Lightness Change as Perceived in Relation to the Size of Recognized Visual Space of Illumination

According to the concept of the recognized visual space of illumination (RVSI) the lightness of an object surface is perceived in relation to its conceptualized size. To prove this proposition the lightness of gray test patches was judged when they were located at various positions inside an illuminated space composed of two rooms in the depth direction from a subject. No retinal image arrangement was changed in the test patch and its immediate surroundings, but the front room had walls, floors and furniture lower in lightness by the amount of N1.5 than the back room to make the RVSI of the former smaller despite the illuminance in the entire space being the same. The results showed that the apparent lightness of the patches was perceived higher by amount of about 13 in L units for the N4 test patch and about 20 for N6 when the patches were located in the front room, in accordance with the prediction. It was stressed that the experiment of lightness judgment should be conducted in a three dimensional space rather than two dimensional plane as done by several investigators.     

荧光光纤温度传感器激励光源的选择

本文分析计算了荧光光纤温度传感器的温敏元件——GsAlAs/GaAs双异质结半导体材料的荧光辐射效率与激励光波长的关系。讨论了温度测量范围及温敏元件GaAlAs层铝含量对激励光源的限制,在0～200℃测温范围内,若采用LED作激励光源,其峰值波长应在0.70～0.76μm之间选择。     

基于CT算法的束团横向相空间测量

精确测量束团的发射度和横向相空间, 在高亮度电子束的产生和应用中具有重要意义. 传统测量方法在测量发射度时需要对束团在相空间内分布进行初始假设, 且只能给出相椭圆的twiss参数;基于CT(computerized tomography)算法的束团横向相空间测量方法无需先验假设, 能给出粒子在相空间内的真实分布, 测量结果更为精确. 介绍了基于CT算法的束团横向相空间测量的原理和初步实验结果, 并与四极透镜扫描法测量的结果进行了比较.     

A coincidence transmission electron microscope with digital waveform measuring system for analytical microscopy

We have been developing a new analytical transmission electron microscope (TEM), called a coincidence TEM, which in principle enables elemental mapping images to be observed at a high signal‐to‐noise (S/N) ratio under very low dose radiation conditions. In this paper, we report the development of a coincidence TEM with a digital waveform measuring system for obtaining a coincidence elemental mapping image. In this system, analog signals detected by a Si(Li) detector and a multianode, position‐sensitive photomultiplier (PSPM) are continuously converted into 12‐bit digital waveform data at a rate of 100 MHz, and transferred to a PC. From the transferred digital waveform data, information on X‐ray photon energy, electron incident position, and detection times of both X rays and electrons are calculated by digital waveform measurement, which lead to the observation of a successful coincidence elemental mapping image. Copyright © 2005 John Wiley & Sons, Ltd.     

Secure Direct Communication Using Ensembles with the Same Compressed Density Matrix

In this paper, a quantum secure direct communication protocol using ensembles with the same density matrix is proposed. The two communication parties can realize the message transmission using this method through a quantum channel, each bit of information can be transmitted using an ensemble and read out through global measurement.The eavesdropping behavior can be detected through the channel diagnoses.     

聚甲基丙烯酸甲酯掺杂Ce3+的飞秒激光三维信息存储

用飞秒激光(200 fs,1 kHz,800 nm)脉冲在掺杂稀土离子Ce3 的聚甲基丙烯酸甲酯(PMMA)膜中进行了光存储实验研究,包括对样品的吸收光谱、激光照射前后的电子旋转共振(Electron spin resonance,ESR)光谱的测量和讨论。结果表明掺杂稀土离子Ce3 的聚甲基丙烯酸甲酯膜具有较低的写入阈值,有利于高速、并行的三维光存储。实验结果采用传统光学显微镜并行读出。给出了四层存储结果(点间距和层间距分别是4μm和16μm),并讨论了脉冲能量的大小对空腔尺寸的影响,进行高密度存储时,在保证读出信号灰度值足够大的情况下,应选择尽量小的激光脉冲写入能量。实验结果表明这种材料可以应用于三维光信息存储。     

微粒大小及其分布的光电复合检测

叙述一种新的光电复合测量技术，它集ＣＣＤ摄像显示，微机信息采集与处理，光不投影放大，显微镜目视判读为一体，可对微粒大小及其空间分布实行多通道测量，观察和分析。     

透射式跑道能见度激光测量仪的研究

介绍了一种利用激光测量跑道水平及斜视能见度的智能化仪器。该仪器主要由光学系统、信号放大与处理系统及显示系统三部分组成。简要介绍了该仪器的基本结构、工作原理和主要技术指标，讨论了其中的技术难点及其相应的解决办法。     

超快光电测量技术

本文综述了近年来趔快光电测量技术的新进展，其中包括扭快光电材料的特性、高速光电器件的基本原理，着重介绍了若干主要的用快光电测量技术．     

钢卷尺刻度在线测量系

本文介绍了一种钢卷尺刻度在线测量系统 ,它采用了高速摄像及计算机数据处理技术 ,文章阐述了系统的非接触动态测量原理 ,描述了光电信号的处理方法 .