快中子照相中的点扩展函数计算

 快中子照相中，基于反冲核原理探测快中子的有机闪烁体平板是普遍采用的快中子辐射转换体。模拟了D-T中子垂直入射BC400闪烁体平板，计算了不同厚度平板闪烁体的点扩展函数，对14.1 MeV快中子照相中闪烁体固有分辨率随厚度的变化进行了研究。计算结果表明，在不考虑二次中子与闪烁体作用及背景噪声等情况时，点扩展函数几乎不依赖于闪烁体厚度。同时，计算还表明在一定的分辨率范围内，由于荧光收集效率的限制，闪烁体厚度增加并不会改善图像对比度。     

用于同步辐射光源的成像板粉末衍射系统

报道了我们研制的一套成像板粉末衍射装置,对其误差来源进行了详细的分析讨论,并与衍射仪进行了比较.该装置的半径为143.3mm,最大测量角度范围不160°，最大角度(2q )偏差小于0.03°,这些性能指标已被实验所证实,完全可应用于粉末衍射全谱的测量.     

矩形片筏基础的挠度分析

工程上对片筏的力学分析，通常采用温克勒地基模型，且假定床基系数是常量。本则认为床基系数是坐标的函数，考虑了具有线性变化床基系数的地基上的片筏，利用伽辽金法求得周边固支片筏在均布荷载作用下的挠度。所得结果颇具一般性且实用价值更高。     

Broadband spectral shaping in a Ti:sapphire regenerative amplifier

A birefringent crystal quartz plate of known thickness has been used as a spectral filter for spectral shaping in a Ti:sapphire regenerative amplifier. The spectral profile of the amplified pulse ejected from the regenerative amplifier was observed while adjusting the birefringent crystal plate in the cavity. By altering the gain spectrum, the bandwidth of the regeneratively amplified pulse was increased from 18 to 35 nm by using a 0.34-mm thick birefringent plate. The output pulse spectrum from the regenerative amplifier neared the bandwidth of the seed pulse. As a comparison, we used a coated filter outside the regenerative amplifier cavity, and the bandwidth of the regeneratively amplified pulse was stretched to 28 nm. When the bandwidth was stretched to 35 nm, the pulse was compressed to 35 fs.     

Bending loss measurement using a fiber cavity ringdown scheme

A novel sensitive technique for the determination of losses in fiber cavities is presented. The method is based on the cavity ringdown scheme implemented in silica-based single-mode fibers. Bending losses of fiber cavities of different lengths have been measured showing all an oscillating behavior with respect to the curvature radius of the fiber as predicted by a theoretical model. The best minimum detectable absorbance per cavity pass achieved by this new method is 1.72×10⁻³ dB within a 10 m-long cavity. This limit suffices well for an accurate determination of optical bending losses even in bend-insensitive fibers. Furthermore, the comparison of the measured bending losses with a theoretical model allows the extraction of different fiber parameters. Good agreement has been found between the experimentally derived parameters and literature data.     

低速二维流动的粒子仿真研究

本文运用信息保存法对低速二维的流动现象进行模拟，考察了低速条件下的有限平板绕流以及微槽道气体流动问题。研究表明：在对低速流动的模拟过程中，运用IP法在能够获得较好的结果的同时，具有比DSMC方法更高的计算效率。     

Security Applications of Optical Face Recognition System: Access Control in E-Learning

The educational system has gradually shifted from a face-to-face to an e-learning system, which has become prevalent in advanced countries with the advance of information technology, and connection of global networks. Accordingly, a growing demand is emerging for more reliable individual certification with technical precision in order to measure and record learning achievements and credentials of participants. The present system has a limit in terms of registration capacity, therefore, its accuracy has often been questioned. Against this background, an individual certification system is proposed particularly for access control in e-learning. Under our proposed system, a compact optical correlator for facial recognition is employed. This correlator was previously tested for of biometrics authentication accuracy and proved highly reliable, having recorded remarkably low error rates (below 1%). The recorded error rate is sufficiently robust that the system itself can be regarded as a valid and practical viable attestation system.     

关于均值KIRCHHOFF板非线性边界镇定问题的几点注记

对于均值K IRCHHOFF板非线性边界镇定问题给出几点注记.首先应用G reen公式对具有非线性边界反馈控制的均值K IRCHHOFF板所决定的非线性系统的能量衰减速度进行了重新推导,从而修正了前人的结果.然后应用极大单调函数的定义和分部积分技巧,对均值K IRCHHOFF板非线性边界镇定问题所决定的非线性算子A的极大单调性给出了重新证明,进而更正了已有文献中相应证明的欠妥之处.     

圆柱型正交各向异性圆形薄板的非线性非对称弯曲问题（Ⅱ）

本文利用“正则摄动法”［２］研究文献［１］中由“两变量法”［３］所得到的关于Ｗｎｍ，和的递推方程和递推边界条件的求解问题。求得了本问题的一致有效渐近解，最后作为实例，我们利用“混合摄动法”［４］研究了轴对称线性弯曲问题，并将所得结果与文献［５］中给出的精确解相比较，两者基本上是一致的。     

双折射双频激光器偏振特性的分析

用激光原理和晶体光学原理分析了腔内加旋光晶体的激光器输出光的偏振特性，实验和分析表明，激光器输出两束不同频率的垂直线偏振光，激光器两端输出光的偏振面有一夹角ａ，且此夹角与晶轴和传光方向的夹角θ有关。理论计算结果在双折射双频激光器的实验结果符合很好。