Epoxidation and oxidation reactions using 1,4-butanediol dimethacrylate crosslinked polystyrene-supported tertiary butyl hydroperoxide

1,4-Butanediol dimethacrylate (1,4-BDDMA) crosslinked polystyrene-supported t-butyl hydroperoxide was employed in the epoxidation of olefins and oxidation of alcohols to carbonyl compounds. The reagent proved to be successful as a recyclable solid phase organic reagent with as much or more efficiency when compared to its monomeric counterpart. The extent of reaction was found to be dependent on various reaction parameters like solvent, temperature, molar concentration and presence of catalyst.     

Sensitive trace enrichment of environmental andiandrogen vinclozolin from natural waters and sediment samples using hollow-fiber liquid-phase microextraction

The presence of vinclozolin in the environment as far as the endocrine disruption effects in biota are concerned has raised interest in the environmental fate of this compound. In this respect, the present study attempts to investigate the feasibility of applying a novel quantitative method, liquid-phase microextraction (LPME), so as to determine this environmental andiandrogen in environmental samples such as water and sediment samples. The technique involved the use of a small amount (3 microL) of organic solvent impregnated in a hollow fiber membrane, which was attached to the needle of a conventional GC syringe. The extracted samples were analyzed by gas chromatography coupled with electron-capture detection. Experimental LPME conditions such as extraction solvent, stirring rate, content of NaCl and pH were tested. Once LPME was optimized, the performance of the proposed technique was evaluated for the determination of vinclozolin in different types of natural water samples. The recovery of spiked water samples was from 80 to 99%. The procedure was adequate for quantification of vinclozolin in waters at levels of 0.010 to 50 microg/L (r> 0.994) with a detection limit of 0.001 microg/L (S/N= 3). Natural sediment samples from the Aliakmonas River area (Macedonia, Greece) spiked with the target andiandrogen compound were liquid-liquid extracted and analyzed by the methodology developed in this work. No significant interferences from the samples matrix were noticed, indicating that the reported methodology is an innovative tactic for sample preparation in sediment analysis, with a considerable improvement in the achieved detection limits. The results demonstrated that apart from analyte enrichment, the proposed LPME procedure also serves as clean-up method and could be successfully performed to determine trace amounts of vinclozolin in water and sediment samples.     

Rapid determination of panaxynol in a traditional Chinese medicine of Saposhnikovia divaricata by pressurized hot water extraction followed by liquid-phase microextraction and gas chromatography-mass spectrometry

Panaxynol is a bioactive component in traditional Chinese medicines (TCMs), such as Saposhnikovia divaricata and Panax ginseng. In the work, two solvent-free sample techniques of pressurized hot water extraction (PHWE) and headspace liquid-phase microextraction (HS-LPME) were combined and developed for the determination of panaxynol in a TCM of S. divaricata. Panaxynol in the TCM samples from different growing areas was extracted by PHWE in dynamic mode, followed by extraction and concentration with HS-LPME and analysis with gas chromatography-mass spectrometry (GC-MS). The PHWE and HS-LPME parameters were optimized and the method validations were studied. Panaxynol in S. divaricata from four different growing areas was quantitatively analyzed by internal standard method. These results have shown that PHWE-LPME-GC-MS is a simple, rapid, efficient and low-cost method for the determination of panaxynol in TCMs and is a potential tool for TCM quality assessment.     

Feasibility of a liquid-phase microextraction sample clean-up and liquid chromatographic/mass spectrometric screening method for selected anabolic steroid glucuronides in biological samples

Anabolic androgenic steroids (AAS) are metabolized extensively in the human body, resulting mainly in the formation of glucuronide conjugates. Current detection methods for AAS are based on gas chromatographic/mass spectrometric (GC/MS) analysis of the hydrolyzed steroid aglycones. These analyses require laborious sample preparation steps and are therefore time consuming. Our interest was to develop a rapid and straightforward method for intact steroid glucuronides in biological samples, using liquid-phase microextraction (LPME) sample clean-up and concentration method combined with liquid chromatographic/tandem mass spectrometric (LC/MS/MS) analysis. The applicability of LPME was optimized for 13 steroid glucuronides, and compared with conventional liquid-liquid extraction (LLE) and solid-phase extraction (SPE) procedures. An LC/MS/MS method was developed for the quantitative detection of AAS glucuronides, using a deuterium-labeled steroid glucuronide as the internal standard. LPME, owing to its high specificity, was shown to be better suited than conventional LLE and SPE for the clean-up of urinary AAS glucuronides. The LPME/LC/MS/MS method was fast and reliable, offering acceptable reproducibility and linearity with detection limits in the range 2-20 ng ml(-1) for most of the selected AAS glucuronides. The method was successfully applied to in vitro metabolic studies, and also tested with an authentic forensic urine sample. For a urine matrix the method still has some unsolved problems with specificity, which should be overcome before the method can be reliably used for doping analysis, but still offering additional and complementary data for current GC/MS analyses.     

Printed plastic electronics and paperlike displays

Plastic electronic materials and high‐resolution printing methods may be important technologies for new classes of consumer electronic devices that are lightweight, mechanically flexible and bendable, and that can cover large areas at low cost. This article summarizes some of our recent work in this area. It focuses on the materials and patterning techniques that we used to produce plastic active‐matrix backplane circuits for a type of paperlike display. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3327–3334, 2002     

Solid-Phase Microextraction Gas Chromatography for Determination of Some Organophosphorus Pesticides

A simple and rapid solid-phase microextraction (SPME) method is presented based on activated charcoal–PVC fiber for determination of some organophosphorus pesticides from aqueous samples in direct mode SPME. After optimization of the experimental variables affecting SPME of the target compounds from aqueous solutions, the proposed method was applied to determine pesticides in fruit juice. The analytes in this procedure were preconcentrated for 15 min on the SPME fiber and subsequently desorbed by heating the fiber at 200 °C for 5 min in the GC injection port. Separation was on a capillary column GC followed by flame ionization detection. Recoveries of the pesticides studied in aqueous samples ranged 42%–63% and repeatability for all analytes was < 9% for a single fiber. Fiber-to-fiber reproducibility was < 18%.     

Determination of organochlorine pesticides by gas chromatography with solid-phase microextraction

Summary A study of different extraction techniques for the determination of a selected group of organochlorine compounds in surface waters is presented. Comparison of liquid-liquid extraction (LLE) with solid-phase extraction (SPE) and solid-phase microextraction (SPME) with fibers of different polarity shows that SPME with a recently commercialised fiber of polydimethylsiloxane divinylbenzene allows these compounds to be determined in surface waters with good extraction efficiencies. Extraction time, effect of temperature, ionic strength and pH were optimised, allowing quantification in agricultural effluents in the range 1.0–60 ng·L⁻¹.     

Keggin型杂多酸在镀锌钝化中的应用

比较了H_4SiMo_(12)O_(40)、H_3PW_(12)O_(40)、H_4SiW_(12)O_(40)、H_3PMo_(12)O_(40)及铬酸盐对镀锌层钝化效果。H_3PMo_(12)O_(40)钝化的最佳条件为:H_3PMo_(12)O_(40)5g/L,pH 1.1,钝化时间35秒,温度15℃,空留时间10秒,封闭温度100℃(水)。经扫描电镜、XPS、AES、IR和Raman光谱等测定,表明在锌表面形成了一种含有P、Mo、O及Zn的耐蚀性膜。其中钼以Mo(Ⅵ)、Mo(Ⅴ)和Mo(Ⅳ)存在,P/Mo比为1:3.0。推测锌表面形成了一种形如Zn_x(PMo_3)_rO_z/ZnO/Zn的复杂钝化膜。     

SBS单组分橡胶防水涂料

探讨了SBS单组分橡胶防水涂料的组成、制备方法及其对性能的影响因素,详细地介绍了该涂料在防水工程应用上的两大独特优势:(1)优异的抗基层形变能力。这一优势,使其具备了屋面防水专用材料和特效材料的条件,解决了以往防水材料一直不能解决的“零点开裂”问题。(2)创造出多种复合防水工法,既克服和解决了卷材与涂料的各自缺点,又发挥了各自的优点,使这种复合防水层成为最有效的防水层。     

Metal Oxide Thin Films Containing Au Nano-Particles Prepared with Gas Diffusion Method

Au particles dispersed thin metal oxide films were prepared from precursor films containing HAuCl₄ with H₂S gas diffusion method. HAuCl₄ was uniformly dissolved in the films as promoted by hydroxypropyl cellulose (HPC). The mechanism of the Au particle formation was studied. It was found that HAuCl₄ was converted directly to Au metal particles upon contacting with H₂S gas. Au particles generated by this method were characterized with small particle size, sharp size distribution and high volume fraction in the films. The surface plasma resonance absorption of Au particles shifted to longer wavelength when TiO₂ component was introduced in the matrix.