New organosols of nickel sulfides,palladium sulfides,manganese sulfide,and mixed metal sulfides and their use in preparation of semiconducting polymer-metal sulfide composites

Organosols of NiS, PdS, and MnS in N,N-dimethylformamide were prepared by reaction of the metal acetate with H₂S. Organosols of mixed-metal sulfides (Zn _x Cd_1–x S, Hg _x Cd_1–x S, Hg _x Cu_1–x S, Cd _x Mn_1–x S, Hg _x Mn_1–x S, Hg _x Cd_1–x S, and Mn _x Zn_1–x S) were similarly obtained by reaction of mixtures of the metal salts with H₂S. The organosol of Zn_0.5Cd_0.5S contained particle with two particle size distributions centered at 6.5 nm and 29 nm, as revealed by Ar laser-scattering analysis. The metal sulfides are recovered by addition of Et₂O to the organosols. Zn _x Cd_1–x S thus obtained shows magnetic susceptibility in the range 0.5×10^–6–2.3×10^–6 emug^–1 depending on thex value. Addition of polymers to the organosols affords semiconducting films of metal sulfide-polymer composites.     

New stereoselective syntheses of cis- and trans-2-methyl-4-arylpiperidines

A stereoselective approach has been developed for the synthesis of cis- and trans-2-methyl-4-arylpiperidines from a common intermediate. The Ni-catalyzed hydrogenolysis of N-Boc-2-methyl-4-aryl-4-piperidinols, obtained by addition of organometallic reagents on N-Boc-2-methyl-4-piperidone, afforded the trans derivatives with up to 95% selectivity whereas the corresponding cis isomers were obtained in the presence of palladium catalysts.     

Ni-B和Ni-Ce-B超细非晶态合金的退火晶化及其催化性能

 采用XAFS,XRD和DTA方法研究了Ni－B和Ni－Ce－B超细非晶态合金在退火过程中的结构变化及其结构与催化性能的关系．活性结果表明,在退火温度为623K时,Ni－B和Ni－Ce－B样品的苯加氢催化反应转化率最高,分别为63％和81％,0．3％Ce的掺入提高了Ni－Ce－B的催化活性．DTA结果表明,Ni－B超细非晶态合金在598和653K有两个晶化峰,而Ni－Ce－B样品有548,603,696和801K四个晶化峰．XAFS和XRD结果进一步说明,在573K退火时,Ni－B样品晶化生成晶态Ni3B和纳米晶Ni,此时Ni－Ce－B仅有少量晶态Ni3B生成．在673K退火时,Ni－B样品中的Ni3B开始分解生成晶态Ni,同时纳米晶Ni聚集并形成大颗粒晶态Ni,而Ni－Ce－B样品晶化生成晶态Ni3B和纳米晶Ni．在773K和更高的温度退火处理后,Ni－B样品中Ni的局域环境结构与金属Ni箔基本一致,但Ni－Ce－B样品晶化生成的Ni晶格有较大畸变,同时Ni3B并未分解．说明0．3％的Ce对提高Ni－Ce－B样品的稳定性有显著作用．本文首次报道了Ni－B和Ni－Ce－B超细非晶态合金中苯加氢催化活性中心为纳米晶Ni和类似于金属Ni的Ni－B非晶态合金．     

Lu2O3对球形Ni(OH)2高温充放电性能的影响

为了改善镍电极的高温充电效率，采用机械混合的方式将球形Ni(OH)2与不同比例的Lu2O3混合后制成粘结式镍正极。充放电测试、循环伏安和XRD等实验结果表明，掺杂Lu2O3后镍电极的析氧过电位明显提高，高温充电效率得到了很大改善，在充电后的电极中β-NiOOH生成；而且Lu2O3的掺杂比例对镍电极的高温性能在不同的充放电倍率下有不同程度的影响，3．5％是最好的掺杂比例，掺杂对高温小电流充电效率的改善作用要大于高温大电流充电。     

Organonickel σ-Complexes—Key Intermediates of Electrocatalytic Cycles

Electrochemical reduction of nickel complexes with 2,2-bipyridyl in the presence of ortho-substituted aromatic bromides or white phosphorus leads to the formation of highly reactive organonickel -complexes that are capable of selectively reacting with diverse substrates with the formation of cross-association products. Mechanisms of electrocatalytic processes involving organic halides, chlorophosphines, white phosphorus, and nickel complexes with 2,2-bipyridyl are studied by the cyclic voltammetry and preparative electrolysis methods. Key intermediates of processes that occur in metallocomplex catalysis are determined.     

Preparation and Characterization of N-4-Nitrophenyl-L-prolinol Nanocrystals in Sol-Gel Matrices

Organic nanocrystals of N-4-nitrophenyl-l-prolinol (NPP) have been grown in sol-gel matrices prepared from silicon alkoxide precursors. Our process is based on the control of the nucleation and growth kinetics of the dye in the pores of dense gels. Nanocomposites gel-glasses are obtained with a high optical quality due to the small size of the nanocrystals (10-20 nm). Differential scanning calorimetry experiments evidenced clearly the melting point of NPP nanocrystals, which is registered 51°C above that of NPP powder. Micro-Raman and solid state NMR spectroscopies allowed us to demonstrate that our nanocrystallization process does not chemically modify NPP molecules. We specified also the nature of interactions existing between the NPP nanocrystals and the xerogels. These strong interactions, which explain the important increase of the melting point of the nanocrystals in comparison to the NPP powder, are hydrogen bonds between nitro groups of NPP and uncondensed silanol functions of the silicate network.     

泡沫镍载碳化钨催化剂上的析氢反应

结合直接化学还原法和交替微波法制备了泡沫Ni载Ni-WC催化剂,用X射线衍射、扫描电镜和透射电镜对催化剂进行了表征,研究了其析氢电催化性能.结果表明,在相同条件下,泡沫Ni载Ni-WC催化剂的析氢起始电位与泡沫Ni相比降低了60 mV左右.电解质浓度和温度对泡沫Ni载Ni-WC催化剂的析氢电催化活性有很大影响.     

Study on the anodic reaction of Ni in an alkaline solution by transient pH detection based on scanning electrochemical microscopy (SECM)

The anodic reaction of Ni in an alkaline solution was studied by the tip–substrate voltammetry mode of scanning electrochemical microscopy (SECM) and cyclic voltammetry (CV). A platinum microdisc electrode was selected as the tip electrode, which functioned as a pH sensor with transient response capability. The pH value of the solution near the Ni electrode surface varied while the Ni substrate oxidation reaction occurred, and the pH variation could be detected by the tip faradic current. The cyclic voltammogram results showed that two types of hydroxides: i.e. α‐Ni(OH)₂ and β‐Ni(OH)₂ were formed during Ni oxidation in the lower potential region. In the proceedings of α‐Ni(OH)₂ → γ‐NiOOH and β‐Ni(OH)₂ → β‐NiOOH, the process of OH^? concentration decrease in the solution was ahead and behind of electron transfer in the solid phase, respectively. These results indicate that the OH^? adsorption process occurs as an elementary step in the former reaction and the H⁺ diffusion process from the inner to the outer layer of the solid phase occurs as a subsequent step in the latter reaction. The results also revealed that the oxide film on the Ni surface has a two‐layer structure. The real potential of the oxygen evolution reaction (OER) on the Ni surface with different cycles is also analyzed in the paper. Copyright © 2007 John Wiley & Sons, Ltd.     

Synthesis and Characterization of Lead Sulfide Nanoparticles in Zirconia-Silica-Urethane Thin Films Prepared by the Sol-Gel Process

PbS nanocrystals (NCs) ranging between 4–8 nm were incorporated into Zirconium-Silica-Urethane (ZSUR) matrix obtained by the sol-gel method. The sizes of the particles were controlled by temperature treatment and by concentration of PbS in ZSUR matrix. The sizes of PbS NCs were determined by TEM measurements. The quantum size effect could also be extracted from optical absorption and photoluminescence spectra. The new matrix allows incorporation of up to 40% PbS forming a characteristic structure of dendrite by reacting lead acetate with ammonium thiocyanate in sol-gel matrix. The sol precursors of the matrix for Zirconium-Silica-Urethane contained zirconium oxide (ZrO₂) matrix solution, tetramethoxysilane (TMOS), 3-glycid oxypropyl trimethoxysilane (GLYMO) and polyethylene urethane silane (PEUS) synthesized separately. The ZrO₂ matrix solution was obtained from zirconium n-tetrapropoxide in propanol and acetic acid was used as a chelating agent to stabilize the zirconium oxide precursor.     

The influence of the sacrificial anode nature on the mechanism of electrochemical arylation and alkylation of white phosphorus

The material of the sacrificial anode has a substantial effect on the nature and yield of the target products of electrochemical phosphorylation of organic halides by white phosphorus in the presence of the nickel complexes with 2,2"-bipyridine. The use of the zinc anode results in the products with tricoordinated phosphorus, viz., triorganylphosphines, the reaction on the aluminum anode affords triorganylphosphine oxides, and the presence of Mg²⁺ ions in the reaction mixture provides the transformation of white phosphorus into cyclic phosphines (PhP)₅.