MORPHOLOGIES AND GAS SEPARATION PROPERTIES OF MELT-SPUN ASYMMETRIC POLY(4-METHYL-1-PENTENE)HOLLOW FIBER MEMBRANES*

Poly(4-methyl-1-pentene) (PMP) hollow fiber membranes were prepared by the melt-spun and cold-stretch(MSCS) method. Scanning electronic microscopy (SEM) was used to characterize the section and surface structures of themembranes with special asymmetric structure. The preliminary results of gas permeation measurements indicated that the resultant hollow fiber membranes have the potential ability for oxygen/nitrogen separation.     

水中酚的膜萃取分离流动注射技术测定的研究

本文提出了硅橡胶膜在线萃取分离流动注射技术测定水样中苯酚的方法。由于水样中的苯酚透过硅橡胶进入萃取液的萃取量随时间的增加和温度的升高而增大，故采用停流技术及升高温度以降低酚的检出限。     

功能液晶膜的新进展

论述了功能液晶膜的新近研究结果和发展动向,指出功能液晶膜具有优异的气体分离、液体分离和电光性能,可望作为高效气体分离膜、高效液体分离膜和大面积光控膜,具有较重大的理论与实际意义。     

Mass transfer and benzene removal from air using latex rubber tubing and a hollow-fiber membrane module

A dense-phase latex rubber tube and a polyporous propylene hollow-fiber membrane module (HFMM) were investigated for control of benzene-contaminated gas streams. The abiotic mass flux observed through the latex tube was 3.9–13 mg/(min·m²) for 150 ppm of benzene at various gas and liquid flow rates, while a 100-fold lower mass flux was observed in the HFMM. After seeding with an aromatic-degrading culture enriched from activated sludge, the observed removal was 80% of 150 ppm, corresponding toa mass flux of 45 mg/(min·m²). The observed mass flux through the HFMM during biofiltration also rose, to 0.4 mg/(min·m²). Because the HFMM had a 50-fold higher surface area than the latex tube, the observed ben zene removal was 99.8%. Compared to conventional biofilters, the two reactors had modest elimination capacities, 2.5–18 g/(m³·h) in the latex tube membrane bioreactor and 4.8–58 g/(m³·h) in the HFMM. Although the HFMM had a higher elimination capacity, the gas-phase pressure drop was much greater.     

羟自由基对支撑磷脂双层膜的破坏及水溶性抗氧化剂保护作用的电化学研究

以支撑磷脂双层膜(supported bilayer lipid membrane, s-BLM)作为生物膜模型, 利用Fenton体系产生羟自由基(hydroxyl free radical, •OH), 采用循环伏安法研究了s-BLM与•OH之间的相互作用. 结果表明: •OH通过与磷脂发生化学反应, 诱发s-BLM上形成孔洞或缺陷, 这种作用对时间、FeSO₄和H₂O₂的浓度具有依赖性, 且不可恢复. 具有还原性基团的抗氧化剂维生素C, 还原型谷胱甘肽和L-半胱氨酸, 通过与•OH发生氧化还原反应, 可抑制•OH与s-BLM的相互作用, 降低•OH对s-BLM结构的破坏程度.     

Novel Membrane Potentiometric Thiocyanate Sensor Based on Tribenzyltin(IV) Dithiocarbamate

A novel PVC membrane ion‐selective electrode based on tribenzyltin(IV) dithiocarbamate [Sn(IV)–TBDTB] as neutral carrier was developed for thiocyanate (SCN^?) determination. The electrode exhibits a near‐Nernstian response for SCN^? with a slope of 62.8±2.0 mV per decade over a wide concentration range 1.0×10^?1–2.0×10^?6 mol L^?1 and a detection limit of 1.0×10^?6 mol L^?1 in MES–NaOH buffer, pH 6.0, at 25 °C. The electrode prepared with 1.5 wt.% Sn(IV)–TBDTB, 32.5 wt.% PVC and 66.0 wt.% 2‐nitrophenyloctyl ether (o‐NPOE) shows optimal response characteristics. Anti‐Hofmeister selectivity sequence for a series of anions shown by the electrode was as follows: SCN^?>Sal^?>I^?>ClO >phCOO^?>CH₃COO^?>Br^?>Cl^?>NO >NO >Citrate>SO₄^2?. The useful pH range for the electrode was found to be 3–7 with a response time 30–40 s. The electrode has been used for direct determination of thiocyanate in wastewater with satisfactory results.     

PSF/TiO2杂化超滤膜形成过程的热力学和动力学研究

采用溶胶-凝胶法制备了不同纳米TiO₂含量的聚砜(PSF)/TiO₂杂化超滤膜, 研究了TiO₂浓度对聚砜铸膜液流变学及热力学性质的影响, 构建了计算成膜过程中表观扩散系数(D_a)的新方法, 求出不同TiO₂浓度及温度下的D_a值, 进而剖析了铸膜液流变学和热力学性质的变化对成膜动力学的影响. 并通过扫描电镜观察、杂化膜孔隙率和超滤性能的测试考察了表观扩散系数与膜结构和性能的关系. 结果表明, 加入TiO₂溶胶的PSF铸膜液由牛顿流体转变为非牛顿流体, 其粘度随TiO₂浓度增大而增大. TiO₂的加入减小了铸膜液对非溶剂的容纳能力, 加速铸膜液的液-液相分离, 同时TiO₂引起的热力学促进作用和流变学阻碍作用相互竞争, 共同影响D_a的变化. 实验得出, D_a随温度升高而增大, 随TiO₂浓度的增大有先增大后减小的趋势. 表观扩散系数D_a与膜的结构和性能具有很好的相关性并能直观地描述整个成膜过程.     

高硅ZSM—5沸石填充硅橡胶膜的醇—水渗透蒸发分离性质

高硅ZSM－5沸石填充疏水性硅橡胶蓦地低浓度醇－水体度醇－水体的渗透蒸发性质的研究有明，提高沸石硅铝比，增加填充量以及进行酸处理皆有利于改善膜对醇－水的分离系数和通量。料液的成，浓度以及温度对膜的分离性质也有显著影响。     

Integrated Microanalytical System Coupling Permeation Liquid Membrane and Voltammetry for Trace Metal Speciation. Technical Description and Optimization

A new minicell coupling the liquid‐liquid extraction technique called permeation liquid membrane (PLM) with an integrated Ir‐based Hg‐plated microelectrode array for voltammetric detection has been developed for the speciation of heavy metals in natural waters. Lead and cadmium have been used as model compounds. The PLM consists of a carrier (0.1 M 22DD+0.1 M lauric acid) dissolved in 1 : 1 mixture of toluene/phenylhexane held in the small pores (30 nm) of a hydrophobic polypropylene membrane (Celgard 2500). One side of this membrane is in contact with a flowing source solution, containing the metal ions of interest. An acceptor or strip solution (pyrophosphate) is placed on the other side of the PLM with the microelectrode array placed at 480 μm of the PLM. The analyte is transported by the carrier from the source solution to the strip solution. The originality of the new minicell is that accumulation in the strip solution is voltammetrically followed by the integrated microelectrode array in real time, and at low concentration level, using square‐wave anodic stripping voltammetry (SWASV). In order to protect the Hg microelectrodes from the adsorption of the hydrophobic carrier, the microelectrodes are embedded in a thin gel layer (280 μm) of 1.5% LGL agarose gel containing 10% of hydrophobic silica particles C18. The choice of optimum conditions is discussed in details in this article. Due to the very small effective strip volume of the new cell (less than 1 μL), high enrichment factor can be obtained (e.g., 330 for Pb) after 2 hours of accumulation. No deaeration of the solutions is required for SWASV measurements. Detection limits under these conditions are 2 pM and 75 pM for Pb and Cd, respectively, using a voltammetric deposition time of 5 min. In addition, no fouling effects were observed with natural water samples.     

肝素化壳聚糖季铵盐／壳聚糖复合膜抗凝血性能的研究

以壳聚糖季铵盐，壳聚糖为基本原材料，选用戊二醛为交剂剂及固定剂，制备一种物理机械性能较优的抗凝血材料。探讨了戊二醛及肝素钠两者用量对肝素化程度及血液生的影响。