Voltammetry in Undiluted Acetic Acid. In Situ Determination of Water

Water present in undiluted acetic acid can be monitored in situ with Pt and Au microelectrodes using differential pulse and square‐wave voltammetries. Both reduction and oxidation peaks can be obtained. The best quantitative analytical results were obtained for the anodic peak, the Pt microelectrode, and differential pulse voltammetry. The anodic water peak is located at +1.55 V vs. the quasi reference Pt electrode. The voltammetric peak obtained at Pt electrode is apparently not a diffusional one, however, the calibration plot obtained by employing this peak is linear over a wide concentration range, up to 4 mol dm^?3. The detection limit has been estimated as 2.3 mM or 0.0043 v/v%. The developed method may be particularly useful, since the Karl Fischer method can not be used to determine water in glacial acetic acid due to the estrification reaction of acetic acid with methanol. A voltammetric wave of undiluted acetic acid could not be obtained in the positive and negative ranges of potential.     

Analysis of the pungent principles of ginger and grains of paradise by high-performance liquid chromatography using electrochemical detection

Summary The pungent principles of ginger and grains of paradise are examined using a reversed-phase HPLC column. An electrochemical detector is used to selectively detect the phenolic gingerols and shogaols. The retention indices of the compounds are compared using methanowater and acetonitrile-water as eluents.Presented at the 14th International Symposium on Chromatography London, September, 1982     

A study on the influence of anionic surfactants on electrochemical degradation of polyaniline

The influence of anionic surfactants on the electrochemical degradation of polyaniline (PANI), deposited by electro-polymerization onto platinum electrodes, was investigated in an aqueous medium by means of cyclic voltammetry. The degradation rate was found to be greatly dependent on the pH of the solution. The electrochemical degradation of PANI/dodecylsulfate and PANI/dodecylbenzenesulfonate films was compared with that of a PANI/hydrochloride film. The degradation rate in the two former cases decreased by some 50% compared to the PANI/hydrochloride film in aqueous solution at pH = 2. The results were confirmed with theoretical calculations performed on the evaluation of head group charge of surfactants, the distance of anions from PANI positive sites and the shielding of anions on PANI positive sites.     

Determination of Nonsteroidal Anti‐inflammatory Drugs in Serum by Microchip Capillary Electrophoresis with Electrochemical Detection

A simple and rapid method has been developed for the analysis of four nonsteroidal anti‐inflammatory drugs (NSAIDs) in serum using microchip capillary electrophoresis with pulsed amperometric detection. The selected NSAIDs (salicylic acid, acetaminophen, diflunisal, and diclofenac) are among the most commonly used drugs to treat fever, inflammation, and pain. Used above the therapeutic levels, these drugs can cause a wide variety of adverse effects and their fast analysis could have a significant impact in treatment and recovery of the patients. Several conditions, including separation potential, pH, and concentration of the electrolyte solution were studied to optimize the separation and detection. In this study, salicylic acid, acetaminophen, diflunisal, and diclofenac were separated in less than 2 minutes using a 5 mM borate buffer at pH 11.5 and a separation potential of +1200 V. Linear relationships were obtained between the concentration and peak current in the 0.5–15.3 μg/mL range and detection limits around 0.26 μg/mL. After 30 consecutive injections, the stability of both the response and migration time of the analytes showed relative related deviations of less than 4.6% and 1.0%, respectively. The potential of this method was verified by spiking a bovine serum sample with the four NSAIDs and analyzing the recovery ratio.     

A simple and regioselective α-bromination of alkyl aromatic compounds by two-phase electrolysis

Electrochemical bromination of toluene and substituted toluenes by two-phase electrolysis yields the corresponding α-brominated products. The reaction has been carried out in a single compartment cell with platinum electrodes at 0 °C in chloroform using an aqueous sodium bromide solution (60%) containing a catalytic amount of HBr. Two-phase electrolysis results in high yields (60-95%) of monobromo compounds with very high regioselectivity (>95%).     

Voltamperometric determination of kinetin with a carbon paste modified electrode

The electrochemical behaviour of kinetin (6-furfurylaminopurine) on a carbon paste modified with OV-17 silicone electrode, is studied. The determination of kinetin is possible working in square wave voltammetric techniques, reaching limits of determination of 38.7 ng ml⁻¹. The proposed method was successfully applied to determine the cytokinin in extracts of apples (previously spiked with kinetin) and the obtained results were in accordance with the results obtained with HPLC-UV.     

葡萄糖、半乳糖和乙醇恒电流氧化过程电位振荡的EQCM研究

采用电化学石英晶体微天平(EQCM)研究了0.5 mol•L^-1 NaOH水溶液中铂电极上葡萄糖、半乳糖和乙醇恒电流氧化过程中伴随的电位振荡行为. 两个糖体系的电位振荡过程伴随EQCM频率的同步振荡响应, 而乙醇体系中相应的频率响应却非常小；三个体系振荡过程的同步动态电阻响应均很小, 表明振荡过程频率响应主要为质量效应. 虽然葡萄糖和半乳糖结构相似, 电位和频率振荡的幅度相当, 但频率波数和周期明显不同, 表明电位振荡行为对两者呈现良好的分子识别能力. 本文也讨论了相关振荡机理和NaOH浓度效应及碱性介质中铂电极电化学过程, 提出了所形成的铂氧化物主要是PtO₂-3H₂O_ad以及两糖体系振荡过程中糖酸根阴离子伴随着高/低电位在铂电极上吸/脱附的新观点.     

Characterization of etched electrochemical detection for electrophoresis in micron inner diameter capillaries

An enhanced etched electrochemical (EC) detection technique has been developed for CE in micron inner diameter capillaries. The design improvements allow for better alignment between the capillary bore and the electrode. This new method involves utilizing a carbon fiber microelectrode and etching both the carbon fiber and the detection end of a micrometer-sized inner diameter capillary to limit dead volume and analyte diffusion at the amperometric EC detector. To understand the factors affecting enhanced detector efficiency, a detailed examination of the relationship between detector design and performance has been completed by exploring the effects of varying electrode diameter, tip shape, and size, in addition to the etch length of the capillary outlet. The enhanced detection provides peak efficiencies as high as 75000 theoretical plates and estimated detection limits as low as 40 nM for dopamine. This etched detection method should further facilitate volume-limited sample analysis by CE.     

Physical properties and electrochemical performance of LiMn2O4 cathode materials prepared by a precipitation method

LiMn₂O₄ powder for lithium-ion batteries was prepared by a precipitation method, and the effects of calcination temperature on the physical properties and electrochemical performance of the samples were investigated by various methods. The results of X-ray diffraction (XRD) showed that the lattice parameter (a) and the unit cell volume (v) decrease with the increasing calcination temperature, and the LiMn₂O₄ sample calcined at 750°C has smaller particle size and higher crystallinity than other samples. The results of the electrochemical experiments showed that the sample calcined at 750°C has larger peak currents, higher initial capacity, and better cycling capability, because of its lower charge-transfer resistance and larger diffusion coefficient of Li⁺ ions than those of other samples.     

The electrochemical interface between copper(111) and aqueous electrolytes

The electrochemical double layer between Cu(111) electrodes and aqueous electrolytes (F⁻ and SO²⁻₄ at various pH values) was studied by means of linear scan voltammetry and ac impedance measurements. It is found that electrochemisorption of oxygen species proceeds on the Cu(111) surface in the potential regions more negative than the electrodissolution potential of copper. The adsorption-desorption kinetics are analysed; the anodic and cathodic symmetry coefficients are found to be equal (α = β = 0.3), and the standard rate constant is k° = 4 × 10⁻¹⁰cm s⁻¹.