混合交通OD分布与随机平衡分配组合模型及算法

基于我国城市混合交通的特点,借助于Logit选择模型,建立了混合交通OD分布与随机平衡分配组合的数学规划模型,证明了模型最优解的等价性与唯一性,同时给出了算法和算例.     

在Ni系ABO3和A2BO4型复合氧化物催化剂上NO吸附性能的研究

合成了具有钙钛石和类钙钛石结构的复合氧化物ＬａＮｉＯ３，Ｌａ０．１Ｓｒ０．９ＮｉＯ３，Ｌａ２ＮｉＯ４和ＬａＳｒＮｉＯ４。考察了它们对ＮＯ的吸附和ＮＯ直接分解反应的催化性能，结合比表面测定，化学分析，ＸＲＤ和ＮＯ－ＴＰＤ对催化剂的表征结果，探讨了该系列复合氧化物对ＮＯ的吸附规律。     

还原温度对超细K－Co－Mo催化剂合成低碳醇性能的影响

 用溶胶－凝胶法合成了K－Co－Mo催化剂．样品经不同温度还原后，用于低碳醇的合成．XRD和HRTEM结果表明，样品是超细粒子，粒子尺寸为2～5nm．考察了催化剂的还原温度和反应条件对催化剂性能的影响．实验结果表明，还原温度对催化剂的活性有较大的影响，最佳还原温度为500℃．最佳反应温度范围为310～330℃．升高压力和空速可以提高醇的收率和选择性．在空速14400h－1，压力6．0MPa和温度310℃的条件下，醇的选择性为55．8％，收率为520．0g／（kg·h），MeOH／C2＋OH为0．27．催化剂稳定性良好，在200h的寿命实验中，活性基本不变．与文献中催化剂相比，超细K－Co－Mo催化剂对合成醇具有较高的活性和选择性，尤其是对C2＋OH的合成明显高于其他合成醇催化剂体系．     

耐硫催化剂上合成混合醇的研究

通过改进制备方法和添加助剂，用浸渍－热分解法制得了具有高活性和高选择性的MoS2-K-C型耐硫低碳混合醇催化剂。在8.0-11.0MPa,290-340℃，6000-12000h^-1,H2 S 浓度为100ppm 左右的条件下，在直流反应器中对催化剂进行了性能测试，结果表明，醇得率为0.14-0.47gROH(gcat·h)^-1，选择性为89-98%。同时，考察了操作条件对催化剂性能的影响。1042h的试验，证明催化剂具有很好的稳定性。     

Characterization and catalytic behavior of La2 - x (Sr, Th)xCuO4 ± λ in reaction NO+CO

Two mixed oxide systems La₂-_xSr_xCuO_{4± λ} (0.0⩽x⩽1. 0) and La_2-xTh_xCuO_{4± λ} (O. O⩽x⩽ 0.4) with K₂NiF₄ structure were prepared by varyingx values. Their crystal structures were studied by means of XRD and IR spectra. The average valence of Cu ion at B site, nonstoichiometric oxygen (λ) and the chemical composition in the bulk and on the surface of the catalysts were measured by means of chemical analysis and XPS. The catalytic behavior in reaction CO+NO was investigated under the regular change of average valence of Cu ion at B site and nonstoichiometric oxygen (λ). Meanwhile, the adsorption and activation of the small molecules NO and the mixture of NO+CO over the mixed oxide catalysts were studied by means of MS-TPD. The catalytic mechanism of reaction NO+CO over these oxide catalysts were proposed; and it has been found that, at lower temperatures the activation of NO is the rate determining step and the catalytic activity is related to the lower valent metallic ion and its concentration, while at higher temperatures the adsorption of NO is the rate determining step and the catalytic activity is related to the oxygen vacancy and its concentration. Project supported by the National Natural Science Foundation of China.     

Structural and magnetic investigations of the mixed-valence Fe(II,III) two-dimensional layer complex, [Fe2(II) Fe2(III)(HCOO)10(C6H7N)6]n.

The structure of the complex, [Fe2(II)Fe2(III)(HCOO)10(C6H7N6)n, (1) exhibits a neutral two-dimensional layer network of alternating iron(II) and iron(III) ions, bridged equatorially by formate groups. All iron atoms are octahedrally coordinated, with iron(III) coordinating axially to one gamma-picoline and one formate group, while the iron(II) centers interact axially with two gamma-picoline groups, above and below the layer plane. The complex crystallizes in the triclinic space group P1 at all studied temperatures [at 120 K, the cell dimensions are: a = 10.228(1), b = 12.071(1), c = 12.072(1) A, alpha = 89.801(2), beta = 71.149(2), gamma = 73.371(2) degrees]. An intralayer antiferromagnetic exchange interaction of J = -2.8 cm(-1) between iron(II) and iron(III) was observed in the magnetic studies. Decreasing the temperature to close to 20 K causes a magnetic-ordering phenomenon to occur and a low-temperature phase with a long-range antiferromagnetic spin orientation appears. The magnetic phase transition was confirmed by M?ssbauer spectroscopic studies at temperatures above and below the critical temperature. Structural information of 1 from synchrotron X-ray diffraction data collected at room temperature and 16 K suggests that the antiferromagnetic ordering is caused by an enhanced pi-pi interaction between chi-picoline groups from adjacent layers.     

Ti-Si复氧化物载体对金催化剂上丙烯环氧化的影响

 以TiCl4和SiCl4为原料,采用水解和非水水解溶胶-凝胶两种方法制备了一系列不同Ti含量的Ti-Si复氧化物载体,继而用沉积-沉淀法制得载金催化剂. 采用X射线衍射、紫外-可见漫反射光谱、 N2吸附和高分辨透射电镜对催化剂进行了表征,并考察了催化剂在氢气和氧气存在下的丙烯气相环氧化催化性能. 研究表明,钛含量在6%～14%范围内时,两种方法制得的Ti-Si复氧化物均为无定形结构,但采用非水水解溶胶-凝胶法制得的载体比表面积较高. 以非水水解溶胶-凝胶法制备的钛含量10%的Ti-Si复氧化物为载体得到的载金催化剂表现出较高的活性和选择性,反应60 min时,丙烯转化率为5.7%, 240 min后降为3.3%, 环氧丙烷的选择性稳定于95%左右. 还考察了非水水解溶胶-凝胶的陈化时间和金沉积-沉淀溶液的pH值等对反应结果的影响.     

Construction of solid-liquid phase diagrams in ternary systems by titration calorimetry

Titration calorimetry was used to construct the solid-liquid equilibrium line in ternary systems containing the solute and an aqueous mixed solvent by measuring the heat of dissolution of the solid solute during successive additions of the liquid solvent. The plot of cumulated heats versus the mole ratio, n_solvent/n_solute, yields two (almost) linear increases of different slopes. These two lines represent successively the enthalpy of dissolution then the enthalpy of dilution of the medium; their intersection gives the solubility and the enthalpy of dissolution of the solute. Phase diagrams have been established over the whole concentration range for o-anisaldehyde, 1,3,5-trimethoxybenzene and vanillin, in water + methanol, +ethanol, or +n-propanol at 303, 313 and 318 K.     

Photoelectron spectroscopy of mono and binuclear iron and chromium cyclooctatetraene complexes

The ultraviolet photoelectron spectra of mono and binuclear cyclooctatetraene (COT) complexes (CO)₃FeCOT (I) [(CO)₃Fe]₂COT (II), CpCrCOT (Cp: 1,3 cyclopentadienyl) (III) and (CpCr)₂COT (IV) are reported. The interpretation of the low energy part of the spectra is followed by a discussion concerning the metal–ligand (COT) and metal–metal interactions. The calculated gas phase structure of CpCrCOT is presented and its main features are discussed.