Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Solid-phase epitaxy of CaSi2 on Si(1 1 1) and the Schottky-barrier height of CaSi2/Si(1 1 1)

Thin Ca films were evaporated on Si(1 1 1) under UHV conditions and subsequently annealed in the temperature range 200–650 °C. The interdiffusion of Ca and Si was examined by ex situ Auger depth profiling. In situ monitoring of the Si 2p core-level shift by X-ray photoemission spectroscopy (XPS) was employed to study the silicide formation process. The formation temperature of CaSi₂ films on Si(1 1 1) was found to be about 350 °C. Epitaxial growth takes place at T≥400 °C. The morphology of the films, measured by atomic force microscopy (AFM), was correlated with their crystallinity as analyzed by X-ray diffraction (XRD). According to measurements of temperature-dependent I–V characteristics and internal photoemission the Schottky-barrier height of CaSi₂ on Si(1 1 1) amounts to qΦ_Bn=0.25 eV on n-type and to qΦ_Bp=0.82 eV on p-type silicon.     

HgCl2/I2复合催化剂协同催化合成异丙醇钇的研究

以金属钇和异丙醇为原料，以HgCl2/I2为复合催化剂，通过对金属钇的机械加工以增加其比表面，并将异丙醇脱水使其含水量降低至0．05％，体系在82℃回流5h，经过滤、减压蒸馏，得到了白色海绵状异丙醇钇，其产率高达83％，合成时间比文献报道的缩短了19h，产率提高了8％。文章确定了催化剂的最佳用量为20gY加入60mg HgCl2/I2，研究了合成产率与HgCl2/I2催化剂和HgCl2催化剂的依赖关系及异丙醇中含水量对合成产率的影响，并对HgCl2/I2的催化作用机理进行了初步探讨。     

SN方法粒子输运计算程序自动建模关键技术问题研究

在充分调研和分析SN方法粒子输运计算程序自动建模方法的基础上，对建模过程中的模型文件格式识别、属性编辑、空腔处理及自动划分离散网格等关键技术问题进行了研究，并提出了合理可行的解决方法。通过对SNAM程序建模部分功能测试，验证了这些方法的正确性和有效性。This paper presents two approaches to enhance the geometry modeling ability of SN particle transport simulation codes and focus on the key issues that lie in the processing from CAD model to SN code geometry model, e.g. CAD file format support, void modeling, mesh generation and model-editing. SNAM （SN Automatic Modeling system） has been developed as an interface code between commercial CAD software and SN particle transport simmulation codes. The testing results have shown that the algorithm and implementation used in SNAM are efficient and capable of all the necessary processing from CAD model to SN geometry model.     

General strategy for a short and efficient synthesis of 3-hydroxy-4-methylprolines (HMP)

The non-proteinogenic amino acid 3-hydroxy-4-methylproline (HMP) is an active constituent of some potent antimicrobials including echinocandins, nostopeptins, pneumocandins, sporiofungin and mulundocandins. A synthesis has been achieved in 10 steps with 29% overall yield; the Evans’ aldol reaction using Crimmins’ modified method was pivotal to the success of the strategy.     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.     

On Some Integral Equations in Hilbert Space with an Application to the Theory of Elasticity

A Volterra type integral equation in a Hilbert space with an additional linear operator L and a spectral parameter depending on time is considered. If the parameter does not belong to the spectrum of L unconditional solvability of the considered problem is proved. In the case where the initial value of the parameter coincides with some isolated point of the spectrum of the operator L sufficient conditions for solvability are established. The obtained results are applied to the partial integral equations associated with a contact problem of the theory of elasticity.     

A study of the fluorescent properties of spin-coated sodium salicylate thin films

Thin films of sodium salicylate were deposited by spin coating from a solution prepared by dissolving sodium salicylate in methanol. The films were characterized by X-ray photoelectron spectroscopy, X-ray diffraction, scanning electron microscopy, UV-visible spectroscopy and spectrofluorometry. The films were crystalline with a strong blue fluorescence peak at an emission wavelength of 419.3 nm. The influence of solution concentration, spin speed and annealing temperature on the fluorescence intensity was studied. Optimum results were obtained with a solution whose concentration was 2.5 M. It was found that lower spin speed resulted in higher fluorescence intensity. Moreover, the fluorescence intensity decreased as the annealing temperature was increased. The durability of the films over a period of 30 days was also investigated, and films annealed at higher temperatures were found to be less degraded with time.     

SEPARATING SCN~- FROM DESULPHURIZATION WASTE SOLUTION OF COCKING PLANT BY D241 RESIN

1. INTRODUCTION In the process of coking plant, about 30%~35% sulfur is transformed to H2S and some other sulfide, which form impurity in coal gas together with NH3 and HCN. Only 0.1% H2S containing in air can lead to die, so it is very important to carry on desulphurization and decyanation with coal gas [1~3]. Currently desulphurization and decyanation craft technique have Dry Oxidation Technology, Wet Oxidation Technology and Liquid Absorption Technology [2] three main kinds. The…     

A solution of the DGLAP equation for gluon at low x

We obtain a solution of the DGLAP equation for the gluon at low x first by expanding the gluon in a Taylor series and then using the method of characteristics. We test its validity by comparing it with that of Glück, Reya and Vogt. The convergence criteria of the approximation used are also discussed. We also calculate εF ₂(x,Q)²/ε In Q ² using its approximate relations with the gluon distribution at low x. The predictions are then compared with the HERA data.