凸域内弦的平均长度

本文研究了凸域内弦的平均长度.通过广义支持函数与凸域的弦幂积分,建立了凸域内弦的平均长度的一般公式,并用此公式得出了圆域和矩形域内弦的平均长度.     

Numerical solution of the linear inverse problem for the Euler-Darboux equation

An inverse problem of the reconstruction of the right-hand side of the Euler-Darboux equation is studied. This problem is equivalent to the Volterra integral equation of the third kind with the operator of multiplication by a smooth nonincreasing function. Numerical solution of this problem is constructed using an integral representation of the solution of the inverse problem, the regularization method, and the method of quadratures. The convergence and stability of the numerical method is proved.     

On the uniqueness of the foliation of spheres of constant mean curvature in asymptotically flat 3-manifolds

In this note we study constant mean curvature surfaces in asymptotically flat 3-manifolds. We prove that, outside a given compact subset in an asymptotically flat 3-manifold with positive mass, stable spheres of given constant mean curvature are unique. Therefore we are able to conclude that the foliation of stable spheres of constant mean curvature in an asymptotically flat 3-manifold with positive mass outside a given compact subset is unique.

     

用^60Co放射源检测油垢厚度的初步实验研究

本文用石蜡模拟油垢，用^60Co放射源的1．25MeV平均能量的γ射线垂直入射，以一定的散射角和不同的探测立体角接收散射γ光子敫．发现散射γ计数与被测石蜡厚度之间存在不同的线性关系．结果发现，放射源与探测器之间屏蔽的好坏和合理的探测距离对提高线性度有很大关系．本实验测得最佳线性相关系数平方值为0．9981，平均测量精度为1．26mm．这对研究散射法检测油垢厚度和选择合适的探测距离提供了实验基础．     

不同溶剂体系中改性氢氧化镁的分散行为

研究了不同的表面改性剂对超细氢氧化镁的表面改性.并分别以水和乙醇为溶剂,研究了表面改性后氢氧化镁的分散行为.实验结果表明,以水为溶剂的体系,六偏磷酸钠分散性能最好,而以乙醇为溶剂,硅烷偶联剂KH-550分散性能最好,其用量为基体量的5%左右,可使制备的超细氢氧化镁粒径达到0.2 μm尺度以下.试验结果对进一步认识超细氢氧化镁的性质及其应用具有重要意义.     

An unflexural refined model of deformation of multilayered plates on an undeformable foundation

The stress-strain state of multilayered plates on an undeformable foundation is investigated. The design diagram of a transversely loaded plate is formed by supplementing it with a symmetric one about the contact surface of the foundation. The double-thickness plate obtained becomes loaded bilaterally and symmetrically about its midsurface. In such a way, only unflexural deformations can be modeled, which reduces the number of unknowns and the general order of differentiation of the resolving system of equations. The refined continual model developed takes into account the deformations of transverse shear and transverse compression in high iterative approximations. The cases of a rigid contact between the foundation and the plate and frictionless slip of the plate over the foundation are considered. Calculations confirm the efficiency of such an approach, which allows one to obtain solutions qualitatively and quantitatively close to three-dimensional ones. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 42, No. 5, pp. 643–654, September–October, 2006.     

Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

<Emphasis Type="Italic">Comment on</Emphasis>¶Low temperature specific heat of blue bronze K <Emphasis Type="Bold">0.30</Emphasis>MoO <Emphasis Type="Bold">3</Emphasis>, by J. Odin,J.C. Lasjaunias,K. Biljaković, K. Hasselbach,and P. Monceau

Eur. Phys. J. B 24, 315 (2001) Here we comment on a recently published paper on the presence of a phason contribution in the low temperature heat capacity data of the charge-density-wave compounds K_0.3MoO₃ and (TaSe₄)₂I. We have shown that the anomaly in the C _P / T ³ data reported by Odin et al. is straightforwardly interpreted in terms of low energy phonon modes resulting from the peculiar topology of these compounds. Received 21 February 2002 Published online 19 July 2002     

具功能反应的三种群捕食者——食饵系统数学模型稳定性的研究

[1]中提出了具有功能反应的三种群捕食者——食饵系统的两种模型(Ⅰ)、(Ⅱ),并给出了局部渐近稳定的条件。本文研究了另外两种模型(Ⅲ)和(Ⅳ)的局部渐近稳定的条件。     

70 GHz二次谐波倍频回旋速调管研究

 对70 GHz二次谐波倍频回旋速调管高频结构和电子与波互作用进行了研究。研究了TE02模腔体绕射品质因数及模式转化，解决了二次谐波倍频回旋速调管漂移段不能截止70 GHz的TE01模而引起的腔体间高频串扰的问题。分析了注电流、输入功率、电子横纵速度比和电子注引导中心半径等参数对输出功率、增益和效率的影响。针对二次谐波回旋速调管放大器工作频带窄、效率低，进行了高频结构优化设计，显著地展宽了工作频带，提高了互作用效率。在理论分析和高频计算的基础上，建立了注-波互作用PIC（粒子模拟）模型，进行了粒子模拟计算和优化，得到了70 GHz 的二次谐波倍频四腔回旋速调管放大器设计方案。粒子模拟结果表明：在工作电压70 kV，注电流13 A，电子注横向速度与纵向速度比为1.5时，中心频率69.81 GHz输出功率256 kW，带宽160 MHz，电子效率28%，饱和增益大于44 dB。