书籍扫描图像畸变参数自动计算方法的研究

为实现书籍扫描图像的畸变自动校正,提出用多项式来描述各像素的理论灰度g(zi)与页面上对应点到扫描仪工作平面距离zi二者之间的关系。为确立该多项式,在畸变参数已知条件下扫描一幅图像,根据已知畸变参数求出zi,即可按最小二乘法原理由各像素灰度的实际值求出多项式的各个系数。实验证明,采用4阶多项式已能满足一般要求,并求出了各系数。对任意扫描图像,自动计算畸变参数的方法为:首先利用扫描图像上页边空白处各像素的灰度,对畸变参数进行估计,并求出zi的估计值;然后代入所确立的多项式,可求得g(zi);通过调整各畸变参数的估计值,直到g(zi)与gi最为接近,即得最佳畸变参数。用于图像校正实验,获得了较好的校正效果,最大误差由不校正时的41%下降到了6.9%。这使得无需用户测量并输入有关畸变参数即可进行自动校正。     

Determination of a control parameter in a one-dimensional parabolic equation using the method of radial basis functions

In this work, the method of radial basis functions is used for finding the solution of an inverse problem with source control parameter. Because a much wider range of physical phenomena are modelled by nonclassical parabolic initial-boundary value problems, theoretical behavior and numerical approximation of these problems have been active areas of research. The radial basis functions (RBF) method is an efficient mesh free technique for the numerical solution of partial differential equations. The main advantage of numerical methods which use radial basis functions over traditional techniques is the meshless property of these methods. In a meshless method, a set of scattered nodes are used instead of meshing the domain of the problem. The results of numerical experiments are presented and some comparisons are made with several well-known finite difference schemes.     

High-throughput concept for tailoring switchable mirrors

The optical properties, the switching kinetics and the lifetime of hydrogen switchable mirrors based on Mg-Ni alloys are determined with particular regard to the composition of the optically active metal-hydride layer in combination with the thickness of the catalytic capping layer. For this, a high-throughput experiment is introduced. The switching kinetics and the reversibility of switchable mirrors are strongly thickness dependent, though the details hinge on the fine structure of the clustered capping layer. Therefore, the kinetics is correlated with the surface structures of Pd on Mg_yNi_1−y as investigated by scanning tunneling microscopy. The results are explained by the so-called strong metal-support interaction (SMSI) state, characterized by a complete encapsulation of the capping layer clusters by oxidized species originating from the support. The SMSI-effect is less important with increasing Pd-layer thickness, and is suppressed by a good wetting of the Pd-clusters on the optically active film. This explains the critical thickness for the catalyzed hydrogen uptake observed in many switchable mirror systems. Moreover, the degradation of the kinetics during cycling is found to depend on the Pd-layer thickness and on the gas environment. Only films, covered with at least 15 nm Pd, show small degradation caused by the SMSI-effect. The SMSI-effect is partly reversible: after changing the gas environment from hydrogen to oxygen, the oxide on the Pd-clusters can be partly removed.     

单轴晶体内表面入射e光线的双反射

基于光线遵从的Fermat原理,从几何学的角度讨论和分析了在单轴晶体中入射的e光线在界面上的双反射,得到了确定光线反射方向的一般公式,并对几种特殊情况进行了讨论.指出了上述结果与由电磁波的边界条件计算所得结果是一致的.     

磁场下含结构缺陷多组分超晶格中的局域电子态和电子输运

在有效质量近似理论下，利用转移矩阵和有效垒高方法研究了有限磁场下含结构缺陷的多组分超晶格中局域电子态的性质.在考虑各组分层有效质量的失配时，外加磁场会导致磁耦合效应的出现.磁耦合效应不仅引起局域电子能级的量子化，并且随着朗道指数或磁场强弱的变化，局域能级及其局域程度都会发生显著移动，特别是对高能区域的局域电子态影响更大.此外，还计算了电子输运系数，讨论了含结构缺陷的三组分超晶格中局域电子能级与输运谱透射禁区中的共振透射峰的关系，发现两者之间有着很好的对应关系，为相应的实验研究提供了依据. 关键词： 超晶格 局域电子态 磁场     

基于内生信息的股票发售机制比较研究

本文在内生信息成本的基础上，通过引入投资银行的信息成本函数，考察了国际上主要股票发售机制的内在机理，并用一个统一的框架比较了各种发售机制的差异及演进趋势。本研究表明，在投资银行和投资者信息成本相同的情况下，由于固定价格发售机制须用额外的折价去解决投资者之间的信息问题，因而相对于累计投标询价制是一种处于劣势的机制选择。同时指出，具有信息成本优势的机构投资者的出现和发展，是固定价格发行向询价发行过渡的一个必要条件。     

实验数据中的坏值及剔除方法

本文对实验得出的数据采用数理统计的方法进行判断,确定测试结果的正确性;对测试结果出现的坏值应给予剔除。     

一种基于Meta分析固定效应模型的简明统计学方法

为了让临床医生更方便地使用M eta分析方法,我们根据四格表数据特点,提出了一种基于固定效应模型的简明方法。该方法简单而容易操作,且统计结果与原方法完全等价,在循证医学领域很有推广价值。     

Holographic interferometry as electrochemical emission spectroscopy of a carbon steel in 5–20 ppm TROS C-70 inhibited seawater

In the present investigation, holographic interferometry was utilized for the first time to determine the rate change of the number of the fringe evolutions during the corrosion test of a carbon steel in blank seawater and seawater with different concentrations of a corrosion inhibitor. In other words, the anodic dissolution behaviors (corrosion) of the carbon steel were determined simultaneously by holographic interferometry, as an electromagnetic method, and by the electrochemical impedance (EI) spectroscopy, as an electronic method. So, the abrupt rate change of the number of the fringe evolutions during corrosion tests, EI spectroscopy, of the carbon steel is called electrochemical emission spectroscopy. The corrosion process of the steel samples was carried out in blank seawater and seawater with different concentrations, 5–20 ppm, of TROS C-70 corrosion inhibitor using the EI spectroscopy method, at room temperature. The electrochemical-emission spectra of the carbon steel in different solutions represent a detailed picture of the rate change of the anodic dissolution of the steel throughout the corrosion processes. Furthermore, the optical interferometry data of the carbon steel were compared to the data, which was obtained from the EI. spectroscopy. Consequently, holographic interferometry is found very useful for monitoring the anodic dissolution behaviors of metals, in which the number of the fringe evolutions of the steel samples can be determined in situ.