Photo-Induced Ultrafast Electron Dynamics in Anatase and Rutile TiO2: Effects of Electron-Phonon Interaction

The photo-induced ultrafast electron dynamics in both anatase and rutile TiO\begin{document}$_{2}$\end{document} are investigated by using the Boltzmann transport equation with the explicit incorporation of electron-phonon scattering rates. All structural parameters required for dynamic simulations are obtained from ab initio calculations. The results show that although the longitudinal optical modes significantly affect the electron energy relaxation dynamics in both phases due to strong Fr?hlich-type couplings, the detailed relaxation mechanisms have obvious differences. In the case of a single band, the energy relaxation time in anatase is 24.0 fs, twice longer than 11.8 fs in rutile. This discrepancy is explained by the different diffusion distributions over the electronic Bloch states and different scattering contributions from acoustic modes in the two phases. As for the multiple-band situation involving the lowest six conduction bands, the predicted overall relaxation times are about 47 fs and 57 fs in anatase and rutile, respectively, very different from the case of the single band. The slower relaxation in rutile is attributed to the existence of multiple rate-controlled steps during the dynamic process. The present findings may be helpful to control the electron dynamics for designing efficient TiO\begin{document}$_{2}$\end{document}-based devices.     

A study of the effect of the synthesis conditions of titanium dioxide on its morphology and cell toxicity properties

In this study, titanium dioxide nanoparticles (NPs) were synthesized using the home microwave method, and the effect of the microwave irradiation time on the structure of NPs was investigated. In addition, the morphological effect of these NPs on the toxicity of HDMSCs cells was investigated. The crystalline structure and morphology of the NPs were analyzed using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and field emission scanning electron microscopy (FE-SEM); the cytotoxicity was determined by the methyl thiazolyl tetrazolium (MTT) assay. X-ray diffraction analysis revealed that all thin films had a polycrystalline nature with an anatase phase of TiO₂. It was also found that the crystallite size increased with increasing microwave radiation time. The FTIR spectrum showed Ti-O-Ti properties by the peak in the range between 527 and 580 cm^?1. Further, the FE-SEM images showed that the grain size increased with increasing irradiation time. The MTT assay results showed that the accumulation of NPs leads to toxicity.     

Binary Metal Oxide Adsorbed Graphene Modified Glassy Carbon Electrode for Detection of Riboflavin

Tungsten oxide (W) decorated titanium oxide (T) adsorbed onto a graphene (Gr) and modified the glassy carbon electrode for the electrochemical quantification of riboflavin (RF) in edible food and pharmaceuticals. For comparison, nanocomposites are formed using graphene oxide (GO), reduced graphene oxide (rGO) and pure graphite (G) sheets to study the electrochemical activities towards riboflavin. The ternary WTGr modified GCE shows the highest electrocatalytic activity due to synergetic interactions between the metal oxide and graphene. The electrochemical observations are supported by the SEM, HRTEM, XRD, UV-Vis, Zeta potential (ζ) and size data. The sensor shows a wide linear range 20 nM–2.5 μM with a detection limit 25.24 nM and sensitivity (4.249×10⁻⁸ A/nM). The fabricated sensor is validated in real samples.     

Sonocatalytic injury of cancer cells attached on the surface of a nickel–titanium dioxide alloy plate

The present study demonstrates ultrasound-induced cell injury using a nickel–titanium dioxide (Ni–TiO₂) alloy plate as a sonocatalyst and a cell culture surface. Ultrasound irradiation of cell-free Ni–TiO₂ alloy plates with 1 MHz ultrasound at 0.5 W/cm² for 30 s led to an increased generation of hydroxyl (OH) radicals compared to nickel–titanium (Ni–Ti) control alloy plates with and without ultrasound irradiation. When human breast cancer cells (MCF-7 cells) cultured on the Ni–TiO₂ alloy plates were irradiated with 1 MHz ultrasound at 0.5 W/cm² for 30 s and then incubated for 48 h, cell density on the alloy plate was reduced to approximately 50% of the controls on the Ni–Ti alloy plates with and without ultrasound irradiation. These results indicate the injury of MCF-7 cells following sonocatalytic OH radical generation by Ni–TiO₂. Further experiments demonstrated cell shrinkage and chromatin condensation after ultrasound irradiation of MCF-7 cells attached on the Ni–TiO₂ alloy plates, indicating induction of apoptosis.     

Ionic/electronic conductivity regulation of n-type polyoxadiazole lithium sulfonate conductive polymer binders for high-performance silicon microparticle anodes

Low-cost silicon microparticles(SiMP),as a substitute for nanostructured silicon,easily suffer from cracks and fractured during the electrochemical cycle.A novel n-type conductive polymer binder with excellent electronic and ionic conductivities as well as good adhesion,has been successfully designed and applied for high-performance SiMP anodes in lithium-ion batteries to address this problem.Its unique features are attributed to the stro ng electron-withdrawing oxadiazole ring structure with sulfonate polar groups.The combination of rigid and flexible components in the polymer ensures its good mechanical strength and ductility,which is beneficial to suppress the expansion and contraction of SiMP s during the charge/discharge process.By fine-tuning the monomer ratio,the conjugation and sulfonation degrees of the polymer can be precisely controlled to regulate its ionic and electronic conductivities,which has been systematically analyzed with the help of an electrochemical test method,filling in the gap on the conductivity measurement of the polymer in the doping state.The experimental results indicate that the cell with the developed n-type polymer binder and SiMP(~0.5 μm) anodes achieves much better cycling performance than traditional non-conductive binders.It has been considered that the initial capacity of the SiMP anode is controlled by the synergetic effect of ionic and electronic conductivity of the binder,and the capacity retention mainly depends on its electronic conductivity when the ionic conductivity is sufficient.It is worth noting that the fundamental research of this wo rk is also applicable to other battery systems using conductive polymers in order to achieve high energy density,broadening their practical applications.     

Enhanced photocatalytic performance of TiO2 particles via effect of anatase–rutile ratio

In the present work anatase–rutile transformation temperature and its effect on physical/chemical properties as well as photocatalytic activity of TiO₂ particles were investigated. The characterisation of the synthesised and annealed TiO₂ particles were determined by X-Ray Powder Diffraction (XRD), scanning electron microscope (SEM), dynamic light scattering (DLS) and Brunauer–Emmett–Teller surface area analysis (BET). The refraction in the ultraviolet–visible (UV–vis) range was assessed using a dual-beam spectrophotometer. The photocatalytic performance of the particles was tested on methylene blue solution. The XRD data indicated that the percentage of rutile increased with the annealing temperature and almost 100% of anatase transformed to rutile at 1000 °C. In addition, the phase transformation was a linear function of annealing temperature so phase composition of TiO₂ can be controlled by changing the annealing temperature. The SEM and BET results presented the increase of agglomerate size and the decrease of specific surface area with the increasing annealing temperature. This proved that anatase has smaller particle size and higher surface area than rutile. The photocatalytic activity of the annealed TiO₂ powders reduced with the increase of annealing temperature. The samples annealed at 900 °C and 925 °C with anatase: rutile ratio of 92:8 and 77:23, respectively, showed the best activity. These results suggested that the photocatalytic activity of TiO₂ particles is a function of phase composition. Thus it can be enhanced by changing its phase composition which can be controlled by annealing temperature.     

Influence of Titanium Dioxide Content on the Crystallization Behavior and Solar Reflectance of Polyethylene/Titanium Dioxide Composites

Titanium dioxide (TiO₂) particles were introduced to improve the solar reflectance of high-density polyethylene (HDPE). The organic-inorganic hybrids were fabricated by melt blending. A series of characterizations were taken to study the crystallization behavior, morphology, solar reflectance, and real cooling property. TiO₂ particles acted as nucleation agents in the HDPE matrix and made the HDPE form thick lamellar crystals. TiO₂ particles could disperse well into the HDPE matrix under 2.5 wt.% loading but agglomerated with 3 wt.%. Solar reflectance was related to the reflective index of TiO₂ and the microstructure of HDPE. The real cooling property depended on the solar reflectance and the dispersion of the TiO₂ particles in the HDPE matrix.     

Application of sol–gel TiO2 film for an extended-gate H+ ion-sensitive field-effect transistor

In this study, a sol–gel TiO₂ thin film has been spin-coated on a commercial ITO glass substrate as the extended-gate field effect transistor (EGFET) for hydrogen ion sensing. The as-deposited films are further annealed at various temperatures (T_a) under ambient atmosphere. It is found that the bi-layer structure of TiO₂/ITO EGFET exhibits good linear sensitivity from pH 1 to 11. Anatase TiO₂ appeared as early as T_a = 200 °C and a brookite (121) diffraction evolved at T_a = 500 °C. No prominent influence on the surface fine structures could be found at higher T_a. Due to the reduction or disappearance of the surface hydroxyl groups on TiO₂, the sensitivities of the TiO₂/ITO pH-EGFET device are rapidly reduced. However, the influence of the conductivity decay for ITO substrates annealed at high T_a could not be excluded. A maximum sensitivity 61.44 mV/pH is achieved as T_a = 300 °C.The bi-layer structure of TiO₂/ITO exhibits better long-term stability than the traditional ITO sensing membranes. In addition, the asymmetric hysteresis is more significant in alkaline buffer solutions, which could be explained by a site-binding model because the diffusion of H⁺ ions into the buried sites of the sensing film is more rapid than that of OH⁻ ions.     

Germanium Quantum Dots Embedded in N‐Doping Graphene Matrix with Sponge‐Like Architecture for Enhanced Performance in Lithium‐Ion Batteries

Germanium quantum dots embedded in a nitrogen‐doped graphene matrix with a sponge‐like architecture (Ge/GN sponge) are prepared through a simple and scalable synthetic method, involving freeze drying to obtain the Ge(OH)₄/graphene oxide (GO) precursor and subsequent heat reduction treatment. Upon application as an anode for the lithium‐ion battery (LIB), the Ge/GN sponge exhibits a high discharge capacity compared with previously reported N‐doped graphene. The electrode with the as‐synthesized Ge/GN sponge can deliver a capacity of 1258 mAh g^?1 even after 50 charge/discharge cycles. This improved electrochemical performance can be attributed to the pore memory effect and highly conductive N‐doping GN matrix from the unique sponge‐like structure.     

表面修饰多壁碳纳米管负载二氧化钛的制备及催化碳酸二甲酯与苯酚酯交换反应的性能

制备了表面修饰多壁碳纳米管负载TiO₂的催化剂,并将其应用于碳酸二甲酯与苯酚的酯交换反应. 采用X射线电子能谱、透射电子显微镜、低温N₂吸附-脱附和X射线衍射等对催化剂进行了表征. 结果表明,以低浓度的氨水（0.4%）代替去离子水作为沉淀剂时,制备的催化剂显示出更好的催化活性、分离性与重复使用性. 考察了TiO₂负载量、催化剂用量及反应时间对反应性能的影响. 在最佳反应条件下,苯酚转化率为42.5%,碳酸甲苯酯与碳酸二苯酯的总选择性达到99.9%以上. 经过4次重复使用后,催化剂的活性略有下降.