CATALYSIS OF POLYSTYRENE N-HYDROXYL SULFONAMIDE FOR ESTERIFICATION OF BUTANOL WITH ACETIC ANHYDRIDE

1. INTRODUCTION The development of efficient polymer-supported catalysts has attracted much attention [1]. For obtaining polymeric catalysts, catalytically active groups were introduced onto polymers mostly by copolymerization of the appropriate monomers bearing the desired catalyticfunctionalities (e.g. imidazole, OH, and COOH) or by modification of preformed polymers.Another possibility involves the attachment of side chains, containing the desired arrangement of functional groups, o…     

Kinetic Studies on the Reaction of Sodium Hexa-cyanoferrate(II) Complex with Peroxydisulfate Anion

Introduction In the previous studies on the oxidation reaction,peroxydisulfate was widely used as an oxidizingagent.1-5 One of the advantages of this oxidant lies in itsstability in a wide range of pH values. The reaction be-tween Fe(CN)5L3- (L=N-aromatic heterocyclic li-gands) and S2O8 2- has been proved to proceed throughan outer-sphere electron transfer mechanism.5 For a re-action [(Eq. (1)] to be under an outer-sphere mechanismthe steps involved are the formation of a reactant …     

Optimization of Mass Transfer Processes in the Zone of the Air Electrode of a Fuel Cell with a Solid Polymer Electrolyte

A two-dimensional mathematical model for the transport of reactants in a fuel cell with a solid polymer electrolyte is developed. The model is used for analyzing spatial distributions of the concentration of reactants and current density over the cell. The effect of the catalytic-layer activity, reactant speed, bipolar-plate geometry, thickness and porosity of current collector and/or gas-diffusion sublayer, and the reaction mixture composition on the fuel cell efficiency is estimated theoretically and experimentally.     

The First Intramolecular Charge Transfer Transition Based on 2-Ureido-4[1H]-pyrimidinone Binding Module

The first intramolecular charge transfer transition based on 2-ureido-4[1H]-pyrimidinone binding module was reported.     

TTF-porphyrin dyads as novel photoinduced electron transfer systems

A TTF-linked porphyrin dyad and its zinc complex have been synthesized as novel photosystems with a redox-active pendant. The two chromophores of these dyads are not interactive in the absorption spectra, but the fluorescence of the porphyrin chromophore is dramatically quenched by intramolecular electron transfer from the TTF pendant.     

Electron transfer induced dissociations of 2- and 4-alkyl cyclohexadienones

Several 2- and 4-alkylcyclohexadienones were prepared and shown to accept electrons to produce ketyl radical anions that dissociated rapidly at room temperature to release carbon-centered radicals and an aromatic phenoxide type anion. In the PET process with benzyl-substituted cyclohexadienones, initiated with triethylamine, the benzyl radicals dimerised or abstracted an H-atom from solvent. In electrochemical reductions, and in reductions with alkali metals in liquid ammonia, the benzyl radicals were further reduced to anions.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

Influence of isovalent substitutions on absorption spectra of orthoferrities

The role of impurity ions in formation of the optical properties of rare-earth orthoferrites is investigated. Optical spectra of the substituted against unsubstituted orthoferrites are presented. The influence of different isovalent substitutions on the optical absorption of orthoferrites that are promising for magnetooptics is studied. Institute of Solid-State and Semiconductor Physics of the Academy of Sciences of Belarus, 17, P. Brovka St., Minsk, 220072, Belarus. Translated from zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 5, pp. 642–645, September–October, 1997.     

Fluorination of diamond — C4F9I and CF3I photochemistry on diamond (100)

The radiation-induced decomposition of C₄F₉I and CF₃I overlayers at 119 K on diamond (100) surfaces has been shown to be an efficient route to fluorination of the diamond surface. X-ray photoelectron spectroscopy has been used for photoactivation as well as for studying the photodecomposition of the fluoroalkyl iodide molecules, the attachment of the photofragments to the diamond surface, and the thermal decomposition of the fluoroalkyl ligands. Measured chemical shifts agree well with ab initio calculations of both C 1s and F 1s binding energies. It is found that chemisorbed CF₃ groups on diamond (100) decompose by 300 K whereas C₄F₉ groups decompose over the range 300 to 700 K and this reactivity difference is rationalized on steric grounds. Both of these thermal decomposition processes produce surface C---F bonds on the diamond. The surface C---F species thermally decompose over a wide temperature range extending up to 1500 K. Hydrogen passivation of the diamond surface is ineffective in preventing free radical attack from the photodissociated products of the fluoroalkyl iodides; I atoms produced photolytically abstract H from surface C---H bonds to yield hydrogen iodide at 119 K allowing diamond fluorination. The attachment of chemisorbed F species to the diamond (100) surface causes band bending as the surface states are occupied as a result of chemisorption. This results in a shift to higher binding energy of the diamond-related C 1s levels present in the surface and subsurface regions which are sampled by XPS on the diamond. The use of photoactivation of fluoroalkyl iodides for the fluorination of diamond surfaces provides a convenient route compared to other methods involving the action of atomic F, molecular F₂, XeF₂ and F-containing plasmas.