Highly sensitive inhibitory kinetics fluorescence method for determination of arsenic

A new and highly sensitive inhibitory kinetic fluorescence method for the determination of arsenic (III) has been established based on its inhibitory effect on the oxidation reaction of Acridine red (ADR) by KBrO₃ in sulphuric acid medium. The reaction has been followed by measuring the enhancement of fluorescence at 550?nm. It relies on the linear relationship where the change in the fluorescence (ΔF) versus added As(III) amounts in the range of 0–0.450?µg?mL^?1 is plotted, under the optimum conditions. The sensitivity of the proposed method, i.e. the limit of detection, is 2.1?×?10^?2?ng?mL^?1. The method is featured with good accuracy and reproducibility for arsenic (III) determination. This method was successfully applied for the quantitative determination of arsenic (III) in food products samples, and the relative standard deviations and the recoveries were in ranges of 2.31–2.83% and 90.0–107.2%, respectively. A review of recently published catalytic or inhibiting kinetic methods for the determination of arsenic (III) has also been presented for comparison. The mechanism of reaction was studied.     

LiBa0.95-yBO3:0.05Tb3+,yBi3+荧光粉的制备及荧光性质

以硼酸和碳酸盐为原料,用高温固相法制备了可被（近）紫外光（369、254 nm）有效激发的Tb³⁺单掺杂LiBa_1-xBO₃：xTb³⁺（物质的量分数x=0.02、0.03、0.04、0.05、0.06、0.07）及Bi³⁺和Tb³⁺共掺杂LiBa_0.95-yBO₃：0.05Tb³⁺,yBi³⁺（物质的量分数y=0.02、0.03、0.04、0.05、0.06、0.07）的2个系列荧光粉,产物的结构和形貌分别用粉末X射线衍射（PXRD）和扫描电子显微镜进行表征。PXRD测定结果表明2个系列的产物均为纯相LiBaBO₃。通过对第一系列产物荧光光谱的测定,筛选出发光强度最好的产物,据此确定铽离子的最佳掺杂量;在此基础上制备出铋离子掺杂量不同的第二系列荧光粉。荧光光谱测定的实验结果表明,Tb³⁺/Bi³⁺共掺杂的荧光粉的发光强度好于Tb³⁺单掺杂的荧光粉,这说明Bi³⁺对Tb³⁺有敏化作用;而且随着Bi³⁺掺杂量的增加,产物的荧光强度表现出先增加后减小的趋势,当Bi³⁺的掺杂量y=0.03时,产物的荧光强度达到最大。Bi³⁺和Tb³⁺之间存在偶极-四极相互作用而进行能量传递。系列荧光粉的CIE坐标显示其发光颜色在一定程度上呈现出由绿色光到白光的渐变趋势。     

(Ca,Me)La4Si3O13:Eu3+(Me=Sr,Ba)荧光粉的结构和发光特性

采用高温固相法制备了(Ca,Me)La4Si3O13∶Eu3+(Me=Sr,Ba)系列红色荧光体,考察了Eu3+掺杂浓度和Sr2+,Ba2+置换对荧光体结构和发光特性的影响。Eu3+最佳掺杂浓度为nEu3+∶nLa3+=1∶7,5D0-7F2与5D0-7F1跃迁发射强度比为2.55。Eu3+掺杂使晶胞参数a和c呈线性变小,对c的影响大于a,使a/c比增大。Sr2+和Ba2+分别置换基质中的Ca2+可以形成完全固溶体,晶胞参数随Sr2+或Ba2+的置换量增加呈线性增大,使a/c比减小。各发射峰强度在Sr2+置换量为0.4 mol时出现极大值,但随Ba2+置换量的增加而不断增强,全置换后荧光强度最大。荧光体的色坐标为(0.638 5,0.353 0)。     

Study of Interactions and Association Thermodynamics Between Sudan Red and Sodium Dodecyl Sulfate in Microemulsions

The absorption spectrum of Sudan red III (SR) in oil solutions and a series of O/W microemulsion with surfactant sodium dodecyl sulfate (SDS) has been determined by the UV-Vis spectrophotometer. We found that an association interaction existed between the stain SR and anionic surfactant SDS in water/mixed oil/SDS microemulsions. By measuring the absorbance of Sudan red in a series of microemulsions which has different R values and using the appropriate association models to analyze the experimental data, we obtain the association constants of SR and SDS, and the values of thermodynamics functions of associationΔ_r G _m has also been calculated from the association constants.     

Determination of Total Tannin of White and Red Rind Pomegranate (Punica Granatum L.) by Colorimetry Method Using Reagent 1, 10 Phenantroline

Determination of the total tannin of white and red rind pomegranate (Punica granatum L.) has been carried out by colorimetry method using reagent 1,10 phenantroline. This method is based on reduction of iron (III) into iron (II) by tannin at temperature 80⁰C for 20 min. Then the formed of iron (II) was reacted with 1,10 phenantroline to form orange red colour complex that could be measured by spectrophotometer visible at maximum absorption wavelength of 508 nm. The limit of detection (LOD) and the limit of quantitation (LOQ) obtained were 0.34 μg/mL and 1.14 μg/mL, respectively. This result was found to be linier with R value of 0.9984; accuracy as percent recovery was 84.69 ± 0.85% and coefficient of variant (KV) was 1.003% for white rind pomegranate while red rind pomegranate percent recovery was 84.38 ± 0,45% and coefficient of variant (KV) was 0.53%. The total tannin of white rind pomegranate was 18.28 ± 0.072%b/b and red rind pomegranate was 17.33 ± 0.081%b/b     

Anaerobic biological treatment of dye bearing water in anaerobic sequencing batch reactor: Performance and kinetics studies

Textile and dye industries are main sources of dye bearing effluent. In present studies the anaerobic biological degradation of Acid Red 3BN dye water (AR3BNDW) and mixed dye water (MDW) for reduction of color and COD were studied in sequential batch reactor (SBR). The sludge as sources of microorganism was arranged from maize processing bio methanation wastewater treatment plant, which was acclimatized for treatment of AR3BNDW and MDW. After the acclimatization, dyes degradation were studied in SBR At optimum operation condition of hydraulics retention time (HRT) = 2.5 d, and treatment time (t_R) = 16 h, AR3BNDW have gone maximum 87% color reduction of 500 mg/L dye, and 82.8% COD reduction of 380 mg/L COD. At same operating condition, 84.5% color reduction of 500 mg/L dye, and 79.42% COD reduction of 413 mg/L COD achieved for MDW. The second order Grau model was fitted well for COD and dye reductions. The kinetics parameter were evaluated for both the dye water.     

In2BP3O12:Cr3+宽带近红外荧光粉的发光性能及应用研究※

近红外光谱技术在安防监控、食品检测、生物成像、农业等领域具有重要应用价值, 而开发出紧凑高效的近红外光源是其大规模商业应用的前提. 荧光粉转换型近红外发光二极管(light emitting diodes, LED)光源具有结构紧凑、成本低、使用寿命长、发射光谱可调等优点, 因此近些年受到广泛关注, 其关键就在于开发出能被蓝光有效激发的高性能近红外荧光粉. 本工作利用高温固相法制备了一种新型宽带近红外荧光粉In₂BP₃O₁₂:Cr³⁺, 在480 nm激发下, 荧光粉发射峰值位于950 nm, 光谱覆盖了750~1350 nm范围, 半峰宽达到210 nm. 采用该荧光粉与商用蓝光InGaN LED芯片封装, 获得了具有宽带发射的近红外LED光源, 在60 mA的驱动电流下, 近红外光辐射功率为5 mW. 当采用该光源照射人的手掌, 用近红外电感耦合器(charge coupled device, CCD)相机能够对手掌中的血管进行清晰的成像. 上述结果表明该近红外荧光粉可用于制备基于蓝光芯片的宽带近红外LED光源, 并在生物医学等领域具有潜在应用前景.     

美丽红色胭脂 魅力红色化学*

介绍了中国胭脂的演变简史,以化学视角对胭脂的发展进行分类:无机胭脂、有机胭脂(天然植物胭脂、有机合成类胭脂)等。进行模拟实验研究,探究胭脂制作工艺流程,分析胭脂中红色物质的成分和显色机制。阐述每个阶段胭脂的不足之处,科普胭脂中的红色化学知识,体会化学对美和健康的重要意义,感受化学的无穷魅力。     

A simple method for removal of toxic dyes such as Brilliant Green and Acid Red from the aquatic environment using Halloysite nanoclay

This project explains an easy, simple and eco-friendly method to remove some toxic dyes like Brilliant Green and Acid Red from aquatic solution by technique of solid-phase extraction that uses Halloysite nanoclay eco-friendly solid phase as absorbent surface for adsorption of dye. The physical properties of the HNC such as scanning electron microscopy, transmission electron microscope, X-ray diffraction, Fourier transform infrared spectroscopy, and surface area analysis were studied. The best conditions like pH of the solution, HNC weight, contact shaking time, the temperature of the solution, and ionic strength were investigated for removal effectiveness. The experimental data of the adsorption process showed that HNC can remove most of the dyes within 30 min, with an adsorption capacity of 12.5 mg/g for A.R dye and 13.9 mg/g for B.G dye on HNC solid phase at optimum conditions. The removal process of dyes on HNC was studied kinetically and thermodynamically, and the data confirms that the pseudo-second-order kinetic model was able to describe the adsorption process. Thermodynamic data confirms the process was spontaneous andexothermic in nature for A.R dye, while was spontaneous and endothermic in nature for B.G dye. Finally, the effectiveness of HNC was inspected by removing dyes from three various real samples, and the results showed high performance in removing dyes on HNC for four consecutive cycles.     

Removal of Anionic Dyes from Aqueous Solution with Layered Cationic Aluminum Oxyhydroxide

It is highly desired yet challenged to find an adsorbent with low cost and excellent performance in the removal of organic dyes from aqueous solution. Here we reported that a layered cationic aluminum oxyhydroxide material hydrothermally synthesized from the low-cost source materials of AlCl₃∙6H₂O, CaO and H₂O, known as JU-111, can meet such criterion in removing methyl orange(MO) and Congo red(CR). JU-111 shows fast adsorption kinetics[especially for CR(15 s)] and high adsorption capacity(MO:>1000 mg/g; CR:>2900 mg/g), surpassing most of the reported adsorbents. Comprehensive characterizations of the adsorption process of MO and CR revealed that both adsorptions were achieved via the anion exchange process. The characteristics of extremely low cost and excellent performance render JU-111 great potential in the practical applications in the removal of anionic dyes.