MORPHOLOGY OF BLACK CARBON AEROSOLS AND UBIQUITY OF 50-NANOMETER BLACK CARBON AEROSOLS IN THE ATMOSPHERE

Different-sized aerosols were collected by an Andersen air sampler to observe the detailed morphology of the black carbon （BC） aerosols which were separated chemically from the other accompanying aerosols, using a Scanning Electron Microscope equipped with an Energy Dispersive X-ray Spectrometer （SEM-EDX）. The results indicate that most BC aerosols are spherical particles of about 50 nm in diameter and with a homogeneous surface. Results also show that these particles aggregate with other aerosols or with themselves to form larger agglomerates in the micrometer range. The shape of these 50-nm BC spherical particles was found to be very similar to that of BC particles released from petroleum-powered vehicular internal combustion engines. These spherical BC particles were shown to be different from the previously reported fullerenes found using Matrix-Assisted Laser Desorption/Ionization Time-Of-Flight Mass Spectrometry （MALDI-TOF-MS）.     

石墨和纳米碳中缺陷和电子密度随温度的变化

测量了石墨和纳米碳在不同温度下的正电子寿命谱,研究了石墨和纳米碳中缺陷和电子密度随温度的变化.结果表明,纳米碳中缺陷的开空间和缺陷浓度分别大于和高于石墨晶体;纳米碳的平均自由电子密度低于石墨晶体.当温度从25K升至295K时,石墨和纳米碳中的平均自由电子密度随温度的升高而下降:石墨晶体中的自由电子密度随温度的升高变化较小;纳米碳的自由电子密度随温度的升高变化较大.随着温度的升高,石墨和纳米碳中的热空位数量增多,而且这些空位可迁移至微孔洞的内表面使微孔洞的开空间增大.     

Reintroduced solids increase inhibitor levels in a pretreated corn stover hydrolysate

Following detoxification of the liquid hydrolysate produced in a corn stover pretreatment process, inhibitor levels are seen to increase with the re-addition of solids for the ensuing hydrolysis and fermentation processes. The solids that were separated from the slurry before detoxification of the liquor contain approx 60% (w/w) moisture, and contamination occurs owing to the diffusion of inhibitors from the moisture entrained in the porous structure of the corn stover solids into the bulk fluid. This evidence suggests the need for additional separation and detoxification steps to purge residual inhibitors entrained in the moisture in the solids. An overliming process to remove furans from the hydrolysate failed to reduce total organic acids concentration, so acids were removed by treatment with an activated carbon powder. Smaller carbon doses proved more efficient in removing organic acids in terms of grams of acid removed per gram of carbon powder. Sugar adsorption by the activated carbon powder was minimal.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Covalent functionalization of multi-walled carbon nanotubes by lipase

Lipase from Candida rugosa was covalently anchored onto acid-treated multi-walled carbon nanotubes (MWNTs) through a self-catalytic mechanism. A variety of characterization techniques including FTIR, Raman spectroscopy, and XPS were employed to demonstrate the formation of the ester linkage between lipase and MWNTs. The MWNTs-lipase biocomposites showed significantly increased solubility in some common-used organic solvents, such as THF, DMF and chloroform. This study may offer a novel and facile route for covalent modification of carbon nanotubes, and expand the potential utilization of both lipases and MWNTs in the fields of biocatalyst and biosensor.     

一个非协调膜元的高精度分析

本文讨论一个四自由度三角形非协调膜元的整体超收敛性，外推和亏量校正。     

脉冲磁场处理对碳纳米管掺杂MgB2线材临界电流密度的影响

对碳纳米管(CNT)掺杂MgB₂超导体磁场处理后的行为进行了研究. 结果表明，CNT掺杂MgB₂超导体经5T脉冲磁场处理后临界电流密度J_c(H)在低磁场下提高了2—3倍，高场下提高一个数量级以上，扫描电镜结果显示CNT沿着处理磁场方向规则排列并且成为MgB₂基体的形核中心和高效的磁通钉扎中心. 关键词： 2')" href="#">MgB₂ 碳纳米管 脉冲磁场处理     

含有五边形—七边形缺陷的单壁纳米碳管的输运性质研究

运用第一性原理的密度泛函理论结合非平衡格林函数研究了含有五边形—七边形拓扑缺陷的纳米碳管异质结的输运性质.结果发现：拓扑缺陷对碳管的输运性质有很大影响；另外，不同类型的碳管形成的异质结的输运性质也有明显的差异. 关键词： 纳米碳管 输运性质 异质结 透射系数     

有限长扶手椅形单壁碳纳米管分子静电势的理论研究

在混合密度泛函B3LYP理论下,用3-21G基函数对有限长扶手椅形单壁碳纳米管(4,4)、(5,5)和(6,6)的构型进行优化和分子静电势计算.结果表明:除近核区域为正常的正电势外,碳纳米管结构模型的管内和管外为负电势区域;在碳纳米管结构模型的管内,管心处均出现负电势的最小值,且负电势的绝对值随着碳纳米管的曲率降低而增大,管心轴线上静电势的变化随碳纳米管的曲率降低而减少,带电粒子流比较容易通过纳米管.