原位沉析法制备磁性氧化铁羟基磷灰石/壳聚糖棒材

首先通过化学沉淀法制备磁性氧化铁羟基磷灰石(Fe3O4/HA),然后以壳聚糖(CS)为基体,利用原位沉析法将Fe3O4/HA与CS复合,制得磁性Fe3O4/HA/CS复合材料.经XRD、粒径分布和PPMS测试,结果表明了Fe3O4/HA复合物的生成.系统研究了磁性Fe3O4/HA/CS棒材力学性能的影响因素,最终确定Fe3O4与HA质量比为3∶17,磁性Fe3O4/HA与CS质量比为9∶91时,棒材的力学性能最优,弯曲强度可达到87.0 MPa,弯曲模量1.57 GPa.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

铅笔芯修饰聚苯胺制作微型复合pH电极的性能

在0.3mm直径的铅笔芯上电修饰聚苯胺,封入玻璃毛细管中,并与Ag/AgCl电极组合成复合微型pH电极.经实验测试,该电极的pH响应特性良好,在pH1～11的线性范围内,能斯特斜率为(-56.4±0.5)mV/pH,线性相关系数不小于0.996.作为参比的Ag/AgCl电极性能稳定.由于电极是复合微型化的,所以可用于活体微区测定.     

聚苯胺导电复合物二次掺杂的基材效应

对十二烷基苯磺酸掺杂的聚苯胺与氯磺化聚乙烯或苯乙烯－丁二烯－苯乙烯三嵌段共聚物形成的复合物的二次掺杂进行了研究。二次掺杂的复合膜经反掺杂后的ＵＶ－Ｖｉｓ吸收光谱在５８０￣８００ｎｍ处呈现宽的吸收，证实了二次掺杂后ＰＡｎ主链的展开，同时表明ＰＡｎ在ＣＳＰＥ中的展开较在ＳＢＳ中更充分，ＥＳＲ动态测试表明二次掺杂诱导主链的载流子间相互作用有２种方式；ＰＡｎ／ＣＳＰＥ中的单极化子转变为双极化子；ＰＡｎ／Ｓ     

Electrodeposition of fluorine-doped lead dioxide

The electrocatalytic properties of PbO₂ may be increased by incorporation of some ions such as F⁻. In this review, the preparation of fluorine-doped PbO₂ in the presence of some additives of fluorine-containing compounds (F⁻, potassium salt of nonafluoro-1-butanesulfonic acid C₄F₉O₃SK and Nafion^®) is reported. The mechanism of electrodeposition is discussed. The amount of additives in the deposit depends on the experimental conditions: potential, current density and charge of additive species in the plating solution. The physicochemical properties of doped oxide are very different from those of undoped oxide, accounting for the different electrocatalytic activity of the materials.     

分子筛改性气—液毛细管柱及其性能考察

以原位合成法制备的分子筛膜对玻璃毛细管内壁进行改性后，成功地制备了常规口径及大口径分配ＳＣＯＴ柱，并对毛细管柱的性能进行了评价。     

Simultaneous deposition of Ni nanoparticles and wires on a tubular halloysite template: A novel metallized ceramic microstructure

Tubular halloysite can be used as a template to fabricate a novel metallized ceramic microstructure through electroless plating. Reduction of Pd ions by methanol is conducted to initiate Ni plating. There is a simultaneous deposition of Ni nanoparticles on the outer surface and discontinuous wires in the lumen site of the halloysite template obtained. The different deposition could be caused by the different composition distribution of ferric oxide impurity in the wall due to the isomorphic substitution during the formation of halloysite template. Its magnetic property is mainly attributed to the Ni nanoparticles, not the wires. The metallized ceramic microstructure has the potential to be utilized as a novel magnetic material.     

DFT法研究分子筛催化trans-2-丁烯的双键异构

利用一个3T簇模型模拟分子筛催化剂的酸性位, 采用密度泛函理论(DFT)的 B3LYP/6-31G(d, p)方法, 研究了分子筛催化1-丁烯双键异构为trans-2-丁烯的反应机理. 对反应各驻点进行了全优化, 经过零点能校正后, 得到了反应的活化能. 研究表明, 反应分三步进行：物理吸附→化学反应→物理脱附. 分子筛的酸性位OH基团首先吸附1-丁烯的双键形成了π配位复合物, 然后按协同反应机理发生双键异构反应, 生成吸附态的trans-2-丁烯, 最后脱附成产物. 计算得到的表观活化能为57.1 kJ•mol^-1, 与实验结果接近.     

分子印迹膜的制备研究进展

将分子印迹技术与膜分离技术相结合的分子印迹膜,由于其高选择性,近年来受到了国内外研究者的广泛关注.本文初步探讨了分子印迹膜(MIM) 的两种分离机理以及目前主要的制备方法:同步法和复合法.     

Synthesis of temperature-sensitive micron-sized monodispersed composite polymer particles and its application as a carrier for biomolecules

 Temperature-sensitive micron-sized monodispersed composite polymer particles were prepared by seeded copolymerization of dimethylaminoethyl methacrylate and ethylene glycol dimethacrylate with 1.77 μm-sized monodispersed polystyrene seed particles. The change in surface property at temperature above and below 35 °C was examined by differential scanning calorimetry, trypsin activity and the adsorption/ desorption behaviors of low molecular weight cationic emulsifier as well as biomolecules. Received: 6 August 1997 Accepted: 16 January 1998