Ce0.6Zr0.35Y0.05O2和Pr0.6Zr0.35Y0.05O2催化剂表面上CO氧化和18O-16O交换反应的研究

测定了在Ce0.6Zr0.4O2,Ce0.6Zr0.35Y0.05O2,Pr0.6Zr0.4O2和Pr0.6Zr0.35Y0.05O2 (分别表示为CZ,CYZ,PZ和PYZ)样品表面上的CO氧化反应和18O-16O 同位素交换反应.结果表明: 在CZ和PZ系列固熔中掺杂Y3 离子可以改善晶格氧的迁移速度;PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.其原因是将Y3 掺杂到Ce0.6Zr0.4O2 或Pr0.6Zr0.4O2晶格中,增加了样品的氧空位浓度,从而提高了晶格氧的迁移性质,而PrOx比CeO2具有更低温度的氧化还原性质,因此PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.     

Mass spectrometric analysis of ceramic components for solid oxide fuel cells

For the determination of trace impurities in ceramic components of solid oxide fuel cells (SOFCs), some mass spectrometric methods have been applied such as spark source mass spectrometry (SSMS), laser ionization mass spectrometry (LIMS), laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) and inductively coupled plasma mass spectrometry (ICP-MS). Due to a lack of suitable standard reference materials for quantifying of analytical results on La _x Sr _y MnO₃ cathode material a matrix-matched synthetic standard-high purity initial compounds doped with trace elements-was prepared in order to determine the relative sensitivity coefficients in SSMS and LA-ICP-MS. Radiofrequency glow discharge mass spectrometry (rf-GDMS) was developed for trace analysis and depth profiling of thick non-conducting layers. Surface analytical techniques, such as secondary ion mass spectrometry (SIMS) and sputtered neutral mass spectrometry (SNMS), were used to determine the element distribution on surfaces (homogeneity) and the surface contaminants of SOFC ceramic layers.Dedicated to Professor Dr. rer. nat. Hubertus Nickel on the occasion of his 65th birthday     

聚苯乙烯—钛酸钡复合材料介电性能的研究

以聚苯乙烯与化学沉淀法钛酸钡陶瓷为基本组成，采用溶液共混，溶液聚合，表面处理后溶液聚合三种方法进行复合，发现后两种复合的钛酸钡颗粒表面发生界面变化，形成活性界面，使得溶液聚合法和表面处理后溶液聚合所得到的材料具有较低的介电损耗，在高频下能保持较高的介电系数。     

Far infrared spectra of solid molecular nitrogen

This paper reports the observation of the far infrared absorption spectrum of a single crystal of N₂, measured over absorption paths of 4 cm (lengthwise) and 2 cm (across the crystal). The crystal chamber, with quartz windows, was immersed in a flow of cold helium gas. The spectrum from 20 to 120 cm^–1 was recorded in the liquid phase, the-phase, and over the full temperature range of the-phase (35.6–2.0 K) with a Fourier transform spectrometer. The spectral resolution, which was not instrument-limited, and the large path allowed the observation of more detailed multiphonon-transition structure in the spectrum of the-phase than has previously been observed.     

CeO2—LnO1.5固溶体的表征及其甲烷催化燃烧性能

向CeO2中引入Ln3 离子后形成的CeO2－LnO1.5（Ln=La，Nd，Sm，Gd）固溶体（n（Ce）：n（Ln）=1：1）是一种无贵金属的新型高效甲烷燃烧催化剂．比表面、XRD、Raman、TEM等分析证实，这类固溶体具有部分畸变的萤石结构，Ln3 进入晶格后诱发的结构变化使得团溶体的表面和本体能同时参与氧化还原反应．实验表明，该固态溶液体系是甲烷催化燃烧的良好催化剂．     

Solid Phase Extraction and Flame Atomic Absorption Spectrometric Determination of Trace Amounts of Zinc and Cobalt Ions in Water Samples

A simple and rapid method for the preconcentration of Co²⁺ and Zn²⁺ as their 2-guanidino-benzimidazole chelates is proposed using an octadecyl silica cartridge. The retained analytes were recovered with a mixture of 5mL of 0.01M HNO₃ and 5mL of methanol. The metal ions in the effluent were determined by flame atomic absorption spectrometry. The effect of different parameters, such as sample matrix, amount of ligand, type of eluent for elution of ions from cartridge, flow rates of sample solution and eluent, breakthrough volume, and limit of detection, were evaluated. The effects of various cationic and anionic interferences on the percent recovery of Co²⁺ and Zn²⁺ were also studied. Quantitative extraction efficiencies were obtained by elution of the cartridge with a minimal amount of solvent. Hence, with a typical preconcentration factor of 50, the limits of detections of the proposed method are 0.26 and 1.62ngmL^–1 for Zn²⁺ and Co²⁺, respectively. The method was applied to the determination of zinc and cobalt ions in different water samples.     

Al2O3／WO3／ZrO2固体强酸催化剂对正丁烷异构化的催化性能

 通过沉淀、回流、浸渍和焙烧等步骤制备了Al2O3／WO3／ZrO2固体强酸催化剂．采用XRD，N2吸附，UV－Vis光谱，NH3－TPD和H2－TPR等技术测定了Al2O3对WO3／ZrO2催化剂的结构、表面酸性、氧化还原性及正丁烷异构化反应性能的影响．结果表明，在WO3／ZrO2中引入适量的Al2O3对其表面酸强度及酸量无显著影响，但可使催化剂中的ZrO2组分以稳定的四方相形式存在，并能有效地抑制催化剂中WO3的聚集长大，从而提高催化剂的稳定性和正丁烷异构化的转化率和选择性．添加铂于Al2O3／WO3／ZrO2中可进一步提高其催化性能．还考察了催化剂的焙烧温度、Al含量、反应温度和反应气氛对正丁烷异构化反应的影响．     

Novel composite anode materials for lithium ion batteries with low sensitivity towards humidity

Graphitic anode materials for lithium ion batteries processed under high humidity conditions show severe performance losses. The sensitivity of these materials towards humidity can be significantly reduced by adsorbing metal ions like silver or copper ions, with subsequent heat treatment of these composites. Results of X-ray photoelectron spectroscopy, high-resolution electron microscopy, thermogravimetry, and differential thermal analysis indicate that the deposited metals exist in metallic and carbide, M_xC (M=Cu or Ag), forms. They remove or cover (i.e. deactivate) active hydrophilic sites at the surface of the graphite. These composites absorb less water during processing. The electrochemical performance, including reversible capacity, coulombic efficiency in the first cycle, and cycling behavior, is markedly improved. This approach provides a potentially powerful method to manufacture lithium ion batteries under less demanding conditions.Presented at the 3rd International Meeting on Advanced Batteries and Accumulators, 16–20 June 2002, Brno, Czech Republic     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

MCM-41-HY复合分子筛的合成及其在深度加氢脱硫中的应用

在水热条件下合成了包覆型MCM-41-HY复合分子筛.采用XRD、N2气吸附和SEM等方法对其进行了表征.结果表明,MCM-41-HY复合分子筛和MCM-41与H型Y沸石(HY)的机械混合物明显不同,在复合分子筛MCM-41-HY中,中孔相MCM-41附晶生长在HY沸石上,将HY包覆起来.以二苯并噻吩为模型化合物,考察了该材料担载NiMo催化剂的加氢脱硫活性.结果表明,MCM-41-HY复合分子筛与MCM-41和HY的机械混合物担载NiMo催化剂的加氢脱硫(HDS)活性相当,但MCM-41-HY复合分子筛担载NiMo催化剂的裂化活性较低.其裂化活性不同的原因在于其载体孔道结构和酸性位的分布不同.