微乳液法合成LiFePO4 / C正极材料及其电化学性能

本文采用微乳液方法合成了纳米LiFePO₄ / C正极材料。制备样品分别用XRD和SEM进行表征，充放电测试其电化学性能。600 ℃制备样品为单一物相，平均粒径90 nm，在室温2.0～4.0 V (vs Li) 放电电压范围和15 mA·g^-1放电速率下，首次放电容量达到159 mAh·g^-1。制备样品同样展现良好的循环性能。在15 mA·g^-1速率下40次循环后，制备样品放电容量仍保持首次放电容量的98.9%。优异的电化学性能得益于样品颗粒的纳米尺寸、均匀分布以及表面碳层包覆提高了活性材料的电子电导率。     

Effect of lithium oxide dopants on electrophysical and sorption properties of zinc oxide

The effects of lithium oxide dopants (0.5–0.8 at. % Li) on the electrophysical and sorption properties of ZnO were studied in the temperature range from 150 °C to 410 °C. The introduction of lithium increases the activation energy of the conductivity of ZnO, decreases its conductivity, and increases the amount of S0₂ sorbed. Two forms of chemisorbed SO₂ (donor and acceptor) are observed on the surface.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1096–1100, May, 1996.     

冠醚B15C5萃取分离锂同位素的阴离子效应

本文研究了B15C5冠醚萃取锂盐时,不同阴离子对体系的同位素分离效应的影响。结果表明,阴离子在冠醚萃取过程中不仅对萃取络合物的稳定性有显著影响,而且阴离子半径及软度越大时,萃取体系的锂同位素分离系数(α_(LI))也越大。     

Direct measurement of gas solubility and diffusivity in poly(vinylidene fluoride) with a high-pressure microbalance

We present solubility and diffusion data for the gases methane and carbon dioxide in the polymer poly(vinylidene fluoride). The polymer was cut from extruded piping intended for use in offshore oil and gas applications. Measurements were carried out using a purpose-built high-pressure microbalance. These properties were determined in the temperature range 80-120 °C and in the pressure range 50-150 bar for methane and 20-40 bar for carbon dioxide. In general, good agreement was obtained for similar measurements reported in the literature. Solubility follows a Henry’s law (linear) dependence with pressure. Diffusion coefficients for each of the gases in the polymer were also measured using the balance. Activation energies for diffusion and heats of solution for the two gases in the polymer were also determined.     

Li_3PO_4包覆LiMn_2O_4正极材料的结构表征和电化学性能

采用共沉淀法在尖晶石LiMn2O4颗粒表面包覆Li3PO4.XRD、SEM研究结果表明,包覆后的材料仍为尖晶石结构,粒径均匀.电化学性能测试表明,Li3PO4包覆层的存在,减少了正极材料与电解液的直接接触,抑制了高温下电解液对LiMn2O4材料的侵蚀,从而有效改善了高温下材料的循环性能.在40℃时,包覆样品的比容量衰减率都低于未包覆样品,其中包覆1%Li3PO4的样品的初始比容量为110.4mAh/g,50次循环后比容量为84.1mAh/g.     

RExOy.nH2O对氟离子的吸附性能

La、Ce等稀土水含氧化物对阴离子的吸附性早有研究「‘－‘1，但从混合轻稀土氯化物制得的水合氧化物吸附F一的研究报道较少．为探讨难溶金属水合氧化物的除氟性能，本文以混合轻稀土氯化物为原料，制得其水含氧化物（RExOy·nH。O），采用高聚物造粒，研究了粒状RExOy·nH。O对F一的吸附性能及吸附机理．所用混合轻稀土氯化物由包头钢铁稀土公司提供，其主要组成（以氧化物计）为：CeO。（50％）、Nd。O3（25％）、La。O。（15％）、P36Oll（8％）．聚丙烯睛分子量为（2．5～5）X10‘．其它试剂为分析纯．RExO．·nH。O参照文…     

Synthesis of New Lithium Ionic Conductor Thio-LISICON—Lithium Silicon Sulfides System

The new lithium ionic conductors, thio-LISICON (LIthium SuperIonic CONductor), were found in the ternary Li₂S-SiS₂-Al₂S₃ and Li₂S-SiS₂-P₂S₅ systems. Their structures of new materials, Li_4+xSi_1−xAl_xS₄ and Li_4−xSi_1−xP_xS₄ were determined by X-ray Rietveld analysis, and the electric and electrochemical properties were studied by electronic conductivity, ac conductivity and cyclic voltammogram measurements. The structure of the host material, Li₄SiS₄ is related to the γ-Li₃PO₄-type structure, and when the Li⁺ interstitials or Li⁺ vacancies were created by the partial substitutions of Al³⁺ or P⁵⁺ for Si⁴⁺, large increases in conductivity occur. The solid solution member x=0.6 in Li_4−xSi_1−xP_xS₄ showed high conductivity of 6.4×10^-4 S cm⁻¹ at 27°C with negligible electronic conductivity. The new solid solution, Li_4−xSi_1−xP_xS₄, also has high electrochemical stability up to ∼5 V vs Li at room temperature. All-solid-state lithium cells were investigated using the Li_3.4Si_0.4P_0.6S₄ electrolyte, LiCoO₂ cathode and In anode.     

3-Cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines in the synthesis of substituted 3-(aminomethyl)pyridines

The reactions of substituted 3-cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines with lithium aluminum hydride in anhydrous diethyl ether afforded the corresponding 3-aminomethyl derivatives, which were used in the synthesis of the corresponding amides.     

Application of the chiral base desymmetrisation of imides to the synthesis of the alkaloid jamtine and the antidepressant paroxetine

The synthesis of the alkaloid jamtine and the antidepressant paroxetine have been addressed by a strategy involving asymmetric desymmetrisation of prochiral imides by a chiral lithium amide base. A short reaction sequence, starting with a cyclohexane fused succinimide, led to the structures originally reported for the alkaloid jamtine and its derived N-oxide. The structures synthesised are shown not to correspond with those originally reported. A second sequence involves desymmetrisation of a 4-arylglutarimide, and provides a short enantioselective synthesis of the drug substance paroxetine.     

Lithium bromide in acetonitrile: Thermodynamics,theory, and simulation

A variety of methods has been used for the study of lithium bromide solutions in acetonitrile yielding by their combination reliable information on different levels of approximation. Osmotic coefficients based on precise vapor pressure measurements are reproduced by CM (chemical model) and HNC (hypernetted chain) calculations and by BD (brownian dynamics) simulations. The results of neutron scattering experiments are treated with the help of HNC and BD methods. Hartree-Fock calculations on isolated LiBr pairs and solvated lithium ions yield reliable particle distances and reveal the geometry of the lithium solvation sphere.