Au/CeO2/Y和Au-MFe2O4催化剂用于有氧条件下CH4还原NOx的研究

以CeO2／Y分子筛和MFe2O4(M=Ni,Co，Zn)为载体，制备Au／CeO2／Y和Au-MFe2O4负载型金催化剂．用CH4做还原剂，考察了它们在有氧条件下催化还原NOχ的活性．结果表明：在Au-Y中引人助剂Ce，使得Au／CeO2／Y的催化活性高于Au／Y；Au-CoFe2O4的催化活性高于Au-Fe2O3，反应温度为300℃时，NOχ在Au-CoFe2O4上的转化率达到39．70%．     

LLDPE/纳米SiO_2复合材料的力学性能和光学性能研究

采用熔融共混方法制备了LLDPE 纳米SiO2 复合材料 ,并对该体系的力学性能和光学性能进行了系统研究 .结果表明 ,随着纳米SiO2 的加入 ,复合材料的弹性模量显著提高 ,冲击强度与拉伸强度呈峰形变化 ,且均在SiO2 含量为 3phr左右达到最大值 .加入少量的纳米SiO2 后 ,复合材料薄膜对长波红外线 (7～ 1 1 μm)的吸收能力较LLDPE膜有了显著提高 ,透光率略有下降但雾度提高 ,透光质量得到改善 .同时表明 ,纳米SiO2 的表面处理方法对膜的光学性能有显著影响     

不同硬段含量脂肪族聚脲的结构与性能研究

通过端氨基聚醚、异佛尔酮二异氰酸酯和异佛尔酮二胺反应 ,合成了一系列不同硬段含量的脂肪族聚脲 ,并用DSC和FTIR等考察了硬段含量对聚脲的微观结构与力学性能的影响 .研究结果表明 ,聚脲呈现部分微观分相的形态 ,随硬段含量增加 ,聚脲中软段和硬段间的相容性提高 ,脲羰基的氢键化程度增加 ,但软段的玻璃化转变温度变化不大 ;此外 ,材料的拉伸强度、撕裂强度和硬度等也随着硬段含量的增加而显著提高 .     

聚丙烯改性研究

采用马来酸酐、二甲基丙烯酸乙二醇酯、三羟甲基丙烷三基丙烯酸酯对聚丙烯进行改性。以自由基反应机理为基础，讨论了引发剂用量、反应时间、改性试剂的种类、用量等因素对改性ＰＰ凝胶含量及性能的影响，提出了力学性能的优选条件。得到了力学性能优良的改性ＰＰ，为其进一步功能化提供了理论参考。     

高效液相色谱-串联质谱法同时测定表层水体中5类40种抗生素

建立了固相萃取-高效液相色谱-串联质谱（SPE-HPLC-MS/MS）同时检测表层水中5类40种抗生素的分析方法。水样经过滤、固相萃取柱富集净化后，以乙腈-0.2%（v/v）甲酸水溶液为流动相进行梯度洗脱，采用电喷雾电离源，在多反应监测、正离子模式进行定性定量分析。结果显示，40种抗生素在1~200 μg/L水平下线性关系良好，平均加标回收率为41.3%~112.6%。采用该方法对长江南京段表层水体进行检测，共检出13种抗生素，含量为13.4~780.5 ng/L，其中喹诺酮类抗生素恩诺沙星检出率达100%，大环内酯类抗生素克林霉素最高检出水平达739.4 ng/L。该法高效、灵敏、可靠，可用于实际水样中多种抗生素的分析。     

新型纤维素衍生物手性固定相的制备及其对几种对映异构体的高效液相色谱分离

合成了一种经环十二烷修饰的纤维素酯，将其涂敷于小粒径的氨丙基化硅胶（APS）上，制备出高效液相色谱手性固定相，以正己烷、异丙醇为流动相拆分了2-对氯苯基丙腈、1-对氟苯基乙醇、1-对叔丁基苯氧基-2-丙醇、2-对氯苯基辛腈及三唑醇等5种外消旋对映体，并考察了流动相中异丙醇含量对分离效果的影响。     

Thermal and mechanical properties of UV irradiated collagen/chitosan thin films

The thermal and mechanical properties of collagen/chitosan blends before and after UV irradiation have been investigated using thermal analysis and mechanical (Instron) techniques. Comparisons were made with the thermal and mechanical properties of both collagen and chitosan films. Air-dried collagen, chitosan and collagen/chitosan films were exposed to UV irradiation (wavelength 254 nm) for different time intervals. Thermal properties of collagen/chitosan blends depend on the composition of the blend and are not significantly altered by UV irradiation.Mechanical properties such as ultimate tensile strength and ultimate percentage of elongation were much better for collagen films than for collagen/chitosan films. The results have shown that the mechanical properties of the blends were greatly affected by the duration of UV irradiation. Ultimate tensile strength and ultimate percentage elongation decreased after UV irradiation of the blend. Increasing UV irradiation leads to an increase in Young's modulus of the collagen/chitosan blend.     

聚硅氧烷涂敷的反相高效液相色谱固定相

用甲基乙烯基聚硅氧烷涂敷于硅烷化的微粒硅胶上，制备出一种新型的涂敷型反相高效液相色谱固定相。该固定相对极性、非极性和碱性化合物均有良好的分离能力，峰对称性好。对其恶性循环 了考察，连续使用三个月后，固定相的碳量和色谱性能仍保持不变。     

Voltammetric studies of microcrystalline C60 adhered to a carbon electrode surface and placed in contact with aqueous electrolyte containing potassium ions

The reduction of microcrystalline C₆₀ fullerene, adhered at a carbon electrode and immersed in aqueous electrolyte, has been studied under various voltammetric conditions. This work reports mainly the voltammetric studies carried out principally in electrolyte containing potassium ions. Comparison of adherence techniques, such as solvent casting and mechanical transfer methods, are made to assess if the type of adhered techniques has any significant influence on the observed electrochemistry. The solvent casting method is found to produce three peaks in the potential for C₆₀^0/n- redox couple as compared to a single and large peak produced when a mechanical transfer technique is employed. When the reduction potential of microcrystalline C₆₀ in the presence of K⁺ is compared with other cations, such as Li, Na, Rb and Cs, it is observed that the shift of reduction potential follows the change in the hydration energy in the order Cs>Rb>K>Na>Li. In a mixed electrolyte study of CsCl/KCl, the reduction potential and peak shape of C₆₀^0/n- redox couple during cyclic voltammetry is observed to change with concentration of the cations and the observed electrochemistry can be attributed to a cation-exchange mechanism. The reduction of C₆₀ is irreversible in aqueous electrolyte containing alkaline cations as the re-oxidation process does not produce any observed electro-activity. Evidence of the formation of a passive coating of K _n C₆₀ fulleride, which does not appear to undergo dissolution is obtained under cyclic voltametric conditions. This coating remains electrochemically active in the presence of tetrabutylammonium ions in acetonitrile. Scan rate, chronocoulometric, and scanning electron microscopic studies provide evidence of the presence of a surface process involving solid–solid transformation.     

Structure and properties of compatibilized recycled poly(ethylene terephthalate)/linear low density polyethylene blends

Blends of recycled poly(ethylene terephthalate) (R-PET) and linear low density polyethylene (LLDPE) were compatibilized with poly(styrene-ethylene/butyldiene-styrene) (SEBS) and maleic anhydride-grafted poly(styrene-ethylene/butyldiene-styrene) (SEBS-g-MA). Effects of compatilizer were evaluated systematically by study of mechanical, thermal and morphology properties together with crystallization behavior of PET. Tensile properties of the blends were improved effectively by the addition of 10 wt% SEBS-g-MA, elongation at break and charpy impact strength were increased with the increasing content of compatilizer. SEBS-g-MA is more effectual on mechanical properties of R-PET/LLDPE blends than SEBS. DSC analysis illustrates crystallinities of PET and LLDPE were increased by compatilizer at annealing condition. WAXD and FT-IR spectra show that annealing influences crystallization behavior of PET. Different compatilizer content results in different morphology structure, in particular, higher SEBS-g-MA content can induce the formation of a salami microstructure.