Electron microprobe analysis of micro amount powder samples: A case study on high purity coal

For the major, minor and trace element analysis of the inorganic compounds of a Ruhr-Saar coal different preparation techniques are investigated with X-ray fluorescence analysis, electron microprobe and classical wet chemical methods minimizing sample weight at standard preparation times and analytical accuracies. Considering accuracy as well as preparation efforts, determinations by electron microprobe on small sample amounts (<50 mg) proved to be superior to the other methods.Abbreviations AAS atomic absorbtion spectrometry - EMA electron microprobe analysis - IC ion chromatography - ISE ion sensitive electrode - PHOT photometry - WCA wet chemical analysis - XRF X-ray fluorescence analysis - LTA low temperature plasma ashing - HTA high temperature ashing - l.o.i. loss on ignition     

SYNTHESIS OF SODALITE BY DRY POWDER METHOD

用新颖的干粉方法合成系列沸石的研究已从五元环沸石延伸到具有四元环和六元环的方钠石。本研究运用干粉方法在Ｎａ２Ｏ－ＳｉＯ２－Ａｌ２Ｏ３混合物中分别以乙醇胺和乙二胺－氟化物为模板，合成出了方钠石。有机模板剂以吸附态模板方式进入体系。用ＸＲＤ数据、扫描电镜图及红外光谱测试结果对实验产品做了表征。结果表明，干粉体系制备的方钠石的晶胞参数小于水热体系和非水体系合成的方钠石的相应值。而以乙醇胺为模板制备的方钠石与以乙二胺－氟化物为模板的样品比较，后者具有较快的晶化速度、较小的晶胞体积和晶粒     

Thermal and mechanical-induced phase transformations during YAG and alumina–YAG syntheses

The preparation of pure Y₃Al₅O₁₂ (YAG) and 50 vol% Al₂O₃–YAG composite powders by a wet chemical route is presented. The role of the synthesis temperature during reverse-strike precipitation has been investigated, showing its relevant effect on the purity and homogeneity of YAG powder. The composite material was prepared by comparing two different synthesis routes. A composite powder was synthesized via reverse-strike temperature-controlled co-precipitation. In the latter case, a pure-alumina precursor was firstly reverse-strike precipitated and then doped with an yttrium salt solution. For both syntheses, the role of thermal and mechanical pre-treatments on the phase development was demonstrated.     

空气 - 乙炔火焰原子吸收法连续测定铜粉中微量Fe、Pb、Sb、Zn和Ni

用HNO3-HCl溶解试样,在几个相同量的试液中,分别加入质量浓度依次递增的5种元素的标准溶液,用火焰原子吸收法连续测定了Fe、Pb、Sb、Zn和Ni的含量,建立了优化的仪器测定条件,并对可能存在的元素进行了干扰试验。结果表明,Fe、Pb、Sb等5种元素的回收率为98.0%～102.3%,相对标准偏差为1.4%～2.5%。     

超细粉Pb0.75Ca0.25[(Ni1/3Nb2/3)0.08Ti0.912Mn0.008]O3的制备与表征

报道了用化学共沉淀法制备掺杂Ca、Ni、Nb、Mn钛酸铅超细陶瓷粉末的方法。制得的粉料化学式为:Pb_0.75Ca_0.25[(Ni_1/3Nb_2/3)_0.08Ti_0.912Mn_0.008]O₃,粒径小于0.1μm,所有的掺杂元素均能定量掺入。     

负载茜素红S的纳米磁性碳粉修饰电极测定牛白蛋白

采用化学沉积法在纳米碳粉上合成磁性Fe3O4颗粒,纳米碳粉吸附茜素红S后通过磁力附着在石墨电极上,制成了负载茜素红S的纳米磁性碳粉修饰电极。研究了该电极在0.014 mol/L H2SO4-0.2 mol/L KC l溶液中对ARS-牛白蛋白的电还原作用,考察了多种实验条件对峰电流的影响。在-0.45 V电位下,牛白蛋白浓度在1.5×10-8~9×10-7mol/L范围内与线性扫描伏安法还原电流成反比,从而实现对牛白蛋白的测定,并初步研究了电化学反应机理。此方法制成的磁性纳米颗粒修饰电极集分离、富集、测定和更新于一体,具有更新方便的特点。     

化学发光分析法测定动物蛋白粉等样品中的锰

基于Mn(Ⅱ) 邻菲罗啉对鲁米诺 KIO4化学发光体系的催化作用建立了测定Mn(Ⅱ)的分析方法。Mn(Ⅱ)质量浓度在2.0×10-6～5.0×10-5mg/mL范围与发光强度呈线性响应,回归方程为ICL=0.6+1.39×106ρ(mg/mL),检出限为2.0×10-6mg/mL。Cr3+、Fe2+、Co2+、Au3+等离子有干扰,使用EDTA、F-、8 羟基喹啉等为掩蔽剂可消除或降低干扰。将该法应用于生物化工产品丙酸钙、动物蛋白粉等中痕量锰的测定,加标回收率98%～102%,10次测定RSD为4 6%。将测定的结果与原子吸收法比较,相对偏差≤±3%。     

溶剂萃取法制备Co(PO_3)_2超细微粉

本文用溶剂萃取法成功地制备了偏磷酸钴超细微粉并通过ＸＲＤ，ＩＲ，ＴＧ，ＤＴＡ，ＴＥＭ等实验对超细微粉的组成、结构进行了表征。     

用N2O-C2H2火焰原子吸收光谱法测定羰基镍粉中钼含量

运用了N2O—C2H2火焰原子吸收光谱法进行羰基镍粉钼含量的测定。介绍了钼最佳测定条件及呈良好线性范围的浓度,同时对样品消化处理条件及在测定中样品的干扰因素进行了综合考虑．该方法的相对标准偏差均小于1.0％(n=6)，回收率均在97．0％～102．0％(n=6)之间．达到了实验室分析质量控制的要求．     

High-productivity continuous biofilm reactor for butanol production

Corn steep liquor (CSL), a byproduct of the corn wet-milling process, was used in an immobilized cell continuous biofilm reactor to replace the expensive P2 medium ingredients. The use of CSL resulted in the production of 6.29 g/L of total acetone-butanol-ethanol (ABE) as compared with 6.86 g/L in a control experiment. These studies were performed at a dilution rate of 0.32 h⁻¹. The productivities in the control and CSL experiment were 2.19 and 2.01 g/(L·h), respectively. Although the use of CSL resulted in a 10% decrease in productivity, it is viewed that its application would be economical compared to P2 medium. Hence, CSL may be used to replace the P2 medium. It was also demonstrated that inclusion of butyrate into the feed was beneficial to the butanol fermentation. A control experiment produced 4.77 g/L of total ABE, and the experiment with supplemented sodium butyrate produced 5.70 g/L of total ABE. The butanol concentration increased from 3.14 to 4.04 g/L. Inclusion of acetate in the feed medium of the immobilized cell biofilm reactor was not found to be beneficial for the ABE fermentation, as reported for the batch ABE fermentation. Names are necessary to report factually on available data. However, the USDA neither guarantees nor warrants the standard of the product, and the use of the names by USDA implies no approval of the product to the exclusion of others that may also be suitable.