Synergistic effects in mixed gas chromatographic stationary phases containing hepatkis(2.3.6-tri-O-pentyl)-β-cyclodextrin and AgNO3 or TINO3 in the separation of xylene isomers

Summary The gas chromatographic separation of xylene isomers using special mixed stationary phases consisting of heptakis(2.3.6-tri-O-pentyl)-β-CD-AgNO₃, heptakis (2.3.6-tri-O-pentyl)-β-CD-TINO₃ or bentone-34-AgNO₃ is investigated. The first two have positive synergistic effects for the separation of m, and p-xylene isomers, but negative synergistic effects for the m, and oisomers. The separation effects depend on temperature, mixing ratio and how mixing is accomplished.     

神经网络法用于多元混酸同时测定

利用多层神经网络误差反向传播算法处理酸碱电位滴定数据，求得出多元混合酸各组分的浓度，优化了神经网络的结构和参数，测定了三组分有机酸混合样品，结果良好，平均相对偏差ＲＳＤ≤４％。     

六氰合铁酸铜钴在蜡浸石墨电极表面的电化学沉积

首次报道了电化学沉积的混合金属六氰合铁酸盐修饰电极作为电流型传感器的研究。针对六氰合铁酸盐修饰电极在中性和碱性条件下的不稳定性，采用混合金属电沉积的方法，成功地提高了电极的稳定性，所得到的修饰电极在 ｐＨ ４～１０之间均表现出良好的稳定性。该电极的响应时间（ｔ９５％）为 ０．５ｓ，并对Ｆｅ３＋／Ｆｅ２＋电对表现出良好的电催化作用。催化氧化峰电流与Ｆｅ２＋的浓度在１．０×１０－４～６．５×１０－２ｍｏｌ/Ｌ范围内呈很好的线性关系，检测下限为 １．４×１０－６ｍｏｌ／Ｌ。     

Poly(ethylene glycol) as Impregnator for Silica Gel in Salting-Out Thin-Layer Chromatography of Some Co(III) Complexes

Silica gel impregnated with poly(ethylene glycol) of different molecular mass (400, 1000, 1540, 4000, and 5500) was investigated for salting-out thin-layer chromatography of 15 mixed aminocarboxylato Co(III) complexes using eight ammonium sulphate solutions as mobile phases. Regularities established earlier for non-impregnated adsorbents are also valid in this work. Poly(ethylene glycol) of high molecular mass increases the hydrophobicity of the adsorbent. Positive linear dependence of R_M values and of salting-out efficiency on average poly(ethylene glycol) molecular mass was usually observed. In contrast with non-impregnated silica gel, separation was achieved between complexes with the smallest hydrocarbon groups.     

Preparation and Properties of Nickel and Iron Oxides obtained by Calcination of Layered Double Hydroxides

A constant pH precipitation method has been applied to obtain solids with Ni/Fe molar ratios of 2/1, 3/2, 1/1, 2/3, and 1/2. In all cases, a phase with the hydrotalcite‐like structure is obtained, containing Ni^II and Fe^III in the brucite‐like layers and carbonate in the interlayer, and, for samples with a Ni/Fe molar ratio lower than 2/1, amorphous hydrated iron oxides, undetected by X‐ray diffraction, are also formed. The solids have been characterized by element chemical analysis, powder X‐ray diffraction, differential thermal analysis, thermogravimetric and differential thermogravimetric analysis, FT‐IR spectroscopy, temperature‐programmed reduction and assessment of specific surface area by nitrogen adsorption at ?196 °C. In all cases reduction leads to zero‐valent state for the metals, reduced nickel particles probably favouring reduction of Fe^III species; the specific surface area increases with the iron content, probably due to the amorphous nature of the hydrated iron oxides formed. Calcination at 1200 °C in air leads to well crystallized solids, formed by NiFe₂O₄ spinel and, additionally, rocksalt‐type NiO for Ni/Fe ratios larger than 1/2. In this way, solids with tailored compositions of these two phases can be prepared.     

Detection of antisperm antibody in human serum using a piezoelectric immunosensor based on mixed self-assembled monolayers

A novel piezoelectric immunosensor based on mixed self-assembled monolayers (mixed SAMs) formed by short-chain amine- and carboxyl-terminated thiols has been developed to immobilize antigens onto gold electrodes for detecting antisperm antibody (AsAb) in human serum samples. The properties and the enhanced performance of the affinity biosensor interface based on mixed SAMs are investigated. Most importantly, analytical results of several human serum samples using the developed technique are in satisfactory agreement with those given by the enzyme-linked immunosorbent assay (ELISA) method in the concentration ranging from 32.3 to 300.0 mU/ml. It means the procedure proposed in this paper is likely to have a great potential in research and may play an important clinical role in a few years later.     

C12-2-En-C12•2Br与SDS混合水溶液的胶团化研究

与[C12H25N＋(CH3)2CH2]2•2Br－(简记为C12-2-C12•2Br)/ C12H25SO4Na(SDS)混合水溶液相比,随着联接链上乙氧基团(E)数目增加,[C12H25N＋(CH3)2]2C2H4(OC2H4)n•2Br－(简记为C12-2-En-C12•2Br, n=2,3)与SDS混合水溶液澄清区域明显增大. C12-2-E3-C12•2Br/SDS混合胶团化过程中二组分产生了协同效应,理论预测在澄清区域所能达到的最小临界胶团总浓度(cmcT,min)= 0.0339 mmol•L－1,对应的SDS在溶液体相中的摩尔分数(x2*)=0.447.当水溶液体相中SDS摩尔分数(x2)=0.5时,混合胶团总聚集数(NT)=36,混合胶团中SDS的摩尔分数(x2M)=0.43.     

Separation and selectivity in micellar electrokinetic chromatography using sodium dodecyl sulfate micelles or Tween 20-modified mixed micelles

The separation and selectivity of eight aromatic compounds ranging from hydrophilic to hydrophobic properties in micellar electrokinetic chromatography (MEKC) using sodium dodecyl sulfate (SDS) micelles or Tween 20-modified mixed micelles were investigated. The effect of different operation conditions such as SDS and Tween 20 modifier surfactant concentration, buffer pH, and applied voltage was studied. The resolution and selectivity of analytes could be markedly affected by changing the SDS micelle concentration or Tween 20 content in the mixed micelles. Applied voltage and pH of running buffers were used mainly to shorten the separation time. Complete separation of eight analytes could be achieved with an appropriate choice of the concentration of SDS micelles or Tween 20-modified mixed micelles. Quicker elution and better precision could be obtained with SDS-Tween 20 mixed micelles than with SDS micelles. The mechanisms that migration order of those analytes was mainly based on their structures and solute-micelle interactions, including hydrophobic, electrostatic, and hydrogen bonding interactions, were discussed.     

离子液体[BMim]BF4对SDS水溶液表面活性和聚集能力的促进

采用表面张力测定法和核磁共振谱等方法研究了阴离子表面活性剂十二烷基硫酸钠(SDS)在水溶性室温离子液体[BMim]BF4/水混合溶剂中的表面性质及聚集行为, 发现极少量[BMim]BF4的介入就可以显著降低SDS的临界胶束浓度, 提高体系的表面活性; 且[BMim]BF4在混合溶剂中所占的摩尔分数(x1)在一定范围内(0相似文献   

Synthesis and Crystal Structure of Bis(tetraethylammonium) Octabromo‐triselenate(II)‐{dibromodiselenate(I)}, [NEt4]2[Se3Br8(Se2Br2)], the Salt of a Mixed‐valence Bromoselenate(II,I) Anion

The brown crystals of [NEt₄]₂[Se₃Br₈(Se₂Br₂)] ( 1 ) were obtained when selenium and bromine reacted in the solution of acetonitrile in the presence of tetraethylammonium bromide. The crystal structure of 1 has been determined by the X‐ray methods and refined to R = 0.0308 for 10433 reflections. The crystals are monoclinic, space group P2₁ with Z = 2 and a = 12.0393(3) Å, b = 11.8746(3) Å, c = 13.1946(3) Å, β = 96.561(1)° (123 K). In the solid state structure the anion of 1 is built up of Se₃Br₈ unit which consists of a triangular arrangement of three planar SeBr₄ units sharing a common edge through two μ₃‐bridging Br atoms, and one Se₂Br₂ molecule which is linked to one of μ₃‐bridging Br atoms. The three Se^II atoms form a triangle which is almost perpendicular to the planes given by three SeBr₄ moieties. The contact between the μ₃Br and the Se^I atom of the Se₂Br₂ molecule is 3.1711(8) Å and can be interpreted as a bond of the donor‐acceptor type with the μ₃Br as donor and the Se₂Br₂ molecule as acceptor. The terminal Se^II‐Br and μ₃Br‐Se^II bond lengths are in the ranges 2.3537(7)–2.4737(7) Å and 2.7628(7)–3.1701(7) Å, respectively. The bond lengths in coordinated Se₂Br₂ molecule are: Se^I‐Se^I = 2.2636(9) Å, Se^I‐Br = 2.3387(11) and 2.3936(8) Å.