An Oscillation Condition for an Electrode－separated Piezoelectric Sensor in Non－electrolyte Liquid

ＡｎＯｓｃｉｌｌａｔｉｏｎＣｏｎｄｉｔｉｏｎｆｏｒａｎＥｌｅｃｔｒｏｄｅ－ｓｅｐａｒａｔｅｄＰｉｅｚｏｅｌｅｃｔｒｉｃＳｅｎｓｏｒｉｎＮｏｎ－ｅｌｅｃｔｒｏｌｙｔｅＬｉｑｕｉｄＳＨＥＮＤａ－ｚｈｏｎｇ，ＨＵＡＮＧＭｉｎｇ－ｓｈａｎ，ＬＩＮＳｏｎｇ，Ｎ...     

SYNTHESIS OF LIQUID CRYSTALLINE POLYACRYLATES WITH THIOESTER AS BRIDGE-BOND

A new series of acrylates with the same mesogens containing thioester as bridge-bondwere synthesized, and the acrylates were characterized by H~1 NMR, IR and MS. Thepolymers were obtained by radical polymerization using AIBN as initiator. The monomersand polymers exhibit thermotropic-enantiotropic liquid crystalline behavior.     

基于脱乙酰基魔芋葡甘聚糖固定酶的葡萄糖传感器

制备了脱乙酰基魔芋葡甘聚糖(d-KGM)的溶胶-凝胶,用红外光谱表征了其脱乙酰基前后的结构转化.探讨了d-KGM溶胶-凝胶的制备条件对其成膜性能及酶固定化的影响.在此基础上将d-KGM用于电极表面葡萄糖氧化酶的固定,制备了相应的葡萄糖传感器,并对传感器的工作条件进行了优化.所制备的传感器灵敏度为240 nA/mmol/L,线性范围为0.1～8 mmol/L,表观米氏常数KM为19.6 mmol/L,稳定性好,寿命长.实验结果表明d-KGM是一种可用于生物传感器中酶固定化的优良材料.     

化学发光消耗型锰传感器

化学和生物发光是由化学反应产生的一种光辐射,不需要任何光源。又由于它们具有高灵敏度、宽线性范围和相对比较便宜的仪器等优点,因而在化学和生物传感器领域引起了广泛的兴趣。已用于H_2O_2、乳酸和胆固醇等多种生物活性物质的测定,但未见有金属离子传感器的报道。本文发展了一种新型的全固态模式的消耗型锰离子化学发光传感器。该传感器将除待测物外的所有化学发光反应试剂全部固定在阴离子交换树脂Amberlyst A-27上,于化学发光反应之前,将一定量化学发光试剂从固定化试剂柱上洗脱,与样品中的锰离子产生化学发光。已成功地应用于水样中痕量锰离子的测定。每个固定化试剂柱可连续使用100次以上。 1 实验部分 1.1 仪器和试剂 化学发光传感器由流动系统和检测系统两部分组成。其中流动系统主要由蠕动泵、六通阀、固定化试剂柱和流通池组成。检测系统由光电信增管、负高压、放大器和记录仪组成(图1)。     

新铌酸盐Ba5NdTi3Nb7O30的合成与介电性能

The New Niobate Ba₅NdTi₃Nb₇O₃₀ was synthesized by solid state reaction at 1250℃ for 48h. The crystal structure and dielectric properties of Ba₅NdTi₃Nb₇O₃₀ were determined by X-ray powder diffraction and dielectric measurements. The results show that Ba₅NdTi₃Nb₇O₃₀ belongs to ferroelectric phase of tetragonal tungsten bronze structure at room temperature with unit cell parameters: a=1.24424(4)nm, c=0.39476(2)nm, calculated density 5.719g·cm^-3. Ba₅NdTi₃Nb₇O₃₀ belongs to relaxor ferroelectrics. The phase transition temperature (T_c) of Ba₅NdTi₃Nb₇O₃₀ from ferroelectric to paraelectric is found to shift toward higher temperature side at higher fre-quency, and T_c is 90℃ at 1kHz. At room temperature, the dielectric constant (ε_r) and dielectric loss of Ba₅NdTi₃Nb₇O₃₀ decrease with the increase of frequency, and Ba₅NdTi₃Nb₇O₃₀ ceramic have high dielectric constant 489 at 1kHz.     

动力学—压电石英晶体传感器测定水中微量汞的研究

基于涂银压电石英晶体对ＣＮ＾－离子的灵敏响应，应用汞对六氰合铁酸钾与邻二氮杂菲反应的动力学催化作用，建立了动力学－ＰＱＣ传感器单面触液测定微量汞的新方法。研究了ＰＱＣ传感器对汞的响应机理，响应曲线，实验条件及共存离子干扰情况。     

固相微萃取/二氧化锡气体传感器联用技术对果蔬中有机磷农药残留的快速检测

研究了固相微萃取(SPME)和二氧化锡气体传感器的联用技术对果蔬中有机磷农药残留乐果、氧乐果、甲胺磷、乙酰甲胺磷、马拉硫磷、敌百虫等的快速检测。结果表明，在85℃下，解吸8min，二氧化锡气体传感器在2min内完成对有机磷农药残留的快速检测。零解吸时间测量的甲胺磷的动态响应曲线表明。SPME／二氧化锡气体传感器联用技术对分析SPME的解吸平衡非常有利。     

Tumor cell detection method using complement-mediated cytolytic reaction and imaging sensor system

A novel tumor-detection system consisting of complementmediated cytolytic reaction and an image processing system was developed for the simple and rapid determination of tumor cells. The present system consists of a CCD image sensor, image memory board, personal computer, and microscope. When monoclonal antibody 3C4, which is specific to the guinea pig hepatoma L-10, was added to cell suspension, only L-10 cytolysis occurred. Cytolysis caused a decrease in brightness of the cells observed by phase-contrast microscopy. The phase contrast image of the cells before cytolysis was converted to a digitalized signal and stored in computer memory. After cytolysis, a brightness threshold above that of lysed cells was subtracted from the digitalized signal and compared to the signal stored before reaction. L-10 cells in mixed cell suspension were determined specifically by the system. Measurement time was only 2 sec and overall time, including reaction time, was approximately 30 min. Since this method does not require a cell washing process, automation of the whole system is possible.     

Nonenzymatic Glucose Detection with Good Selectivity Against Ascorbic Acid on a Highly Porous Gold Electrode Subjected to Amalgamation Treatment

A nonenzymatic glucose sensor with good selectivity for the ascorbic acid oxidation is presented. After the gold polycrystalline electrode was subjected to amalgamation treatment, two advantageous effects were observed. One is the enhancement of the surface roughness and the other is an increase in the catalytic current in the glucose oxidation. Besides the known first effect, the latter provided another advantageous effect in a fabrication of nonenzymatic glucose sensor. Using a gold electrode subjected to amalgamation treatment for 60 s, two calibration curves for glucose oxidation at two different potentials of ?0.1 V and 0.25 V were obtained and compared. At the potential of ?0.1 V, at which no ascorbic acid was oxidized and no interference effect was observed, a current sensitivity of 16 μA cm^?2 mM^?1 from zero to 10 mM glucose concentration range was obtained. At the other potential of 0.25 V, at which ascorbic acid was easily oxidized, a satisfactory calibration curve with negligible ascorbic acid interference was also obtained together with a more enhanced current sensitivity of 32 μA cm^?2 mM^?1.     

Optimization of a portable microanalytical system to reduce electrode fouling from proteins associated with biomonitoring of lead (Pb) in saliva

There is a need to develop reliable portable analytical systems for on-site and real-time biomonitoring of lead (Pb) from both occupational and environmental exposures. Saliva is an appealing matrix since it is easily obtainable, and therefore a potential substitute for blood due to existing reasonably good correlation between Pb levels in blood and saliva. The microanalytical system is based on flow-injection/stripping voltammetry with a wall-jet (flow-onto) microelectrochemical cell. Samples that contain as little as 1% saliva can cause electrode fouling, resulting in significantly reduced responsiveness and irreproducible quantitations. In addition, incomplete Pb release from salivary protein can also yield a lower Pb response than expected. This paper evaluates the extent of in vitro Pb-protein binding and the optimal pretreatment for releasing Pb from the saliva samples. Even in 50% by volume of rat saliva, the electrode fouling was not observed, due to the appropriate sample pretreatment and the constant flow of the sample and acidic carrier that prevented passivation by the protein. The system offered a linear response over a low Pb range of 1-10 ppb, low detection limit of 1 ppb, excellent reproducibility, and reliability. It also yielded the same Pb concentrations in unknown samples as did the ICP-MS. These encouraging results suggest that the microanalytical system represents an important analytical advancement for real-time non-invasive biomonitoring of Pb.