Acoustic absorption in aqueous potassium phosphate

Measurements of acoustic absorption and velocity as a function of frequency and concentration in KH₂PO₄–K₂HPO₄ buffers at 4°C and pH 5-7 are reported. The dependence of the observed acoustic relaxation parameters on concentration is consistent with that to be expected from perturbation of a monomer-dimer equilibrium with an equilibrium constant [for 2H₂PO ₄ ^– (H₂PO₄)₂ ^2–] of 0.21 M^–1, a bimolecular rate constant of 5×10⁸ M^–1-sec^–1 and a standard volume change of –5 cm³ mole. The equilibrium constant for H₂PO ₄ ^– + HPO₄ ^2–H₃(PO₄)₂ ^3– is estimated to be 0.7 M^–1.     

自由体积与亲水性对环氧涂层防护性能的影响

报道了涂层聚合物自由体积和亲水性对涂层腐蚀防护性能影响的初步研究结果.实验表明,相对于自由体积,树脂的亲水性是决定树脂吸水率的更主要因素.低亲水性涂层腐蚀防护性能的提高主要源自到达涂层/金属界面的水量的显著降低.但由于采用活性酯固化的环氧树脂涂层中水通道的尺寸相对较大,水合离子扩散较容易,因此该类涂层覆盖下的金属基体被润湿部分的腐蚀趋势反而较一般涂层为大.     

CsxH3-xPW12O40的孔结构

Ｎ２静态吸附容量法的测定结果表明，磷钨酸铯盐（ＣｓｘＨ３－ｘＰＷ１２Ｏ４０）的孔窝和孔分布与ｘ值的大小相关。ｘ〈１．５的ＣｓｘＨ３－ｘＰＷ１２Ｏ４０孔容相近，孔分布近似；当ｘ〉１．５时，ＣｓｘＨ３－ｘＰＷ１２Ｏ４０的孔主要是孔径小于１０ｎｍ的中孔和微孔，平均孔径及孔容随ｘ的增加而增大。ＳＥＭ和ＴＥＭ的观测结果表明，ＣｓｘＨ３－ｘＰＷ１２Ｏ４０的孔是微细粒子堆积留下的空隙孔，可能不存在晶内孔。     

Molar volumes and ion pairing of lithium halides in alcohols

The concentration dependence of the apparent molar volumes of lithium halides (and electrolytes in general) in alcohols (and solvents permitting association in general) is, in the first instance, due to changes in the degree of association and to the inherent difference between the apparent molar volumes of the ions and of the ion pairs. Previous publications on the molar volumes of electrolytes in organic solvents, disregarding altogether ion pairing, appear to be incorrect. Data from the literature for lithium chloride and lithium bromide in normal primary alcohols and several branched alcohols from C₁ to C₈ and data from our laboratory for lithium halides in 1-hexanol and 2-ethyl-1-hexanol served for the determination of φ _V and φ _E . Electrical and structural contributions to the values of these functions for the ions and for the ion pairs are discussed.     

Measurement of moisture in grains at extreme temperatures

Summary This research has demonstrated that the dielectric method can be used successfully for grain moisture measurements for diverse grain types over wide ranges of temperatures if the grain moisture content is below certain (grain-specific) threshold values. These high-moisture limits were estimated. Optimum temperature correction coefficients for 149 MHz moisture measurements were determined for grain samples at different moisture levels. This information should be very helpful for grain moisture meter manufacturers and for moisture meter users who need to determine grain moisture contents at temperature extremes to be able to market grain more efficiently.     

A practical approach to transferring linear gradient elution methods

Attempts to theoretically address the problems involved in transferring linear gradient elution methods have been somewhat ad hoc due to the simplifying assumptions usually made in conventional gradient elution theory. Until now, all equations based on the k* parameter of linear gradient elution theory used as the basis for predicting the separation selectivity have not explicitly included the effect of the dwell volume (VD). Using an exact equation for predicting k*, that is, one which fully accounts in an a priori fashion for VD, we find a set of simple yet exact equations which unequivocally must be satisfied to transfer an optimized linear gradient elution method from one system (column or instrument or both) to another. These relationships absolutely mandate that a change in the instrument dwell volume requires a proportional change in the column volume; in turn, a change in the column volume requires a proportional change in the flow rate and/or gradient time to maintain a constant gradient steepness. Although we are not the first to suggest these guidelines, this work provides a complete theoretical foundation for these exact guidelines for the maintenance of gradient selectivity for the case of transferring a linear gradient elution method between different columns packed with the same particles and/or between different instruments.     

Interpretation of the Metabolic Enthalpy Change, ΔHmet,Calculated for Microbial Growth Reactions in Soils

The microcalorimetric method was used to calculate the metabolic enthalpy change per mol of glucose degraded by soil microorganisms, ΔH _met. This parameter has been calculated by microcalorimetry for many organic, inorganic and biochemical reactions, but there is only some information about its quantification for microbial growth reactions in soils. Values of ΔH _met were calculated for different soil samples collected in Galicia (Spain) and Campinas (Săo Paolo, Brazil). Exponential microbial growth was stimulated in all soil samples by the addition of glucose and power-time curves were recorded. Results showed changes in the values of ΔH _met calculated for all the soil samples, suggesting a dependence of this value with the microbial growth rate constant, with the percentage of growth, with the initial number of microorganisms of soil samples, with the quantity of glucose added and with the strain of bacteria growing in soil. The interpretation of variations of ΔH _met provides important qualitative and quantitative information. It reports data that allow to interpret from a qualitative point of view, the increase in biomass as a consequence of the degradation of the organic matter in soil, to understand changes in the percentages of soil organic matter and to know if the microbial population growing in differential soil samples is homogeneous. Therefore, to report that value would be very important in ecological studies, but beforehand, it is necessary to solve some problems that can appear in the experiments done to make the quantification . This revised version was published online in August 2006 with corrections to the Cover Date.     

Synthesis and properties of 7,7-bis(heteroazulen-3-yl)-8,8-dicyano-1,4-quinodimethanes

The synthesis and properties of a novel type of 7,7-bis(heteroazulen-3-yl)-8,8-dicyano-1,4-quinodimethanes (9a-c) are studied. The synthetic method is based on a TFA-catalyzed electrophilic aromatic substitution on the heteroazulenes with 4-(dicyanomethyl)benzaldehyde to afford the corresponding methane derivatives, followed by oxidative hydrogen abstraction with DDQ. The polarization of 9a-c is evaluated by the inspection of their ¹³C NMR and IR spectra. Based on the investigation of the UV-Vis spectra of 9a-c and protonated cations 10a-c, conformational changes of the heteroazulene-moiety and (dicyanomethyl)phenyl group are suggested. In the CV measurements of 9a-c, two reversible reduction waves are observed, indicating the stabilizing ability of heteroazulenes toward the corresponding radical and anion species. Furthermore, 9a-c exhibit two irreversible oxidation waves, which suggest a conformational change in the radical cation during the redox process. The conformational change is rationalized on the basis of the MO calculations.     

Heat capacity of alcohols in aqueous solutions in the temperature range from 5 to 125°C

Using a precise technique of scanning microcalorimetry the heat capacity differences between water and dilute aqueous solutions of ethanol, n-propanol, n-butanol and n-pentanol were measured from 5 to 125°C and the partial molar heat capacities of these substances in water were determined. It was found that the heat capacity increment for alcohol disolved in water is proportional to the number of the-CH ₂ ^– groups and decrease with a temperature increase. The heat capacity increment of hydration of non-polar groups is shown to be positive and large at room temperature and decreases in magnitude as the temperature increases. In contrast, the heat capacity increment of hydration of polar groups is negative at room tempreature and increases as the temperature increases. From the temperature dependence of the heat capacity increment one can assume that the water molecules solvated by the non-polar groups of the alcohols behave in a non-cooperative manner.     

Volume and compressibility changes of complex formation between 18-Crown-6 and NaCl,KCl, and CsCl in water

The apparent molal volumes and compressibilities of NaCl, KCl, and CsCl in mixtures of 18-Crown-6 and water have been calculated from density and speed-of-sound measurements at 25°C. The partial molal volumes and compressibilities of the salts when all cations have formed complexes with 18-Crown-6 molecules have been evaluated. The sign and magnitude of the volume and compressibility changes of complex formation strongly suggest that the charge of the cation becomes very effectively screened by the crown ether.