Interconnection between the Structures and Sorption Characteristics of Mesophase Materials of MCM-41 Type Containing Alkylpyridines

Under the conditions studied for the synthesis of mesophase materials with alkylpyridinium halides an increase in the density of packing of these molecules in the encapsulated micelles was observed with an increase in the length of the alkyl radicals. The difference in the density of packing of these surface active reagents (SAR) depended to a considerable extent on the perfection of the hexagonal structure and the characteristic absorption properties of the mesophase materials of MCM-41 type.     

Sol-gel polyimide-silica composite membrane: gas transport properties

The effect of introduction of silica particles prepared by the sol-gel technique on the gas transport properties of a polyimide film was studied. The sorption and permeation of N₂, O₂, CO₂, H₂ and CH₄ were studied and correlated with morphological changes in the polymer structure. From sorption isotherms, we observed that the composite membrane presents higher solubility coefficients than the polyimide one. The solubility coefficient ratio between the composite and the polyimide is about 1.5–2.0. The isotherms were analyzed in terms of the dual mode sorption. The Henry's coefficient and the Langmuir's affinity and saturation constants were obtained allowing to calculate the Langmuir to Henry concentration ratios as function of the gas pressure. These ratios decrease until zero within a certain pressure range as long as the Langmuir's mode is acting and they are higher for the polyimide membrane when compared with the composite one. This study was completed with calorimetric measurements during the sorption. The gas interaction energy in kJ/mol decreases within the same pressure range as previously described. The measured energies are higher for the polyimide film when compared with the composite one because the polyimide membrane presents a stronger energetic effect caused by a higher Langmuir's contribution. From permeation studies at 3.15⁵ Pa, the composite membrane showed higher permeability coefficients and permselectivities than the polyimide one. All these results were explained, taking into account the difference on the imidization degree of both membranes and the morphological changes which may be induced by the silica nodules in the organic/inorganic interphases.     

Sorption of alkali metals and silver nitrates from binary and multicomponent solutions by a crown-containing polymer

The equilibrium in the systems containing a polymer based on dibenzo-18-crown-6 and binary or multicomponent aqueous solutions of NaNO₃, KNO₃, RbNO₃, and AgNO₃ was studied. The constants of the sorption of the individual electrolytes from solution into the polymer were determined. Preliminary calculations of the phase composition on sorption of 11 mixtures of electrolytes with a common anion from the data on the equilibria in the systems with one electrolyte are possible.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 3, pp. 464–466, March, 1993.     

Fine characterization of the ethylene and ethane sorption in poly(amide 12-block-tetramethylenoxide) copolymer/AgBF4 membranes

Ethylene/ethane sorption characteristics were determined for dry Pebax™ (poly(amide 12-block-tetramethylenoxide) copolymer)/AgBF₄ membranes by using an electronic microbalance. The membranes containing 0.7 and 22 wt.% AgBF₄ showed a dual-mode sorption isotherm. The ethane isotherms for all the membranes were of the Henry-type, which is the normal sorption for gases in rubbery polymers. The abnormal presence of Langmuir sorption sites only for ethylene in the rubbery copolymer, never reported sofar, is attributed to the silver-based specific complexation sites. The silver salt which dissolved in limited amounts in the rubbery copolymer had a much smaller Langmuir sorption capacity than the salt that crystallized in the copolymer. The sorption kinetics indicate that the crystallized salt did adsorb slowly ethylene according to a zeroth-order kinetics, but not ethane. The gas uptake kinetics resulting from a step of the pressure surrounding the copolymer exhibited one stage for ethane but two stages for ethylene. For the latter, there was first a fast Fickian sorption stage, then a drift of the zeroth-order sorption of ethylene on salt crystals, which contributes for a large part to the total uptake. The zeroth-order sorption suggests that the sorbed ethylene amount in the second-stage is independent of the crystal-surface coverage. The value of the Fickian diffusion coefficient calculated by fitting the kinetics with a solution of the second Fick’s law was 5 × 10⁻¹² m²/s for both ethylene (the first stage) and ethane, and is typical for small organic compounds in a rubbery material.     

Sorption of water vapor on cation-substituted vermiculite

Deformations of Na, Ca, and Ba vermiculites upon sorption of water vapor have been determined by a dilatometric method. Sequential stages in the hydration of interlayer exchange cations have been identified. The experimental results have been compared with data obtained in studies using adsorptive, calorimetric, and x-ray methods.Institute of Physical Chemistry, Russian Academy of Sciences, 117915 Moscow. Institute of Colloid Chemistry and the Chemistry of Water, Academy of Sciences of the Ukraine, Kiev. Translated from Izvestiya Akademii Nauk, Seriya Khimicheskaya, No. 1, pp. 34–39, January, 1992.     

自由体积与亲水性对环氧涂层防护性能的影响

报道了涂层聚合物自由体积和亲水性对涂层腐蚀防护性能影响的初步研究结果.实验表明,相对于自由体积,树脂的亲水性是决定树脂吸水率的更主要因素.低亲水性涂层腐蚀防护性能的提高主要源自到达涂层/金属界面的水量的显著降低.但由于采用活性酯固化的环氧树脂涂层中水通道的尺寸相对较大,水合离子扩散较容易,因此该类涂层覆盖下的金属基体被润湿部分的腐蚀趋势反而较一般涂层为大.     

Specific surface of two hydrated cements differing in strength

Specific surface, S, of CSH-gel particles of disordered layered structure, was studied by water sorption/retention in two cement pastes differing in strength, i.e. C-33 (weaker) and C-43 (stronger), w/c=0.4. Hydration time in liquid phase was t _h=1 and 6 months, followed by hydration in water vapour either on increasing stepwise the relative humidity, RH=0.5→0.95→1.0 (WS) or on its lowering in an inverse order (WR). Specific surface was estimated from evaporable (sorbed) water content, EV (110°C), assuming a bi- and three-molecular sorbed water layer at RH=0.5 or 0.95, respectively (WS). On WR it was three- and three- to four-molecular (50 to 75%), respectively, causing a hysteresis of sorption isotherm. At RH=0.5 the S increased with cement strength from 146 m² g^-1 (C-33, 1 m) to 166 m² g^-1 (C-43, 1 m) and with hydration time to 163 (C-33, 6 m) and to 204 m² g^-1 (C-43, 6 m). At RH=1.0 (and 0.95), higher S-value were measured but these differences were smaller: S amounted to 190-200 m² g^-1 in C-33 (1 and 6 m) and 198-210 m² g-1 in C-43 (1 and 6 m). Thus no collapse occurred on air drying of paste C-43 (6 m). This revised version was published online in July 2006 with corrections to the Cover Date.     

A thermodynamic analysis on the coincidence of extrema conditions in the sorption equilibrium for ternary polymer systems

Flory-Huggins theory of polymer solutions has been used to express the condition of extrema values in the total sorption, as well as the inversion point in the preferential adsorption parameters for termary polymer systems. Two approaches have been followed, the first considers the binary and ternary interaction parameters independent of polymer concentration and solvent composition. In the second one, this dependence has been introduced. Our attention is focused on the volume fraction of solvent mixture dependence of the above parameters, in order to confirm or not the coincidence between the extrema values and the inversion point. Several cosolvent and cononsolvent ternary polymer systems, have been used to test the validity of the equations obtained. Also, it has been verified, from an experimental point of view, that in cosolvent ternary polymer systems there is coincidence in both compositions while in cononsolvent ternary polymer systems, such coincidence does not appear.     

INTROMISSION OF WATER-REPELLENT AND HYDROSCOPIC PROPERTIES SIMULTANEOUSLY TO PP BY PLASMA DISCHARGE METHOD

Plasma-induced surface graft copolymerization of acrylic acid on polypropylene non-woven fabric (PP-g-AA) and polypropylene membrane were reported. The extents of grafting were controlled by the plasma and polymerization condition. Hexadecyltrimethyl ammonium bromide was then coupled with the carboxyl group of PP-g-AA to obtain a polyion complex (PIC). At last, CF4 plasma was used to give PICs hydrophobic property. The moisture regain and water-repellency of the processed PICs was investigated. The surfaces were characterized using ATR FT-IR and XPS. The result indicates that the products have very high ability to adsorb moisture, even better than cotton fiber. At the same time, the products show excellent hydrophobic property, which can‘t be wetted by those reagents whose surface tensions were higher than 327mN/m.     

Sorption of triethyleneglycol and tetraethyleneglycol by silicalite at fixed water activities

The sorption of tetraethyleneglycol by silicalite-1 and triethyleneglycol by silicalite-1 and a silicalite-1/silicalite-2 intergrowth has been studied at 25°C and at fixed water activities in the range 0.111<a _w<0.902 by an isopiestic method. All of the glycol uptakes are between 0.95 and 1.2 molecules per unit cell and in all cases they are essentially independent of water activity. The water content of the silicalite-1 was more sensitive to water activity and glycol content than was that of the silicalite-1/2 intergrowth.