Identical Superdeformed Bands in ^171Ta and ^173Re

The rotational band built on the i13/2 proton [660,1/2] Nilsson state in ^173Re is proven to be identical to that in ^171Ta.The close similarity of the two bands in ^171Ta and ^173Re suggests that the ^173Re nucleus with the odd proton based on the i13/2 [660,1/2] Nilsson state may be triaxially superdeformed.     

κ玻色子q相干态的反聚束效应

研究了q变形湮没算符高次幂（αq^k,κ≥3)本征态的反聚束效应，并就κ=3的情况用数值计算方法研究了q变形参数对该效应的影响。结果表明，当q变形相干态中谐振子的强度x=|z|^2在某些区间内取值时，αq^k的本征态将呈现反聚束效应，并且这一效应明显地受到q参数的影响。当参数q取定时，随着q变形光场强度的变大，该光场的光子数涨落在经典（或量子）和量子（或经典）特性之间交替地变化。     

双面电弧焊接的传热模型

将等离子焊接(PAW)电弧和钨极氩弧焊(TIG)电弧串接,相对作用于工件的正反面形成双面电弧焊接(DSAW)系统,可以引导焊接电流沿工件厚度方向流过小孔,补偿等离子电弧穿透工件时消耗的能量,以有效地提高等离子弧的穿透能力.综合考虑影响双面电弧焊接正反面熔池几何形状的力学因素,建立了熔池表面变形的控制方程,以此为基础并采用帖体曲线坐标系建立了DSAW焊接传热的数学模型,分析了DSAW,PAW焊接传热的差异,从传热的角度解释了DSAW焊接熔深增加的原因.焊接工艺实验表明,计算结果与实测结果吻合良好. 关键词： 双面电弧焊接(DSAW) 传热模型 熔池表面变形模型     

亚皮秒光脉冲在密集色散管理光纤中的传输特性

文章从包含高阶效应的非线性薛定谔方程出发,基于一种二阶和三阶色散都作了完全补偿(零路径平均色散)的光纤级联系统模型,用数值法对亚皮秒(几百飞秒)高斯光脉冲在密集色散管理光纤(放大周期远远大于色散补偿周期,La>>Lc)中的传输特性做了研究.结果表明啁啾化亚皮秒光脉冲在短周期色散补偿光纤中可以实现稳定传输.色散管理的密集化程度越高,即色散补偿周期越短,光脉冲在光纤中传输时的呼吸度越小,前后脉冲间的相互作用也越弱,有利于提高光纤传输系统的性能.此外,由于色散管理孤子的系统功率较小,因此高阶非线性项的影响不大.     

吸积盘的X射线辐射对周围星际物质的离化研究

利用辐射流体力学程序对三倍频纳秒激光与靶物质相互作用进行了模拟研究，得到了可以产生黑体辐射谱分布的激光等离子体X射线辐射靶的最佳厚度；数值模拟研究了黑体谱分布的X射线辐射场对等离子体系统平均离化度分布的影响，它有助于深入理解天体物理中吸积盘对它周围星际物质的离化影响. 关键词： 辐射流体力学 激光等离子体 X射线辐射 吸积盘 离化     

On Polynomial Functions over Finite Commutative Rings

Let R be an arbitrary finite commutative local ring. In this paper, we obtain a necessary and sufficient condition for a function over R to be a polynomial function. Before this paper, necessary and sufficient conditions for a function to be a polynomial function over some special finite commutative local rings were obtained.     

q变形对相干态的相位概率分布特性

通过推广Pegg和Barnett的相位算符和相位态到q变形的双模情况, 应用数值计算 研究了q变形对相干态的相位概率分布特性. 结果表明, q变形对相干态的相位概率分布受到相位参数、q参数和参数│ξ│的调节, 从而反映出不同的量子相干特性.     

Electronic Properties of Red P-Type Tl2S5 Single Crystals

Single crystals of red Tl2S5 were prepared by a special modified vertical Bridgman and Stockbarger technique.This growth was performed in our laboratory. The influences of temperature on the electrical conductivity, Hall mobility, carrier concentration, and thermoelectric power (TEP) were carried out in the temperature range 277-413K. Throughout these measurements, various physical parameters such as effective mass of charge carriers,carrier mobility, diffusion coefficient, and the relaxation time for both majority and minority carriers were found.     

Deformation Morphology underneath the Vickers Indent in Bulk Metallic Glasses

Plastic deformation behaviour of Zr52.5Al10Ni10Cu15Be12.5 and Mg65Cu25Gd10 bulk metallic glasses (BMGs) is studied by using the depth-sensing nanoindentation and microindentation. The subsurface plastic deformation zone of the BMGs is investigated using the bonded interface technique. Both the BMGs exhibit the serrated flow depending on the loading rate in the loading process of indentation. Slow indentation rates promote more conspicuous serrations, and rapid indentations suppress the serrated flow. Mg-based BMG shows a much higher critical loading rate for the disappearance of the serration than that in Zr-based BMG. The significant difference in the shear band pattern in the subsurface plastic deformation zone is responsible for the different deformation behaviour between the two BMGs. Increase of the loading rate can lead to the increase of the density of shear bands. However, there is no distinct change in the character of shear bands at the loading rate of as high as1000 nm/s.