简便快速的硫化氢测定法

本文提出了有一种简易快速测定剂来测定水样中的硫化氢的方法。该法的检出限为０．１ｍｇ／Ｌ，对１．０１ｍｇ／Ｌ的Ｈ２Ｓ样品７次测定的相对标准偏差＜４．１％，１ｈ能测定１２个样品。用本测定了几种水样中的Ｈ２Ｓ含量，回收率为８４％－１０５％。应用它可上标准法的４ｈ左右缩短到５ｍｉｎ；使分析成本降低９／１０；不需配制一系列分析试剂和仪器，只需一支小型塑料管和几片药片，便于渔业水质和环境水质的野外现场监测。     

耐硫催化剂上合成混合醇的研究

通过改进制备方法和添加助剂，用浸渍－热分解法制得了具有高活性和高选择性的MoS2-K-C型耐硫低碳混合醇催化剂。在8.0-11.0MPa,290-340℃，6000-12000h^-1,H2 S 浓度为100ppm 左右的条件下，在直流反应器中对催化剂进行了性能测试，结果表明，醇得率为0.14-0.47gROH(gcat·h)^-1，选择性为89-98%。同时，考察了操作条件对催化剂性能的影响。1042h的试验，证明催化剂具有很好的稳定性。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Thermolysis of reactive oligo(p-phenylene sulfide) containing disulfide bond

Oligo(phenylene sulfide) (OPS) containing one disulfide bond at the end of the chain, which was obtained by the oxidative polymerization of diphenyl disulfide, had a relatively low Td_10%(temperature for 10% weight loss) of 412 °C because of degradation of the disulfide bond. But this thermal cleavage of the disulfide bond promoted the curing reaction through thiophenoxy radical formation. OPS was allowed to react with diiodobenzene at 220 °C. The thermal stability of OPS was improved through the consumption of the disulfide bond and the coupling of the chain.     

[Bi2Cl10(H2-Norf)4(H2O)8](H-Norf是诺氟沙星)

CommentDuringinvestigationsonvariousmetalcomplexeswithH鄄Norf[1,2],complexationwithBiwasinvestigated.Fig.1showsthestructureofthefirstBi髥complexcontainingtheantibacterialdrugNorfloxacin○,[Bi2Cl10(H2鄄Norf)4(H2O)8].Thisisanioniccompoundcompris鄄ingfour[H2     

Reductive coupling of polyfunctionalized organobismuth and organolead arylating reagents in the synthesis of benzopyran derivatives

Benzopyran derivatives were synthesized in good yields by the reactions of tris[2-(chloromethyl)phenyl]bismuth diacetate and 2-(halomethyl)aryllead triacetates with phenols and naturally occurring 4-hydroxycoumarins in the presence of bases according to a three-step one-pot procedure. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 11, pp. 2520–2529, November, 2005.     

聚-4,7-二硫杂壬基倍半硅氧烷铑配合物的合成与催化硅氢化性能

本文叙述了一种新型有机硅聚合物负载配位催化剂——聚-4,7-二硫杂壬基倍半硅氧烷铑配合物的合成、结构及其对烯烃硅氢化反应的催化性能.标题配合物在用量为烯烃摩尔量的十万分之一时仍具有良好的催化活性,烯烃的转化数达到80,000.     

选择性氧化含氰基的对硝基苯硫醚

选择性氧化含氰基的对硝基苯硫醚岳国仁，王建华，张正（南京大学化学系南京２１０００８）关键词含氰基硫醚，选择性氧化，四水合过硼酸钠据报道［１］对硝基苯磺酰基乙腈的合成，反应时间长，可采用四水合过硼酸钠（ＮａＢＯ３·４Ｈ２Ｏ）作为氧化剂，受到重视［２，３...     

Influence of the texture of chromia catalysts on their activity in synthesis of 2-methylthiophene

The texture of Cr₂O₃-K₂O/Al₂O₃catalysts containing oxides of rare earth elements (REE) was studied. The catalysts are used for the synthesis of 2-methylthiophene by the reaction of H₂S with n-pentane or piperilene. The heterocyclization of n-pentane is a consecutive reaction involving a step of dehydrogenation of initial hydrocarbon. At this step the texture of the catalyst affects the yield of 2-methylthiophene. The yield of 2-methylthiophene obtained from piperilene and I₂S is independent of the catalyst texture.     

Synthesis of New Lithium Ionic Conductor Thio-LISICON—Lithium Silicon Sulfides System

The new lithium ionic conductors, thio-LISICON (LIthium SuperIonic CONductor), were found in the ternary Li₂S-SiS₂-Al₂S₃ and Li₂S-SiS₂-P₂S₅ systems. Their structures of new materials, Li_4+xSi_1−xAl_xS₄ and Li_4−xSi_1−xP_xS₄ were determined by X-ray Rietveld analysis, and the electric and electrochemical properties were studied by electronic conductivity, ac conductivity and cyclic voltammogram measurements. The structure of the host material, Li₄SiS₄ is related to the γ-Li₃PO₄-type structure, and when the Li⁺ interstitials or Li⁺ vacancies were created by the partial substitutions of Al³⁺ or P⁵⁺ for Si⁴⁺, large increases in conductivity occur. The solid solution member x=0.6 in Li_4−xSi_1−xP_xS₄ showed high conductivity of 6.4×10^-4 S cm⁻¹ at 27°C with negligible electronic conductivity. The new solid solution, Li_4−xSi_1−xP_xS₄, also has high electrochemical stability up to ∼5 V vs Li at room temperature. All-solid-state lithium cells were investigated using the Li_3.4Si_0.4P_0.6S₄ electrolyte, LiCoO₂ cathode and In anode.