles, defining the orientation of the electric field gradient tensor of 27Al with respect to the Al–H dipolar vector. In contrast, the transfer of populations in double resonance sequence is sensitive to these angles, and it can be thus used to measure them. 相似文献
57.
用分子动力学方法模拟了空位在金刚石近(001)表面的扩散过程,研究了温度对空位扩散的影响.结果表明,当温度为1000K左右时,位于近表面第二层上的空位开始向表面运动;当温度在1400—2000K时,空位完全扩散到表面.这与实验结果和其他计算结果符合得很好.同时发现,温度为1400—1800K时,空位的扩散经历了两次迁移运动,其分别对应了均方位移图中的两个极大值.在不施加任何约束的条件下得到了空位的动态扩散路径,空位在金刚石近(001)表面的扩散势垒约为042eV.并探讨了一定温度下空位数目增多及其不同排列
关键词:
金刚石
空位
扩散
分子动力学 相似文献
58.
A convergent-barrel (CB) cold spray nozzle was designed through numerical simulation. It was found that the main factors influencing significantly particle velocity and temperature include the length and diameter of the barrel section, the nature of the accelerating gas and its pressure and temperature, and the particle size. Particles can achieve a relatively low velocity but a high temperature under the same gas pressure using a CB nozzle compared to a convergent-divergent (CD) nozzle. The experiment results with Cu powder using the designed CB nozzle confirmed that particle deposition can be realized under a lower gas pressure with a CB nozzle. 相似文献
59.
This paper describes the performance and simulation of a compact integrated optical processor for the real-time reconstruction of two-dimensional images in airborne stripmap synthetic aperture radar applications. The functional behavior of the processor is explained in some detail. The design criteria are briefly given. The simulation step allowed the main processor characteristics and properties to be identified. A number of comparisons were obtained in airborne SAR mission scenarios between the predictions of the optical device and those achieved by the modern electronic digital approach, based on the wavefront reconstruction method by matched filtering. 相似文献
60.