Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Physico-chemical aspects of polyethylene processing in an open mixer. Part 26: Formal kinetics of aldehyde and carboxylic acid formation at a constant rate

Formation of carboxylic acids at a constant rate can be easily explained. It seems to result from the formation and decomposition of α,γ-keto-hydroperoxides. Formal kinetics based on formation and decomposition of these structural units is in agreement with the experimental findings. The activation energy deduced from the calculations is negligible, in agreement with the experimental data showing the constant rate to be practically temperature independent. Comparison of the acids with the hydroperoxides and ketones formed initially shows that the rate of oxygen addition to alkyl radicals is significantly smaller than in low molecular mass liquids. The same conclusion is reached on comparing directly the acids formed on decomposition of α,γ-keto-hydroperoxides in polyethylene melt and in hexadecane. The rate of oxygen addition in polyethylene melt is closer to 2 × 10⁵ than to 6 × 10⁵ (s⁻¹) that is valid in hexadecane.It is possible to attribute the relatively small amount of aldehydes that might be formed at a constant rate to different reactions of alkoxy radicals that are not in a cage with other radicals. These alkoxy radicals result from the addition of peroxy radicals to unsaturated bonds. This addition is followed mainly by epoxide formation and simultaneous release of an alkoxy radical.     

Localization effects and measure source terms in numerical schemes for balance laws

This paper investigates the behavior of numerical schemes for nonlinear conservation laws with source terms. We concentrate on two significant examples: relaxation approximations and genuinely nonhomogeneous scalar laws. The main tool in our analysis is the extensive use of weak limits and nonconservative products which allow us to describe accurately the operations achieved in practice when using Riemann-based numerical schemes. Some illustrative and relevant computational results are provided.

     

Cosmic dust and our origins

The small solid particles in the space between the stars provide the surfaces for the production of many simple and complex molecules. Processes involving the effects of ultraviolet irradiation of the thin (hundredth micron) mantles are shown to produce a wide range of molecules and ions also seen in comets. Some of the more complex ones inferred from laboratory experiments are expected to play an important role in the origin of life. An outline of the chemical evolution of interstellar dust as observed and as studied in the laboratory is presented. Observations of comets are shown to provide substantial evidence for their being fluffy aggregates of interstellar dust as it was in the protosolar nebula, i.e. the interstellar cloud which collapsed to form the solar system. The theory that comets may have brought the progenitors of life to the earth is summarized.     

Time delay as a key to apoptosis induction in the p53 network

A feedback mechanism that involves the proteins p53 and mdm2, induces cell death as a controlled response to severe DNA damage. A minimal model for this mechanism demonstrates that the response may be dynamic and connected with the time needed to translate the mdm2 protein. The response takes place if the dissociation constant k between p53 and mdm2 varies from its normal value. Although it is widely believed that it is an increase in k that triggers the response, we show that the experimental behaviour is better described by a decrease in the dissociation constant. The response is quite robust upon changes in the parameters of the system, as required by any control mechanism, except for few weak points, which could be connected with the onset of cancer. Received 8 May 2002 / Received in final form 9 July 2002 Published online 17 September 2002     

Equilibrium in Queueing Systems with Complementary Products

We study a model of a queueing system with two complementary products/services. In our model, there is one M/M/1 system and another facility that provides instantaneous service. The two services are complementary and the customer has no benefit from obtaining just one of them. We investigate the model under various price structures and ownership assumptions.AMS subject classification: 90B22, 91A10The authors are equal in their contribution to this paper. This paper is submitted by the first author to the Tokyo Institute of Technology as partial fulfillment of the requirements for the Ph.D. program in the Department of Value and Decision Sciences, and the order of names was chosen in compliance with program conditions. This research was supported by the Israel Science Foundation (grant No. 237/02).     

An AFM, XPS and electrochemical study of molecular electroactive monolayers formed by wet chemistry functionalization of H-terminated Si(1 0 0) with vinylferrocene

Molecular electroactive monolayers have been produced from vinylferrocene (VFC) via light-assisted surface anchoring to H-terminated n- and p-Si(1 0 0) wafers prepared via wet chemistry, in a controlled atmosphere. The resulting Si-C bound hybrids have been characterized by means of XPS and AFM. Their performance as semiconductor functionalized electrodes and their surface composition have been followed by combining electrochemical and XPS measurements on the same samples, before and after use in an electrochemical cell. White-light photoactivated anchoring at short (1 h) exposure times has resulted in a mild route, with a very limited impact on the initial quality of the silicon substrate. In fact, the functionalized Si surface results negligibly oxidized, and the C/Fe atomic ratio is close to the value expected for the pure molecular species. The VFC/Si hybrids can be described as (η⁵-C₅H₅)Fe²⁺(η⁵-C₅H₄)-CH₂-CH₂-Si species, on the basis of XPS results. Electrochemical methods have been applied in order to investigate the role played by a robust, covalent Si-C anchoring mode towards substrate-molecule electronic communication, a crucial issue for a perspective development of molecular electronics devices. The response found from cyclic voltammograms for p-Si(1 0 0) functionalized electrodes, run in the dark and under illumination, has shown that the electron transfer is not limited by the number of charge carriers, confirming the occurrence of electron transfer via the Si valence band. The hybrids have shown a noticeable electrochemical stability and reversibility under cyclic voltammetry (cv), and the trend in peak current intensity vs. the scan rate was linear. The molecule-Si bond is preserved even after thousands of voltammetric cycles, although the surface coverage, evaluated from cv and XPS, decreases in the same sequence. An increasingly larger surface concentration of Fe³⁺ at the expenses of Fe²⁺ redox centers has been found at increasing number of cv’s, experimentally associated with the growth of silicon oxide. Surface SiO⁻ groups from deprotonated silanol termination, induced by the electrochemical treatments, are proposed as the associated counterions for the Fe³⁺ species. They could be responsible for the observed decrease in the electron transfer rate constant with electrode ageing.     

纳米氧化钛-乙二醇溶胶溶液的研究

选用了钛酸丁酯、硬脂酸和乙二醇作为表面活性剂，采用表面化学修饰和表面物理修饰2种方法修饰纳米氧化钛，然后分散在乙二醇溶剂中形成溶胶溶液．并通过红外光谱仪、紫外分光计、原子力显微镜，分析了表面化学修饰后的纳米氧化钛表面化学结构的变化，观测了纳米氧化钛溶胶在乙二醇溶剂中稳定性．试验结果表明表面活性剂与纳米氧化钛的表面的不饱和键之间形成了新的化学结构，粒子表面可能接枝上有机长链，提高了纳米粒子在溶剂中的相容性．表面化学修饰后的纳米氧化钛与乙二醇溶剂形成了较稳定的溶胶体系，而且纳米溶胶粒径较小．表面活性剂添加量与纳米粒子添加量控制在(1～1．2)：1时，可以获得纳米溶胶粒径较小，同时溶胶稳定性较好的纳米氧化钛-乙二醇溶胶体系．     

Numerical simulation of thermally and chemically nonequilibrium flows and heat transfer in underexpanded induction plasmatron jets

The results of numerical simulation are presented for thermally and chemically nonequilibrium air plasma flows in a plasmatron discharge channel and underexpanded dissociated and partially ionized air jets flowing past a cylindrical model with a blunt leading edge and cooled copper surface under the experimental conditions realized in a VGU-4 100 kW induction plasmatron (Institute for Problems in Mechanics of the Russian Academy of Sciences) (see, for example, [1, 2]). The nonequilibrium excitation of the vibrational degrees of freedom of the molecules in the modal approximation and the difference between the electron and translational heavy-particle temperatures are taken into account in the calculations. The calculated data on the heat transfer and pressure at the stagnation point are compared with the results obtained within the framework of the thermally equilibrium model. Comparison with the experimental data obtained in the Institute for Problem in Mechanics of the Russian Academy of Sciences (Laboratory for interaction between plasma and radiation and materials) and kindly provided for comparison purposes gives satisfactory agreement.     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.