Search for deconfinement in NA49 at the CERN SPS

Experiment NA49 at the CERN SPS uses a large acceptance detector for a systematic study of particle yields and correlations in nucleus-nucleus, nucleon-nucleus and nucleon-nucleon collisions. Preliminary results for Pb+Pb collisions at 40, 80 and 158 A⋅GeV beam energy shown and compared to measurements at lower and higher energies.     

Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

Mass‐lumping or not mass‐lumping for eigenvalue problems

In this article we analyze the effect of mass‐lumping in the linear triangular finite element approximation of second‐order elliptic eigenvalue problems. We prove that the eigenvalue obtained by using mass‐lumping is always below the one obtained with exact integration. For singular eigenfunctions, as those arising in non convex polygons, we prove that the eigenvalue obtained with mass‐lumping is above the exact eigenvalue when the mesh size is small enough. So, we conclude that the use of mass‐lumping is convenient in the singular case. When the eigenfunction is smooth several numerical experiments suggest that the eigenvalue computed with mass‐lumping is below the exact one if the mesh is not too coarse. © 2003 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 19: 653–664, 2003     

Application of Pulsed Traveling Hydrogen Arcs for Metal Oxide Reduction

A plasma reactor that has a transient traveling arc has been used to study hydrogen in relation to in-flight reduction of metal oxide particles. Experiments were done to determine the nature of the arc and its interaction with the reactor gas. The lifetime of the excited atomic hydrogen was measured and it was found to be more than 4 ms after the arc had ceased. Powders and tablets of oxides were exposed to the pulsed-arc treated hydrogen and found to react much more rapidly and intensely than when exposed to hot molecular hydrogen. The results suggest that atomic hydrogen will exist throughout the volume of such a reactor for a period that is sufficient to reduce particles of FeO, Cr₂O₃, and TiO₂.     

激光溅射Ni等离子体与气相CH3OH团簇的反应

用激光溅射 分子束技术研究了气相中Ni的等离子体与甲醇分子团簇的反应 .观察到Ni+ (CH3 OH) n、NiO+ (CH3 OH) n、H+ (CH3 OH) n、H3 O+ (CH3 OH) n 四个种类的团簇正离子和CH3 O-(CH3 OH) n(n≤ 2 5 )一种团簇负离子 .详细考察了激光烧蚀等离子体作用于脉冲分子束的不同位置时 ,对团簇产物种类和团簇尺寸大小的影响 .发现NiO+ (CH3 OH) n 是由Ni+ (CH3 OH) n 团簇内的脱甲烷反应生成的 ,而H+ (CH3 OH) n、H3 O+ (CH3 OH) n主要是激光等离子体中的电子与甲醇团簇碰撞电离产生的     

某些类氖离子和类镍离子等离子体状态对应关系的研究

利用一维拉格朗日流体动力学程序Med103详细研究了产生类镍Ag,Cd,In,Sn, Sb离子和类氖Fe,Co,Ni,Cu,Zn离子的等离子体状态.通过对电子温度、离子丰度、离子数密度等状态参量的分析比较，得到了这两类等离子体状态之间的对应关系.即类镍银的等离子体状态与类氖铁 的相近，类镍镉的与类氖钴的相近，依次类推.利用这一对应关系可以方便地由类氖机理x射线激光的等离子体状态来对相应元素的类镍x射线激光的等离子体状态进行判断. 关键词： 类氖 类镍 等离子体状态 x射线激光     

Speciation Analysis of Inorganic Tin (Sn(II)/Sn(IV)) by Graphite Furnace Atomic Absorption Spectrometry Following Ion-Exchange Separation

A new method based on anion exchange resin separation and graphite furnace atomic absorption spectrometry (GFAAS) detection is proposed for the determination of inorganic tin species. The result showed that Sn(IV) was quantitatively retained on the resin when [HCl] = 9.0 mol · L⁻¹, but Sn(II) could not be adsorbed on the resin under the same condition. Thus, a separation of Sn(II) and Sn(IV) has been realized. When the concentration of NaOH solution was between 2.0–7.0 mol · L⁻¹, Sn(IV) that adsorbed on the resin could be eluated from the resin completely. Meanwhile, under the atmosphere and the nitrogen states, the translation between Sn(II) and Sn(IV) was investigated. Under the optimal conditions, the detection limit of Sn(IV) is 0.40 μg · L⁻¹ with RSD of 2.3% (n = 5, c = 2.0 μg · L⁻¹). The proposed method was applied to the speciation analysis of tin in different water samples and the recovery of total Sn was in the range of 98.7–101.7%. In order to verify the accuracy of the method, a certified reference water sample was analyzed and the results obtained were in good agreement with the certified value.     

Synthesis and characterization of isotopically enriched methylmercury (CH3201Hg+)

A simple procedure for the synthesis of an important standard, isotopically enriched methylmercury, which is not commercially available, has been established successfully. The isotopically enriched standard synthesized is utilized in conventional isotope dilution mass spectrometry (IDMS), as well as in speciated IDMS (SIDMS), for determination of the true concentration of methylmercury in environmental samples. The CH₃²⁰¹Hg⁺ standard has been synthesized from commercially available ²⁰¹HgO and tetramethyltin. The synthesis time required is 1 h at 60°C. The product is highly pure, yielding more than 90% as ²⁰¹Hg in CH₃²⁰¹Hg⁺. Hazardous dimethylmercury does not occur during this synthesis procedure. The product synthesized was analyzed using high‐performance liquid chromatography coupled with inductively coupled plasma mass spectrometry (ICP‐MS) and ICP‐MS alone in order to determine its concentration, isotopic composition and purity. The stability of the product was also evaluated for over 6 months and found to be stable at 4°C in the dark. The isotopically enriched methylmercury synthesized can be used in SIDMS and IDMS analyses as a standard. Copyright © 2003 John Wiley & Sons, Ltd.     

Characterization of Metallo Bis(terpyridine) Diblock Polymers by Nonaqueous Capillary Zone Electrophoresis

A method of nonaqueous capillary zone electrophoresis (CZE) has been developed to characterize block (co)polymers of poly(ethylene oxide) and poly(styrene) containing metallo bis(terpyridine) complexes as bridging units. Specific CZE separation conditions had to be applied, with barium perchlorate dissolved in N-methylformamide (NMF) as background electrolyte and OV-1701-OH deactivated capillaries. For detection UV absorption was measured at a wavelength of 316 nm. Metallo diblock polymers with molecular weights up to 30,000 Da could be analyzed by the proposed nonaqueous CZE method. Experiments performed with polymeric compounds containing Fe, Ni or Ru as central metal ions showed that their electrophoretic mobilities were independent of the type of metal ion. Therefore, the data on the size of the polymeric compounds could be obtained using just one set of calibration standards. Polydispersities of the samples calculated from the experimental results were in correlation with the polydispersities of the polymers used in the synthesis of the metallo diblock polymers. Several polymeric samples contained metallo mono(terpyridine) complexes as impurities. These by-products could be separated from the main product. With symmetrical diblock polymers only one by-product was detected, while with an asymmetric diblock polymer two types of mono-complexes were found. The amount of the mono-complexes present as impurities was dependent on the type of central metal ion (Ni > Fe >> Ru).     

A simple expression for the ADM mass

We show by an almost elementary calculation that the ADM mass of an asymptotically flat space can be computed as a limit involving a rate of change of area of a closed 2-surface. The result is essentially the same as that given by David Brown and York (Phys. Rev. D 55, 1977–1984 1997; Phys. Rev. D 47, 1407–1419 1993). We will prove this result in two ways, first by direct calculation from the original formula as given by Arnowitt, Deser and Misner and second as a corollary of an earlier result by Brewin for the case of simplicial spaces.