Luminescence properties of α-Al2O3 dosimetric crystals exposed to a high-current electron beam

The spectra of pulsed cathodoluminescence (PCL) and thermoluminescence (TL) in TLD-500 detectors, which were exposed to a strong beam from a pulsed electron accelerator, have been studied. Additional bands in the PCL spectrum and new peaks in the TL curves, which are due to impurity ions, have been revealed. Luminescence bands of F- and F⁺-centers cannot be used in the dosimetry of strong electron beams using TLD-500 detectors because of the saturation of dose dependence and the decrease in the TL yield. It is shown that high doses from these beams can be measured by recording TL in the luminescence band of impurity titanium ions.     

Hydrophilic segmented block copolymers based on poly(ethylene oxide) and monodisperse amide segments

Segmented block copolymers based on poly(ethylene oxide) (PEO) flexible segments and monodisperse crystallizable bisester tetra‐amide segments were made via a polycondensation reaction. The molecular weight of the PEO segments varied from 600 to 4600 g/mol and a bisester tetra‐amide segment (T6T6T) based on dimethyl terephthalate (T) and hexamethylenediamine (6) was used. The resulting copolymers were melt‐processable and transparent. The crystallinity of the copolymers was investigated by differential scanning calorimetry (DSC) and Fourier Transform infrared (FTIR). The thermal properties were studied by DSC, temperature modulated synchrotron small angle X‐ray scattering (SAXS), and dynamic mechanical analysis (DMA). The elastic properties were evaluated by compression set (CS) test. The crystallinity of the T6T6T segments in the copolymers was high (>84%) and the crystallization fast due to the use of monodisperse tetra‐amide segments. DMA experiments showed that the materials had a low T_g, a broad and almost temperature independent rubbery plateau and a sharp flow temperature. With increasing PEO length both the PEO melting temperature and the PEO crystallinity increased. When the PEO segment length was longer than 2000 g/mol the PEO melting temperature was above room temperature and this resulted in a higher modulus and in higher compression set values at room temperature. The properties of PEO‐T6T6T copolymers were compared with similar poly(propylene oxide) and poly(tetramethylene oxide) copolymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4522–4535, 2007     

双金属氰化络合物催化剂的形态及其对催化剂活性的影响

合成了多个基于钴氰化锌的双金属氰化络合物(DMC)催化剂,并对催化剂的结晶形态进行了表征.考察了制备过程中,有机配体及其引入方式,温度,搅拌速度对DMC催化剂形态的影响.其中有机配体对DMC催化剂形态的影响是最主要的.有机配体中富电子原子的电负性的强弱和数量共同影响着DMC催化剂的形态.该类原子的电负性越强,得到的DMC催化剂的结晶性越差,无定型部分的比例越高,并且单个原子的电负性强弱比该类原子的数量在此间的影响更大.而在有机配体预先存在的情况下,该沉淀体系则更有利于无定型部分的产生.在30℃左右的沉淀反应温度下,得到的DMC催化剂的无定型部分比例最高.在有机配体存在的情况下,搅拌速度对DMC催化剂形态的影响有限.并且发现存在于有机配体中的DMC催化剂随着时间的推移,形态会发生变化.初步揭示了DMC催化剂的形态与其催化活性间的关系.而无定型态的DMC催化剂更有利于PO的聚合.     

光电变色器件用纳米晶氧化钛薄膜的微结构与特性

纳米晶TiO2薄膜在光电变色器件中具有很重要的作用。它的微结构直接影响染料的吸附、光的散射以及电荷输运的特性。因此，探索TiO2薄膜的微结构(如粒径、表面形貌和厚度等)及光电性能是非常有意义的。采用电子束蒸发工艺制备了光电变色器件用纳晶TiO2薄膜，利用原子力显微镜、X射线衍射、俄歇电子能谱等手段对纳米晶TiO2薄膜的表面形貌、结晶状态及组分进行了分析。从理论上研究和讨论了纳米晶TiO2薄膜晶粒尺寸对光电性能的影响，并用量子限制效应解释了吸收光谱峰值波长随粒径减小而发生蓝移的现象。     

A Monte Carlo simulation of the heterogeneous adsorption of hydrogen ions on metal oxides: Effect of inert electrolyte

Charging of the surface of an oxide caused by the adsorption of hydrogen ions and ions of inert 1:1 electrolyte was investigated by using grand canonical Monte Carlo simulation technique. In particular, adsorption isotherms of protons as well as of ions of the electrolyte together with the resulting charge density of the surface were obtained for different system parameters. Also, the effect of the surface energetic heterogeneity and the concentration of the background electrolyte on the isotherms and the charge density curves was examined. Furthermore, lateral interactions in the mixed adsorbed phase were taken into account in the modeling of the system behavior. The obtained results, in general, suggest that the three factors mentioned above may have substantial influence on the charging mechanism at the liquid/oxide interface.     

Tetradecanol dehydrogenation over CuO catalyst supported on BaO, CaO and MgO

Bimetallic Cu/Mg, Ca, Ba mixed oxide compounds acted as catalyst in the dehydrogenation of tetradecanol into tetradecanal, and were characterized by thermal gravimetric analysis, surface area, X-ray diffraction, temperature-programmed reduction and desorption of CO₂. Alkaline earth oxides increased the total basic site concentration in the order of Mg>Ca>Ba. A correlation was found between the total basic site concentration and initial dehydrogenation rate. This revised version was published online in June 2006 with corrections to the Cover Date.     

Dielectric properties of europium-indium oxide solid solution films prepared on Si (100) substrates

Thin Eu-In solid solution oxide films (SS) were grown on Si (P) substrates to form MOS devices. The samples were characterised by X-ray fluorescence and X-ray diffraction techniques. The ac-conductance and capacitance of the devices were studied as a function of frequency in the range 500 Hz to 100 kHz, temperature in the range 293-400 K and gate voltage. The investigation established that: (1) the prepared SS exhibit a sudden reversible structural change at about 370 K, (2) the frequency dependence for f>10 kHz of the ac-conductivity and capacitance of the insulator at room temperature is controlled by the ‘corrected barrier hopping’ CBH model, (3) the temperature dependence of the ac-conductance which shows a small activation energy characterises the hopping process of current carriers between equilibrium sites, and (4) the prepared transparent SS have a sufficiently high relative permittivity ?, around 30, which suggests they are promising candidates for high-? dielectric applications.     

Magnetic properties of lanthanum orthoferrite fine powders prepared by different chemical routes

Fine powders of lanthanum iron oxide, LaFeO₃, have been prepared by solid state reaction as well as sol-gel synthesis and nebulized spray pyrolysis. Structures, morphologies and magnetic susceptibility measurements of these powders have been examined. The powders prepared by all the three low-temperature routes contain nearly spherical particles with an average diameter of 40 nm. These samples show a lower Neel temperature than the powder prepared by solid state reaction besides showing much lower magnetic susceptibility at low temperatures. Dedicated to Professor C N R Rao on his 70th birthday     

K＋－SrO－La_2O_3／ZnO催化剂上甲烷氧化偶联反应Ⅰ．催化活性和反应气中添加CO_2的影响

Ｋ＋┐ＳｒＯ┐Ｌａ２Ｏ３／ＺｎＯ催化剂上甲烷氧化偶联反应＊Ⅰ．催化活性和反应气中添加ＣＯ２的影响余林徐奕德＊＊郭燮贤（中国科学院大连化学物理研究所催化基础国家重点实验室，大连１１６０２３）关键词钾离子，氧化锶，氧化镧，氧化锌，金属氧化物催化剂，甲烷，...     

三甲基膦和环氧乙烷的加成产物裂解反应机理的MNDO法研究

文中用ＭＮＤＯ方法研究了三甲基膦和环氧乙烷加成产物裂解反应机理