小长径比垂直管气液两相流动特性分析

实验观察了小长径比垂直上流管内流型及特点,并对管入口处的压力波动特性和系统的压差波动特性进行了试验研究.结果表明:小长径比(L/D)垂直管内流型表现为泡状流、塞状流、乳沫状流、环状流和液束环状流;分别增加管线中的气量、液量,或者同时增加气液流量,均会造成垂直管入口处压力波动的均值和最大压力的增加;压力信号的概率密度(PDF)大部分呈双峰分布,也存在单峰和多峰分布;差压信号的概率密度符合正态分布,其功率谱密度同压力信号相比具有频率波动范围宽、幅值小的特点.     

离化团簇束法制备c轴取向的ZnO薄膜

为了探索低温可调控ZnO薄膜沉积技术,提出了一种新的ZnO薄膜制备方法,即离化团簇束（ICB）法,并自行设计研制了应用该方法制备ZnO薄膜的专门装置.采用超音速喷嘴获得高速锌原子团簇束,用Hall等离子体源产生氧离子束离化锌原子团簇,获得了较高的离化率.在沉积过程中,可以通过调节衬底偏压、氩氧比、衬底加热温度等参数,来控制成膜的质量;应用这个装置成功地在硅衬底上制备的ZnO薄膜,经XRD和EDS检测,薄膜的c轴取向一致,Zn、O原子百分比接近于1：1,成膜质量好.     

57Fe Mössbauer spectroscopic study of (25−x)MnO–xZnO–15Fe2O3–60B2O3 glasses

The ⁵⁷Fe Mössbauer technique has been used to investigate the effect of zinc oxide substitution in (25???x)MnO–xZnO–15Fe₂O₃–60B₂O₃ glass system (x?=?0, 5, 10, 15 and 20 mol% of ZnO ). Mössbauer absorption spectra for all the samples recorded at room temperature suggest the existence of the two paramagnetic quadrupole doublets. The observed variations in hyperfine parameters have been explained on the basis of cations distribution and exchange interaction at the lattice sites and it is concluded that B–B interaction increases while the metal–metal interaction decreases due to replacement of manganese oxide by zinc oxide. These results suggest that the present glass system exhibits a paramagnetic behaviour that changes towards the weak paramagnetic when manganese oxide was replaced with zinc oxide.     

基于单片机控制的实验线路故障诊断系统

介绍了基于单片机控制技术的强电实验线路故障自动诊断系统的结构及功能,阐述了系统硬件设计、软件设计的基本原理．     

Numerical simulation and experimental validation of heat transfer within rotating flows for three‐dimensional non‐axisymmetric,turbulent conditions

A control volume type numerical methodology for the analysis of steady three‐dimensional rotating flows with heat transfer, in both laminar and turbulent conditions, is implemented and experimentally tested. Non‐axisymmetric momentum and heat transfer phenomena are allowed for. Turbulent transport is alternatively represented through three existing versions of the k–ε model that were adjusted to take into account the turbulence anisotropy promoted by rotation, streamline curvature and thermal buoyancy. Their relative performance is evaluated by comparison of calculated local and global heat balances with those obtained through measurements in a laboratory device. A modified version of the Lam and Bremhorst, low Reynolds number model is seen to give the best results. A preliminary analysis focused on the flow structure and the transfer of heat is reported. Copyright © 2002 John Wiley & Sons, Ltd.     

光刻机硅片表面不平度原位检测技术

随着光刻特征尺寸的不断减小,硅片表面不平度对光刻性能的影响越来越显著.该文提出了一种新的硅片表面不平度的原位检测技术本文在分析特殊测试标记成像规律的基础上,讨论了测试标记的对准位置偏移量与硅片表面起伏高度的变化规律,提出了一种新的硅片表面不平度原位检测技术.实验表明,该技术可实现硅片表面不平度及硅片表面形貌的高准确度原位测量.该技术考虑了光刻机承片台吸附力的非均匀性对硅片表面不平度的影响,更真实反映曝光工作状态下的硅片表面不平度大小.与现有的原位检测方法相比,硅片表面不平度的测量空间分辨率提高了1.67%倍,可实现硅片表面形貌的原位检测.     

Simultaneous Measurement of Particle Size and Particle Velocity by the Spatial Filtering Technique

The objective of this study was to compare the measuring results of a fiber‐optical probe based on a modified spatial filtering technique with given size distributions of different test powders and also with particle velocity values of laser Doppler measurements. Fiber‐optical spatial filtering velocimetry was modified by fiber‐optical spot scanning in order to determine simultaneously the size and the velocity of particles. The fiber‐optical probe system can be used as an in‐line measuring device for sizing of particles in different technical applications. Spherical test particles were narrow‐sized glass beads in the range 30–100 μm and irregularly shaped test particles were limestone particles in the range 10–600 μm. Particles were dispersed by a brush disperser and the measurements were carried out at a fixed position in a free particle‐laden air stream. Owing to the measurement of chord lengths and to the influence of diffraction and divergent angle, the probe results show differences from the given test particle sizes. Owing to the particle‐probe collisions, the mean velocity determined by the probe is smaller than the laser Doppler mean velocity.     

Flow in a waterfall with large Froude number

An approximate method is developed to solve the full nonlinear equations governing two-dimensional irrotational flow in a free waterfall, falling under the influence of gravity, at high Froude number based on conditions far upstream. Schwarz—Christoffel transformation is used to map the region, in the complex potential-plane, onto the upper half-plane. The Hilbert transformation as well as the perturbation technique, for large Froude number, are used as a basis for the approximate solution of the problem. A complete solution, up to second-order approximation, for the downstream free-surfaces profiles, for different Froude number, is discussed and illustrated. The obtained approximate solutions are compared with those of other authors. Favourable agreement with other results suggests that this method is effective in dealing with flow problems strongly influenced by gravity and high Froude number. The results obtained by this method are sufficiently accurate for practical purposes.