胺固化环氧酚醛树脂对Hg~(2+)的吸附性能

螯合树脂能与金属离子形成稳定的配合物,在无机、冶金、分析药物、催化、海洋化学、放射化学、环境保护各领域都有非常重要的应用[1-3]。我们曾以酚醛树脂为大分子骨架与多胺反应制备了一系列螯合树脂并对其结构及对多种金属离子的吸附性能进行了探讨[4,5]。本文则以线型环氧酚醛树脂为大分子骨架、多乙烯多胺为固化剂,制备了五种不同氮含量的氨基环氧酚醛螯合树脂,并考察其对金属离子Ｈｇ2+的吸附性能。1　实验部分1.1　仪器与试剂ＮｉｃｏｌｅｔＭＡＧＮＡ ＩＲ550(ＳｅｒｉｅｓＩＩ)红外分光光度计,ＳＨＡ-Ｃ水浴恒温振荡器,ＰＥ2000…     

锂离子电池正极材料LixNi1／3Mn1／3及电化学性能研究CO1／3O2的合成及电化学性能研究

应用以氢氧化物共沉淀为前驱体的高温固相烧结法合成LiNi1/3Mn1/3Co1/3O2正极材料，研究了沉淀温度及烧结过程锂盐投入量对该材料的结构和电化学性能的影响．结果表明，以室温（-20℃）下合成的氢氧化物为前驱体制备的LiNi1/3Mn1/3Co1/3O2具有较好的电化学性能．高温固相烧结会导致部分LiOH损失，因而在合成过程中需加入过量的氢氧化锂，实验表明Li1.08Ni1/3Mn1/3Co1/3O2材料的电化学性能最优．     

New generalized computations of quasi-planar waveguides characteristics

An efficient hybrid field solution to the general multilayer substrates transmission line problems with full shielded and half open cross-sectional geometry is presented by using the waveguide modes coupling and decoupling procedure in the spectral domain. Modal transverse transmission lines corresponding to the LSE and LSM modes are taken into account so that the Green's elements for the edge conditions can be derived by a simple iterative method. In this paper, we analyze not only the propagation constants and characteristic impedances but also the available transmission power capacity and power distribution of most commonly used structures. Normalized eigenmode power levels characterizing the propagation features are computed.     

The thermodynamics of proton dissociation of adenine

The thermodynamic quantities associated with ionization of the N₁ and N₉ protons of adenine have been calorimetrically determined as a function of temperature. The H values for proton dissociation of these groups, with pK values of 4.19 and 9.92, were found to be 5.1 and 9.1 kcal/mole, respectively, at 25°C, =0.025. The C _p values for proton dissociation of these groups were estimated to be –11 and –17 cal/mole-deg. These results indicate that the large heat capacity changes observed during conformational transitions of polynucleotides are not the result of ionization of the bases.     

S-Shaped composition dependence of excess thermodynamic quantities for cyclohexane mixtures with globular alkanes

Expansion coefficients , isothermal compressibilities, thermal pressure coefficients and heat capacities have been measured at 25°C for the cyclohexane+trans-decalin system. An S-shaped composition dependence, positivelnegative for highllow cyclohexane compositions is found for C _p ^E dV ^E /dT and the thermal expansion contribution to C _p ^E namely VT. The thermal motion contribution to C _p ^E , namely C _v is close to zero. The positive excursion of these mixing quantities at high cyclohexane content is anomalous. Correspondingly, the mixing quantity-VT deviates strongly in this region from the predicted equality with H ^E . The literature and this work show that all these excess quantities behave similarly for cyclohexane mixed with cyclooctane, methylcyclohexane and some highly branched alkanes. The unusual composition dependence of the thermodynamic quantities is consistent with order occurring when any large alkane molecule of globular shape is added to cyclohexane. This is speculatively associated with an interference by the globular alkane with the relatively free rotation of cyclohexane molecules.     

Computation of heat capacities of solid state benzene,p-oligophenylenes and poly-p-phenylene

Heat capacities (C_p) of solid benzene, biphenyl,p-terphenyl,p-quaterphenyl, and poly-p-phenylene were analyzed using the ATHAS Scheme of computation. The calculated heat capacities based on approximate vibrational spectra of solid benzene and the series of oligomers containing additional phenylene groups were compared to experimental data newly measured and from the literature to identify possible additional large-amplitude motion. The skeletal heat capacity was fitted to the Tarasov equation to obtain the one- and three-dimensional vibration frequencies ₁ and ₃ using a new optimization approach. Their relationship to the number of phenylene groupsn is: ₁=426.0–150.3/n; and ₃=55.4+81.8/n. Except for benzene, the quantitative thermal analyses do not show significant contributions from large-amplitude motion below the melting temperatures.This work was financially supported by the Div. of Materials Res., NSF, Polymers Program, Grant # DMR 90-00520 and Oak Ridge National Laboratory, managed by Lockheed Martin Energy Research Corp. for the U. S. Department of Energy, under contract number DE-AC05-96OR22464.     

Investigation of the thermophysical properties of polymers by the temperature wave technique

The technique of temperature waves to measure the complex thermophysical characteristics of materials has been proposed. The relations for the moduli and arguments of these characteristics for the case of plane temperature waves have been calculated. The temperature dependences of the moduli and arguments of complex thermophysical characteristics of polyvinylacetate (PVAc) at different frequencies and also the temperature dependences of its vibrational and configurational heat capacities have been determined. It has been shown that the vibrational heat capacity of PVAc in the region of softening grows sharply and its configurational heat capacity goes through a peak. The segmental mobility has been found to affect the heat transfer in the polymer in an ambivalent way causing both a decrease and increase of thermal conductivity.

---

Zusammenfassung Zur Bestimmung der komplexen thermophysischen Eigenschaften von Stoffen wurde eine Temperaturwellentechnik vorgeschlagen. Für den Fall zweidimensionaler Temperatur-wellen wurden die Verhältnisse von Moduli und Argumenten dieser Eigenschaften berechnet. Die Temperaturabhängigkeit von Moduli und Argumenten der komplexen thermophysischen Eigen-schaften von Polyvinylacetat (PVAc) bei verschiedenen Frequenzen und auch die Temperatur-abhängigkeit seiner Vibrations- und Konfigurations-Wärmekapazitäten wurden bestimmt. Es wurde gezeigt, daß die Vibrations-Wärmekapazität von PVAc im Erweichungsbereich scharf zunimmt und die Konfigurations-Wärmekapazität durch einen Peak geht. Man fand, daß die Segment-Mobilität den Wärmetransport im Polymer auf eine ambivalente Weise beeinflußt, in dem die Wärmeleit-fähigkeit entweder gesenkt oder angehoben wird.

     

Hydration heat capacities of hydrophobic solutes at 248–373 K

A new equation is suggested to define the temperature dependence of the Gibbs energy of hydration of hydrophobic substances: ΔG ⁰ = b ₀ + b ₁ T + b ₂lnT. According to this equation, the hydration heat capacity is in inverse proportion to temperature. Consistent values of hydration heat capacity of nonpolar solutes have been obtained for different temperatures using data on solubility and dissolution enthalpy. The contributions of the hydrocarbon radicals and OH group to the heat capacity of hydration of the compounds were found for the temperature range 248–373 K. The hydration heat capacity of the hydroxyl group has a weak dependence on temperature and increases by only 12 J/(mol·K) in the specified temperature interval. Changes in the hydration entropy of hydrophobic and OH groups are calculated for the temperature increasing from 248 K to 373 K.     

Excess heat capacities and orientational order in systems containing hexadecane isomers of different molecular structure

Using the Picker flow microcalorimeter, excess heat capacities have been obtained at 25°C throughout the concentration range for 2,2-dimethylbutane,n-hexane, and cyclohexane each mixed with a series of hexadecane isomers of increasing degrees of orientational order, as determined by depolarized Rayleigh scattering. The isomers are 2,2,4,4,6,8,8-heptamethylnonane, 6-, 4-, and 2-methylpentadecane, andn-hexadecane. Thec _p ^E values are negative, increasing rapidly in magnitude with increase of orientational order, and are not predicted by the Prigogine—Flory theory which neglects order. Values ofc _p ^E are obtained at 10, 25, and 55°C for cyclohexane +6-, 4-, and 2-methylpentadecane which with other literature data lead to the temperature dependence of the thermodynamic excess functions for cyclohexane solutions of the five C₁₆ isomers. The excess enthalpy and entropy vary with the C₁₆ isomer and with temperature, but the corresponding variation of the excess free energy is small, indicating a high degree of enthalpy-entropy compensation. This is consistent with a rapid decrease with temperature of orientational order in the C₁₆ isomers.     

Ionization of aqueous toluic acids: Conductance and thermodynamics

Conductivities of aqueous solutions ofortho-, meta-, andpara-toluic acids have been measured for the concentration range 0.1–2 millimolar and at 5° intervals from 5 to 100°C. At each temperature pK _a(m) andA ₀ have been calculated using the paired ion model recently described by Fuoss. Thermodynamic parameters have been calculated for the ionization of each acid, and Walden products for the anions. Results are discussed in terms of contributions to acidity by enthalpy and entropy changes as well as by hydration of the various solute species.