Diffusion Mechanisms of Zeolite Catalysts

The diffusion mechanisms within zeolite catalysts, such as resistance to diffusion at pore mouths, configurational diffusion, adsorption-controlled diffusion, influence of co-existing molecules and pore blocking, were overviewed. Two kinds of diffusivities, the intracrystalline diffusivity and the effective diffusivity, were discussed separately to clarify the diffusion mechanism.     

Effective crystal field for trivalent first transition row ions

In the present work the semiempirical effective crystal field (ECF) method previously designed for electronic structure calculations of transition metal complexes and utilizing non‐Hartree–Fock trial wave function and parameterized for complexes of doubly charged Cr²⁺, V²⁺, Mn²⁺, Fe²⁺, Co²⁺, and Ni²⁺ cations is extended to complexes of triply charged cations of 3d‐elements. With the parameters adjusted the ECF method is applied to calculations of ground states and low‐energy spectra of the d‐shells of fluoro‐, chloro‐, aqua‐, amino‐, and cyano‐complexes of the triply charged cations. Obtained total spin and symmetry of the ground states match the experimentally observed ones. Satisfactory agreement between the calculated and experimental d‐shell electronic transition energies is achieved as well. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem, 2002     

La0.7-xDyxSr0.3MnO3(0.00≤x≤0.70)的TCR研究

研究了La位Dy掺杂对La0.7-xDyxSr0.3MnO3(0.00≤x≤0.70)电阻温度系数(TCR)的影响.实验结果表明:Dy掺杂将引起电阻率曲线的急剧变化,导致出现大的TCR;随Dy掺杂的增加,TCR在x=0.30出现峰值,然后随掺杂量的增加逐步降低.体系出现大的TCR,来源于Dy掺杂引起的晶格畸变和额外磁性耦合.     

Cu-P系稀土耐候钢中最佳稀土含量的研究

利用光学显微镜、图像分析仪和电子探针对低氧低硫的10PCuRE耐候钢板坯进行了观察和检测,采用干-湿周浸室内加速试验方法测得了试验钢的腐蚀率.用电化学方法测得了带锈样的阳极极化曲线.研究得出对于S:～0.004%,O:～0.002%的10PCuRE耐候钢,最佳稀土含量为0.0065%～0.012%,此稀土含量对非金属夹杂物的变质作用和耐蚀性能的提高最为有利.     

Resistance of supersulfated cement to strong sulfate solutions

One of the principal uses of supersulfated cement has been for structures exposed to sea water and sulfate bearing ground waters. The resistance to such environments has been related to the absence of calcium hydroxide and the combination of much of the free alumina into ettringite during hydration. This paper reports the resistance of SSC to sulfate solutions in which ettringite has been decomposed. Prism samples were subjected to initial water storage at 25°C for both 28 days and 6 months. Samples were also cured for 6 months at 95°C and at both 11% and 100% R.H. The control samples of 28 days were compared with the 6 months samples of a more mature undecomposed SSC paste. After curing the prisms were measured and all the samples were immersed in three sulfate solutions (0.7M Na₂SO₄ , 0.7M MgSO₄ and saturated CaSO₄), and water at the same time. Measurements of linear expansion over 6 months were carried out. Core and surface material following immersion was examined by DTG and XRD. The study indicated that SSC is resistant to sodium and calcium sulfate solutions. Strong magnesium sulfate solutions decomposed the samples under all conditions. A possible mechanism for this attack is suggested. This revised version was published online in July 2006 with corrections to the Cover Date.     

STUDY ON 1-HEXENE POLYMERIZATION BASED ON ZIEGLER-NATTA CATALYSTS WITH DOPED SUPPORT

A series of Ti/Mg supported catalysts are prepared by using ball-milled mixtures of MgCl2-ethanol adducts and NaCl as supports, and 1-hexene polymerizations catalyzed by the novel catalysts are studied. It is found that the molecular weight distribution of poly(1-hexene) becomes apparently narrower when catalysts with doped supports are used, indicating that changing the structure of the support is an effective way to regulate the active center distribution of heterogeneous Ziegler-Natta catalyst.     

紫外分光光度法测定高山红景天根及其浸膏的有效成分

使用紫外分光光度法测定了高山红景天根不同部位及其浸膏中主要有效成分的含量.红景天甙、酪醇对照品溶液和供试品溶液在276nm处具有最大吸收峰,红景天甙对照品溶液的线性回归方程为A=0.00529c+0.00189,r=0.99997(n=8),线性范围为7.97～71.71mg/L,平均回收率为98.08%,RSD为2.60%(n=5).测得高山红景天原药材内层部分、外皮层部分和总体混合物部分主要有效成分(红景天甙和酪醇)的含量(以红景天甙计)分别为2.789%,2.385%和2.617%,其浸膏中主要有效成分的质量分数分别为6.384%,13.80%和6.700%.并用HPLC法验证了该法的准确性,结果表明,该法可用于红景天属植物原药材及其浸膏中主要有效成分的定量分析.     

Influence of Some Aggressive Media on Corrosion Resistance of Mortars With Spent Cracking Catalyst

The influence of spent catalyst from catalytic cracking in fluidized bed on the hydration process of cement and the properties of cement mortars were studied. The spent catalyst was used as an additive to cement in the mortars (10 and 20% of cement). The samples of mortars kept in water for28 days, then they were placed in sulfate and chloride media for 2 months (the control samples were kept in water for 3 months). After this time they were subjected to bending strength and compressive strength determinations. Thermogravimetric and infrared absorption studies were performed and capillary elevation, capability of binding heavy metals, and changes in mass and apparent density were determined too. The studies disclosed the pozzolana nature of spent catalyst and its influence on cement mortars being in contact with corrosive media. This revised version was published online in August 2006 with corrections to the Cover Date.     

主动冷却点阵夹层防热结构温度响应计算模型北大核心CSCD

针对点阵夹层结构主动热防护问题,建立了夹层结构面板和芯体导热与冷却剂对流耦合的非稳态传热理论模型,利用有限体积法离散控制方程并在MATLAB中进行了迭代求解.模型首次考虑了面板与夹芯杆之间的收缩热阻,并利用分离变量法得到了收缩热阻的近似解析解.基于单胞模型和周期性边界条件,模拟得到了模型所需的表面对流传热系数h_(b)和h_(fin).最后,选取多单胞计算工况进行数值模拟和理论模型对比,并讨论了收缩热阻对模型预测精度的影响.结果表明:理论模型能够准确预测夹层结构及内部流体的温度变化,理论与仿真之间的最大误差不超过1%;随着外加热流密度不断增大,忽略收缩热阻使得计算结果造成的误差不断增大;与数值模拟相比,理论模型可显著地减少计算时间并节省计算资源,尤其适用于非均匀、非稳态复杂热载荷下点阵夹层结构的温度响应计算.     

Normalized Dynamic Characterization and Application of Multiple Heat Storage Materials Based on Standard Thermal Resistance北大核心CSCD

基于标准热阻和能量流法,推导出储热材料与换热流体的瞬态换热热阻,通过类比电路分析法,获得了储热-换热过程的瞬态热量流模型及动态响应时间常数。进一步引入节点温度,重新定义换热热阻,获得了储热与换热过程耦合的三阶电路瞬态热量流模型,求解得到了加热、储热和释热三类时间常数,可用于协同表征储热材料中储热与释热的快慢程度,从而实现了多类储热材料的归一化动态表征。通过数值模拟验证与应用对比分析,发现基于多时间常数的归一化动态模型用于表征储热材料的动态特性是可行的,可直接对不同换热、储热材料进行对比分析。案例分析发现与固体储热材料换热时,液态金属的动态换热能力优于熔融盐,而相比于水蒸气和CO₂,空气与陶瓷材料换热能更快达到稳态。