用PCR技术检测生物硝化池污水中硝化细菌(Nitrobacteria)的研究

从生物硝化池污水水样中分离了硝化细菌ＤＮＡ,以其为模板,针对其１６ＳｒＲＮＡ基因及２３ＳｒＲＮＡ基因而设计合成了两对引物并分别进行了ＰＣＲ扩增,扩增产物的２％琼脂糖凝胶电泳结果显示,硝化细菌ＤＮＡ模板得到了特异性扩增．参照分子量标准（Ｍａｒｋｅｒ）的电泳结果,被扩增的ＤＮＡ条带大小分别约为４００ｂｐ和７３０ｂｐ．实验结果表明ＰＣＲ技术可用于污水中硝化细菌的快速检测     

Synthesis and performances for treating oily wastewater produced from polymer flooding of new demulsifiers based on polyoxyalkylated N,N‐dimethylethanolamine

Usually, oily wastewater produced from polymer flooding (OWPF) was treated by cationic polymer in oilfield. In this paper, six block copolymers of ethylene oxide and propylene oxide were prepared by using N,N‐dimethylethanolamine (DMEA) as the acceptor (DMEA‐mnp and DMEA‐mnpq, n:m:p:q represented the weight ratio of different blocks). Most of DMEA products could perform well for treating OWPF, especially DMEA1231. Their performances were mainly affected by temperature. The reason of increasing oil removal performance of DMEA1231 with temperature was the decrease of interfacial dilational modulus (ε) with increasing temperature. When temperature raised up to 55°C, the ε of DMEA1231 had the minimum (1.5 l mN/m). Therefore, the OiW had the minimum (90 mg/l). Because DMEA1231 had the best performance, its flocculation kinetics was studied systemically. The results showed that the optimum condition for DMEA1231 was as follows: dosage was 300 mg/l, temperature was 55°C, stirring speed was 200 rpm and stirring time was 5 min. At last, the offshore oil field test was carried out to check the DMEA1231 performance. The result showed that at the optimum condition, DMEA1231 could perform as well as the cationic polymer. The most important thing was that flocs of DMEA1231 were not viscous and floated on the surface of the water. The results obtained by this paper provide a good choice for the treatment of OWPF in offshore oilfield to avoid the formation of viscous flocs. Copyright © 2014 John Wiley & Sons, Ltd.     

Synthesis of polyamidoamine dendrimer (PAMAM/CuS/AA) nanocomposite and its application in the removal of Isma acid fast yellow G Dye

The adsorption of Isma acid fast yellow G dye was studied using polyamidoamine (PAMAM)/Copper sulfide (CuS)/AA nanocomposite containing different amounts of CuS by batch technique. PAMAM dendrimer/CuS/AA nanocomposites were synthesized via gamma irradiation cross‐linking method with the aid of sonication. The nanocomposites were characterized by Fourier‐transform infrared, X‐ray diffraction, transmission electron microscope, energy dispersive spectroscopy X‐ray, thermal gravimetric analysis, ultraviolet‐visible, and fluorescence spectroscopy. The size of the CuS nanoparticles was formed in the range of 12–19 nm. The adsorption capacity of the nanocomposites was evaluated as a function of initial dye concentration, pH, adsorbent dosage, and time. It was verified that the adsorption rate fits a pseudo‐second‐order kinetics for initial Isma acid fast yellow G dye concentrations. Results indicated that the adsorption of Isma acid fast yellow G dye fitted well to the Langmuir model. Our results demonstrate that the PAMAM dendrimer/CuS/AA nanocomposite is very promising for removing organic dyes from wastewater. Copyright © 2015 John Wiley & Sons, Ltd.     

Electrocatalytic Determination of Hydroxylamine in the Presence of Thiosulfate in Water and Wastewater Samples Using a Nanostructure Modified Carbon Paste Electrode

In this research, we report the preparation of a high sensitive voltammetric sensor for electrocatalytic determination of hydroxylamine (HX) in the presence of thiosulfate (TS). We describe the synthesis and characterization of CdO nanoparticles (CdO/NPs) with transmission electron microscopy (TEM) and X‐ray diffraction (XRD) methods. At an optimum condition, the two peaks are separated ca. 0.58 and 0.92 V for HX and TS at the surface of the proposed sensor. Square wave voltammetry (SWV) of HX exhibited two linear dynamic ranges with a detection limit (3σ) of 0.06 µmol L^?1. The propose sensor was used for determination of HX in water samples.     

Suitability of dispersive liquid–liquid microextraction for the in situ silylation of chlorophenols in water samples before gas chromatography with mass spectrometry

Trace analysis of chlorophenols in water was performed by simultaneous silylation and dispersive liquid–liquid microextraction followed by gas chromatography with mass spectrometry. Dispersive liquid–liquid microextraction was carried out using an organic solvent lighter than water (n‐hexane). The effect of different silylating reagents on the method efficiency was investigated. The influence of derivatization reagent volume, presence of catalyst and derivatization/extraction time on the yield of the derivatization reaction was studied. Different parameters affecting extraction efficiency such as kind and volume of extraction and disperser solvents, pH of the sample and addition of salt were also investigated and optimized. Under the optimum conditions, the calibration graphs were linear in the range of 0.05–100 ng/mL and the limit of detection was 0.01 ng/mL. The enrichment factors were 242, 351, and 363 for 4‐chlorophenol, 2,4‐dichlorophenol, and 2,4,6‐trichlorophenol, respectively. The values of intra‐ and inter‐day relative standard deviations were in the range of 3.0–6.4 and 6.1–9.9%, respectively. The applicability of the method was investigated by analyzing water and wastewater samples.     

Liquid–liquid microextraction and spectrophotometric determination of anionic surfactants using Astra Phloxine FF

A novel and simple procedure for determination of anionic surfactants has been developed. The method is based on the reaction of sodium dodecyl sulphate (SDS) with Astra Phloxine FF reagent at pH 3–8, followed by liquid–liquid microextraction of the formed ion associate into an organic phase containing a mixture of carbon tetrachloride and dichloroethane (4:1, v/v) and subsequent UV-Vis detection at 555 nm. The calibration plot was linear in the range 0.006–0.29 mg L^?1 of SDS. The limit of detection (LOD), calculated based on 3s, is 0.002 mg L^?1. The method was applied to the determination of anionic surfactants in real wastewater samples.     

Deep eutectic solvent based magnetic nanofluid in the development of stir bar sorptive dispersive microextraction: An efficient hyphenated sample preparation for ultra‐trace nitroaromatic explosives extraction in wastewater

A deep eutectic solvent based magnetic nanofluid was coupled with stir bar sorptive dispersive microextraction as a hyphenated sample preparation technique. The neodymium core magnetic stir bar was coated physically with nanofluid of magnetic carbon nanotube nanocomposites and deep eutectic solvents. The prepared nanofluid has magnetic and strong sorbing properties and is compatible with gas chromatography. In this nanofluid, the deep eutectic solvent acts simultaneously as both carrier and stabilizer for magnetic nanotubes. The predominant experimental variables affecting the extraction efficiency of nitroaromatic compounds were evaluated. Under the optimized conditions, the limit of detection and enrichment factor were in the range of 0.2–4.9 ng/L and 852–1480, respectively. The relative standard deviations were between 5.6 and 10.2% (n  = 6). Method validation was performed by both spiking–recovery method and comparison of results with other methods. Finally, the proposed method was successfully applied for the extraction and pre‐concentration of nitroaromatic explosives in water samples, followed by determination by gas chromatography with micro‐electron capture detection.     

应用FTIR和~(13)C NMR表征制革废水处理过程的溶解性有机物特性

制革业是我国重要的工业门类,年废水排放量2亿t以上。制革废水中油脂、皮屑、胶原蛋白等大分子有机物含量较高,同时兼具高盐、高碱、高负荷的特点,已被相关部门列为重点监控的工业污染源。在制革废水的处理方面,不仅要关注进出水的水质参数,同时也要监测废水处理过程污染物的转化规律,以便为废水处理工艺的优化和废水处理设备的研发提供基本数据。溶解性有机物(DOM)广泛存在于各类水体中,是表征废水理化性质和净化程度的重要参数。目前,对于制革废水处理过程DOM性质的研究尚很欠缺。以此为切入点,采用元素分析、热重分析、红外光谱和核磁共振表征制革废水不同处理工段的DOM样品。研究发现:制革废水处理时间的延长导致DOM中C元素含量升高,H/C原子比先增加后降低,说明大分子有机物首先被分解为小分子链状结构,最终存在于水体的是极难降解的终极结构组分。DOM脂肪族化合物和蛋白组分的热解发生在第二阶段(110~530℃),第三阶段(530~800℃)主要完成芳环的降解或C—C键的断裂。废水原水DOM主要含有—OH,—NH2,CO等官能团,FTIR图谱证明了废水处理中后期高聚合度芳香族物质的存在,这是微生物新陈代谢作用的结果。DOM中烷基C含量先增加后减少,含量最大值(25.25%)出现在二级生化池;芳香C含量的最小值(28.28%)出现在二级生化池,而后迅速上升,暗示了废水处理过程含C官能团种类和数量的交替变化规律。对制革废水DOM性质的跟踪识别有助于从总体上推断污染物的净化机制。     

离子液体处理含油污水实验研究

合成出了适合于含油污水处理的憎水性离子液体,研究了离子液体对含油污水的处理条件。当离子液体与含油污水体积比为1∶5,pH值为5,处理15min后,水中油的去除率为95.6%,COD_Cr的去除率为93.5%,表明应用离子液体可以有效地去除油田采出水中的有机物。同时考察了再生离子液体对除油效果的影响,其五次平行实验的除油率达95.4%,COD_Cr去除率为93.2%,表明离子液体可以回收利用。在此基础上,分析了离子液体对含油污水处理的作用机理。