共振光散射法测定环境水样中痕量锡

基于在Tris-HCl介质中,痕量锡对氯酚红-人血白蛋白-十二烷基硫酸钠体系的共振散射光谱有明显的猝灭作用;考察了它们的光谱特征、影响因素和适宜的反应条件;确定了散射光强度与Sn2 的关系,从而建立了测定痕量锡的共振光散射新方法.该法在室温下进行,操作方便,灵敏度高和选择性好.其线性范围为0.2-4.0μg/L,检出限0.12μg/L,用于环境水样中痕量Sn2 的测定,相对标准偏差小于3.1%,加标回收率为95.5%-100.5%,效果良好.     

极化子导电到能带导电的转变

采用交流法测量大功率商用钛酸钡(BT)陶瓷加热器的电阻和加热功率随温度的变化关系.结果显示,BT陶瓷的电导特性在80℃附近出现了明显的转变,从低温时的极化子跳跃导电转变为高温时的能带导电,此时,电阻出现极小值,而加热功率出现极大值.     

2-(2-喹啉偶氮)-5-二甲氨基苯胺光度法测定铜

在pH=4.0的磷酸盐缓冲介质中,CTMAB存在下,2-(2-喹啉偶氮)-5-二甲氨基苯胺(QADMAA)与铜反应生成2:1稳定络合物,络合物λmax=580nm,ε=1.14×105L·mol-1·cm-1.铜含量在0.01-0.6μg/mL内符合比耳定律,方法用于环境样品中铜的测定,结果令人满意.     

Surface structures formed by individual adsorption and coadsorption of Mn and Bi on Cu(0 0 1), studied by LEED

We have studied the individual adsorption of Mn and Bi, and their coadsorption on Cu(0 0 1) by low-energy electron diffraction (LEED). For Mn, we have determined the c(2 × 2) structure formed at 300 K, whose structure had been determined by several methods. We reconfirmed by a tensor LEED analysis that it is a substitutional structure and that a previously reported large corrugation (0.30 Å) between substitutional Mn and remaining surface Cu atoms coincides perfectly with the present value. In the individual adsorption of Bi, we have found a c(4 × 2) structure, which is formed by cooling below ∼250 K a surface prepared by Bi deposition of ∼0.25 ML coverage at 300 K where streaky half-order LEED spots appear. The c(4 × 2) structure has been determined by the tensor LEED analysis at 130 K and it is a substitutional structure. In the coadsorption, we found a c(6 × 4) structure, which has been determined by the tensor LEED analysis. It is very similar to the previously determined structure of the c(6 × 4) formed by coadsorption of Mg and Bi, and embedded MnBi₄ clusters are arranged in the top Cu layer instead of MgBi₄. Large lateral displacements of Bi atoms in the c(6 × 4)-(Mn + Bi) suggest that the Mn atoms undergo the size-enhancement caused by their large magnetic moment.     

The AB2-XA1 electronic transition of NO2: A rovibronic survey covering 14 300-18 000 cm

More than 250 rotationally resolved vibrational bands of the A²B₂-X²A₁ electronic transition of ¹⁵NO₂ have been observed in the 14 300-18 000 cm⁻¹ range. The bands have been recorded in a recently constructed setup designed for high resolution spectroscopy of jet cooled molecules by combining time gated fluorescence spectroscopy and molecular beam techniques. The majority of the observed bands has been rotationally assigned and can be identified as transitions starting from the vibrational ground state or from vibrationally excited (hot band) states. An exceptionally strong band is located at 14 851 cm⁻¹ and studied in more detail as a typical benchmark transition to monitor ¹⁵NO₂ in atmospheric remote sensing experiments. Standard rotational fit routines provide band origins, rotational and spin rotation constants. A subset of 177 vibronic levels of ²B₂ vibronic symmetry has been analyzed in the energy range between 14 300 and 17 250 cm⁻¹, in terms of integrated density and using Next Neighbor Distribution. It is found that the overall statistical properties and polyad structure of ¹⁵NO₂ are comparable to those of ¹⁴NO₂ but that the internal structures of the polyads are completely different. This is a direct consequence of the X²A₁-A²B₂ vibronic mixing.     

Solid-phase epitaxy of CaSi2 on Si(1 1 1) and the Schottky-barrier height of CaSi2/Si(1 1 1)

Thin Ca films were evaporated on Si(1 1 1) under UHV conditions and subsequently annealed in the temperature range 200–650 °C. The interdiffusion of Ca and Si was examined by ex situ Auger depth profiling. In situ monitoring of the Si 2p core-level shift by X-ray photoemission spectroscopy (XPS) was employed to study the silicide formation process. The formation temperature of CaSi₂ films on Si(1 1 1) was found to be about 350 °C. Epitaxial growth takes place at T≥400 °C. The morphology of the films, measured by atomic force microscopy (AFM), was correlated with their crystallinity as analyzed by X-ray diffraction (XRD). According to measurements of temperature-dependent I–V characteristics and internal photoemission the Schottky-barrier height of CaSi₂ on Si(1 1 1) amounts to qΦ_Bn=0.25 eV on n-type and to qΦ_Bp=0.82 eV on p-type silicon.     

HgCl2/I2复合催化剂协同催化合成异丙醇钇的研究

以金属钇和异丙醇为原料，以HgCl2/I2为复合催化剂，通过对金属钇的机械加工以增加其比表面，并将异丙醇脱水使其含水量降低至0．05％，体系在82℃回流5h，经过滤、减压蒸馏，得到了白色海绵状异丙醇钇，其产率高达83％，合成时间比文献报道的缩短了19h，产率提高了8％。文章确定了催化剂的最佳用量为20gY加入60mg HgCl2/I2，研究了合成产率与HgCl2/I2催化剂和HgCl2催化剂的依赖关系及异丙醇中含水量对合成产率的影响，并对HgCl2/I2的催化作用机理进行了初步探讨。     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.     

SEPARATING SCN~- FROM DESULPHURIZATION WASTE SOLUTION OF COCKING PLANT BY D241 RESIN

1. INTRODUCTION In the process of coking plant, about 30%~35% sulfur is transformed to H2S and some other sulfide, which form impurity in coal gas together with NH3 and HCN. Only 0.1% H2S containing in air can lead to die, so it is very important to carry on desulphurization and decyanation with coal gas [1~3]. Currently desulphurization and decyanation craft technique have Dry Oxidation Technology, Wet Oxidation Technology and Liquid Absorption Technology [2] three main kinds. The…     

A solution of the DGLAP equation for gluon at low x

We obtain a solution of the DGLAP equation for the gluon at low x first by expanding the gluon in a Taylor series and then using the method of characteristics. We test its validity by comparing it with that of Glück, Reya and Vogt. The convergence criteria of the approximation used are also discussed. We also calculate εF ₂(x,Q)²/ε In Q ² using its approximate relations with the gluon distribution at low x. The predictions are then compared with the HERA data.