Continuous melting and ion chromatographic analyses of ice cores

A new method for determining concentrations of organic and inorganic ions in ice cores by continuous melting and contemporaneous ion chromatographic analyses was developed. A subcore is melted on a melting device and the meltwater produced is collected in two parallel sample loops and then analyzed simultaneously by two ion chromatographs, one for anions and one for cations. For most of the analyzed species, lower or equal blank values were achieved with the continuous melting and analysis technique compared to the conventional analysis. Comparison of the continuous melting and ion chromatographic analysis with the conventional analysis of a real ice core segment showed good agreement in concentration profiles and total amounts of ionic species. Thus, the newly developed method is well suited for ice core analysis and has the advantages of lower ice consumption, less time-consuming sample preparation and lower risk of contamination.     

Comparison of three post-column reaction methods for the analysis of bromate and nitrite in drinking water

Three post-column ion chromatographic methods (i.e., a sodium bromide–sodium nitrite method, an o-dianisidine method, and a potassium iodide–ammonium heptamolybdate method) were compared for bromate and nitrite analysis. Also, the effect of direct mixing of the reagents without ion suppressors for the sodium bromide–sodium nitrite method and the potassium iodide–ammonium heptamolybdate method was investigated. For the analysis of bromate, the three methods showed similar method detection limits (0.17–0.24 μg/l) with pneumatic reagent delivery systems. Direct reagent mixing achieved comparable detection limits to the suppressor configuration. The three methods are also compatible with conductivity detection. When used in combination with conductivity detection, this compatibility allows simultaneous analysis of bromate, nitrite, and other common ions in drinking water, such as bromide. It was found that the o-dianisidine method achieves μg/l-level detection of nitrite and bromate with a simpler configuration than the potassium iodide–ammonium heptamolybdate method, while the sodium bromide–sodium nitrite method was not sufficiently sensitive for nitrite analysis at the μg/l level.     

Review of the methods of the US Environmental Protection Agency for bromate determination and validation of Method 317.0 for disinfection by-product anions and low-level bromate

In recent years several methods have been published by the United States Environmental Protection Agency (EPA) which specify bromate as a target analyte. The first of these was EPA Method 300.0. As technological improvements in ion chromatographic hardware have evolved and new detection techniques have been designed, method detection limits for bromate have been reduced and additional procedures have been written, including EPA Method 300.1, 321.8 and, most recently, EPA Method 317.0. An overview of the evolution of these bromate methods since 1989 is presented. The focus is specific to each of these respective procedures, highlighting method strengths, weaknesses, and addressing how these methods fit into EPA’s regulatory agenda. In addition, performance data are presented detailing the joint EPA/American Society for Testing and Materials multilaboratory validation of EPA Method 317.0 for disinfection by-product anions and low-level bromate.     

New block-grafted anion exchanger for environmental water analysis by ion chromatography

The IonPac AS14A is a recently developed stationary phase that was produced using a new block-grafting technique, which enables the preparation of high-water-content anion exchangers with excellent peak shape and good chromatographic efficiency. The performance of this column for the analysis of inorganic anions was compared to that obtained using an IonPac AS4A column, which is specified in US Environmental Protection Agency Method 300.0, in addition to another commonly used alternative; the AS14 column. The AS14A column is available in two different formats; 250×4 mm I.D. (7.0 μm diameter particle) and 150×3 mm I.D. (5.5 μm diameter particle). The IonPac AS14A (in 4 mm I.D. format) was found to provide similar performance to the AS14 column with increased peak efficiency and better pH stability and is a suitable alternative for the analysis of anions in moderate- to high-ionic-strength samples. The IonPac AS14A (in 3 mm I.D. format) provides comparable run times to the AS4A column with better overall peak selectivity and improved fluoride resolution, hence this column would be a suitable column to substitute in place of either the AS4A or AS14 columns for the analysis of inorganic anions in low- to moderate-ionic-strength environmental waters. The AS14A column used with an Atlas electrolytic suppressor provides equivalent method detection limits to those obtained when using a micromembrane suppressor but with the operational convenience of a self-regenerating suppressor.     

The alkali metal cation effect on the surface-enhanced Raman spectra of phosphate anions adsorbed at silver electrodes

The interaction of adsorbed phosphate anions with alkali metal cations at the Ag|aqueous solution interface has been investigated by surface-enhanced Raman spectroscopy (SERS). Formation of ion pairs at the interface was evident from the cation-induced perturbations in the SER spectra of anions. The frequency of the external vibration, silver–oxygen (Ag---O′), was not sensitive to the nature of cation, while the relative intensity of this mode was cation-dependent and was explored as a sensitive probe for the monitoring of coadsorption of ions at the interface. From the internal phosphate vibrations, both asymmetric modes, δ_as(PO) and ν_as(PO), were found to be the most sensitive to the nature of the cation. At a relatively positive potential (0.00 V vs. Ag | AgCl) the spectral parameters for the Cs⁺ and K⁺ cations were very similar indicating the same bonding type with anions. A more inhomogeneous chemical environment for the phosphate oxygen atoms was detected in the case of Na⁺ and Li⁺ cations. An increase in ν_as(PO) frequency by ca. 10 cm⁻¹ was the characteristic spectral signature for the interaction of phosphates with Li⁺. The formation of water-shared ion pairs at the interface was suggested based on the absence of splitting in the ν_as(PO) mode and the previously observed frequency sensitivity of this band to solvent H₂O substitution by D₂O. At negative potential (−0.80 V), a stabilization effect of Cs⁺ on the phosphate adlayer was detected based on the twofold increase in intensity of the ν(Ag---O′) mode compared with Li⁺. Splitting of the ν_as(PO) mode suggested the contact interaction of anions with specifically adsorbed Cs⁺ cations.     

Mechanism of protection of adenosine from sulphate radical anion and repair of adenosine radicals by caffeic acid in aqueous solution

The photooxidation of adenosine in presence of peroxydisulphate (PDS) has been studied by spectrophotometrically measuring the absorbance of adenosine at 260 nm. The rates of oxidation of adenosine by sulphate radical anion have been determined in the presence of different concentrations of caffeic acid. Increase in [caffeic acid] is found to decrease the rate of oxidation of adenosine suggesting that caffeic acid acts as an efficient scavenger of SO ₄ ^• and protects adenosine from it. Sulphate radical anion competes for adenosine as well as for caffeic acid. The quantum yields of photooxidation of adenosine have been calculated from the rates of oxidation of adenosine and the light intensity absorbed by PDS at 254 nm, the wavelength at which PDS is activated to sulphate radical anion. From the results of experimentally determined quantum yields (Φ_expt1) and the quantum yields calculated (Φ_cal) assuming caffeic acid acting only as a scavenger of SO ₄ ^• show that Φ_expt1 values are lower than Φ_expt1 values. The ǵf values, which are experimentally found quantum yield values at each caffeic acid concentration and corrected for ₄ ^• scavenging by caffeic acid, are also found to be greater than Φ_expt1 values. These observations suggest that the transient adenosine radicals are repaired by caffeic acid in addition to scavenging of sulphate radical anions.     

Nitrate and chloride transport through a smart membrane

To develop membranes having ionic selective properties under control of external stimuli is a challenge of the membrane and material scientific community. Conducting polymers swell and shrink under electrochemical control, so they are good candidates to prepare such smart membranes. The ionic transport through a new free-standing polypyrrole film working as a membrane in a diffusion cell was studied. The driving forces were transversal electric fields or concentration gradients across the film. The obtained ionic conductivity was dependent on both the electrolyte nature and concentration, as well as on the oxidation degree of the film, which was controlled by the applied external electric potential. Reverse and continuous changes of up to one order of magnitude on the transversal ionic conductivity are obtained when the membrane is in stationary oxidation states attained by polarisations at a constant potential in the range between −0.6 V and +0.4 V, respectively. A prevalent conductivity of anions (t₋ = 0.94) was obtained from Donnan potential measurements. The experimental results indicate that the oxidised film behaves as a nanoporous membrane highly permeable to nitrate ions, while the rejection of these ions is very high in the reduced film. The free-standing polypyrrole film works then as a smart membrane selective to nitrate ions under concentration gradient.     

Mechanism of the anionic polymerization of methyl methacrylate initiated by tetramethylammonium–triphenylmethide in tetrahydrofuran

A tetramethylammonium (TMA)–triphenylmethide (TPM) initiator generated in situ by the reaction of trimethyltriphenylmethylsilane with tetramethylammonium fluoride in tetrahydrofuran was found to have greater stability than the corresponding tetrabutylammonium or tetrahexylammonium derivatives. The predominant mode of degradation of TMA–TPM was found to be the TMA‐mediated methylation of TPM anions. The initiation of methyl methacrylate by TMA–TPM in tetrahydrofuran at ?78 °C was demonstrated to produce quantitative yields of poly(methyl methacrylate) with polydispersities of less than 1.1. Although the initiator efficiencies were low (9–40%) because of relatively slow initiation on the polymerization timescale, the initiation appeared to be rapid enough to give relatively narrow molecular weight distributions. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 237–244, 2004     

无机阴离子对镍-4-〔(5-氯-2-吡啶)偶氮〕-1,3-二氨基苯显色反应的作用机理及应用研究

被试的六种无机钠盐对Ni~(2-)-5-Cl-PADAB显色体系有不同程度的增敏作用,并能提高显色反应的选择性。初步探讨了无机阴离子对显色反应作用的机理。已成功地将Ni~(2-)-5-Cl-PADAB-NaBr体系用于废水中镍的测定。