基于吸收系数的生脉注射液中聚山梨酯80含量测定新方法

聚山梨酯80又名吐温80，为一种亲水型非离子表面活性剂，是食品、保健品和药品中常用的辅料，作为增溶剂和澄清剂广泛用于中药注射剂。近年来，不良反应的发生使得聚山梨酯80的质量和应用愈加受到重视，有研究认为其加入可能引起注射剂不良反应增加。为避免超量使用，有必要对该辅料的投料加以严格控制。中药注射剂中聚山梨酯80的含量测定是当下研究的热点和难点，可以通过分光光度法、分子排阻-蒸发光散射检测法(SEC-ELSD)、液质联用法(LC-MS)直接测定，也可以水解后法经液相色谱-紫外检测法(HPLC-UV)或气相色谱法(GC)间接测定。但由于聚山梨酯80为聚氧乙烯聚合数目不同的混合物、不同厂家生产的聚山梨酯80化学组分及比例存在较大差异，难以采用统一的转换公式或对照品准确定量。此外，中药注射剂的复杂基质造成的假阳性干扰也对定量提出了挑战。为解决以上问题，以生脉注射液为例，提出基于吸收系数的中药注射剂中聚山梨酯80含量测定新方法。优化检测波长、显色剂种类、液液萃取过程振荡和静置时间，在6个不同品牌仪器上测得聚山梨酯80-硫氰酸钴配合物的吸收系数(E1%_{1 cm})为104.23，相对标准偏差(RSD)为2.08%。生脉注射液稀释10倍后，精密量取供试品溶液1.0 mL，精密加入硫氰酸钴溶液10 mL，二氯甲烷20 mL，涡旋振荡3 min。将混合液移至分液漏斗中，静置30 min，取下层二氯甲烷液，将前1 mL弃去，接收约15 mL，在320 nm处测定吸光度，再根据Lambert-Beer定律，利用获得的吸收系数计算得到聚山梨酯80的含量。方法阴性无干扰，精密度和重复性相对标准偏差均低于3%，平均回收率为98.42%。为进一步验证方法的准确性，分别采用吸收系数法和标准曲线法测定了2个厂家的10批生脉注射液，并与实际投料量比较。配对t检验结果表明，当置信度为95%时，两种方法无显著性差异，吸收系数法测得结果与企业生产中聚山梨酯的实际投料量也无显著性差异。研究采用前人未采用的、灵敏度更高的320 nm为检测波长，显著降低了基质干扰，克服了中药注射剂中聚山梨酯80测定结果与实际投料量难以吻合的问题。吸收系数法无需使用对照品，亦不用制备标准曲线，可为中药注射剂中聚山梨酯80的检查标准提供切实可行的解决方案。所建方法灵敏、准确、快速、简便，为含聚山梨酯80制剂的质量控制提供了关键常数及新的思路。     

Dinuclear gold (I)-di-N-heterocyclic carbene complexes: syntheses,structure, density functional theory calculation and photoluminescence study

The synthesis and characterizations for a series of dinuclear gold (I)-di-NHC complexes, 1–8 through the trans-metalation method of their respective silver (I)-di-NHC complexes, i–viii are reported (where NHC = N-heterocyclic carbene). The successful complexation of a series of unusual non-symmetrical and symmetrical di-NHC ligands, 3,3'-(ethane-1,2-diyl)-1-alkylbenzimidazolium-1'-butylbenzimidazolium (with alkyl = methyl, ethyl, propyl, butyl, pentyl, hexyl, heptyl, benzyl) with the gold (I) ions are suggested by elemental analysis, Fourier transform-infrared, ¹H- and ¹³C-NMR data. The ¹³C-NMR spectra of 1–8 show a singlet sharp peak in the range of 190.00–192.00 ppm, indicating the presence of a carbene carbon that bonded to the gold (I) ion. From single crystal X-ray diffraction data, the structure of complex 6 with the formula of [di-NHC-Au (I)]₂·2PF₆ is obtained [where NHC = 3,3'-(ethane-1,2-diyl)-1-hexylbenzimidazolium-1'-butylbenzimidazolium]. The photophysical study in solid state of 6 displays an intense photoluminescence with a strong emission maxima, λ_em = 480 nm, upon excitation at 340 nm at room temperature. Interestingly, the emission maximum at 77 K shows a structural character with a strong peak at 410 nm, a medium at 433 nm and a weak at 387 nm, accompanied by a tail band to about 500 nm.     

New organoruthenium metallates containing ferrocenecarboxalidine thiosemicarbazones and their nucleic acid/albumin binding and in vitro cytotoxicity

A string of four new hetero binuclear Ru(III) complexes of ferrocenecarboxaldehyde-4(N)-substituted thiosemicarbazones were synthesized and characterized by various spectral (infrared, ultraviolet–visible, Electron Paramagnetic Resonance (EPR) and High Resolution Mass Spectrometry (HR-MS) techniques. The binding abilities of the ligands/complexes with nucleic acid (calf thymus DNA, CT-DNA) and bovine serum albumin (BSA) were analyzed by absorption and emission titration methods. The complexes exhibited better DNA binding affinity than their parent ligands. The interaction with CT-DNA was found to be intercalative and with BSA static quenching mechanism was observed. All the synthesized Ru(III) complexes were subjected to study their in vitro cytotoxicity against MCF-7 (human breast cancer) and HT-29 (human colon cancer) cell lines. Among the four complexes, complex 3 [RuCp (FF-etsc)PPh₃]Cl exhibited the highest cytotoxicity in MCF-7 cells and complex 4 [RuCp (FF-ptsc)PPh₃]Cl was the most active on HT-29 cells.     

Et2Zn-mediated stoichiometric C(sp)-H silylation of 1-alkynes and chlorosilanes

A first example of an Et₂Zn mediated silylation of 1-aklynes is reported. A series of functional groups are tolerated in this reaction. Mechanistic studies support Zn alkynilides as intermediates in the reaction. This reaction protocol provides a practical method for the preparation of alkynylsilanes and expands the application of organometallic zinc in organic synthesis.     

Sensitive chemically amplified electrochemical detection of ruthenium tris-(2,2′-bipyridine) on tin-doped indium oxide electrode

Optimized combination of chemical agents was selected for sensitive electrochemical detection of dissolved ruthenium tris-(2,2′-bipyridine) (Ru-bipy). The detection was based on the chemical amplification mechanism, in which the anodic current of a redox-active analyte was amplified by a sacrificial electron donor in solution. On indium-doped tin oxide (ITO) electrodes, electrochemical reaction of the analyte was reversible, but that of the electron donor was greatly suppressed. Several transition metal complexes, such as ferrocene and tris-(2,2′-bipyridine) complexes of osmium, iron and ruthenium, were evaluated as model analyte. A correlation between the amplified current and the standard potential of the complex was observed, and Ru-bipy generated the largest current. A variety of organic bases, acids and zwitterions were assessed as potential electron donor. Sodium oxalate was found to produce the largest amplification factor. With Ru-bipy as the model analyte and oxalate as the electron donor, the analyte concentration curve was linear up to 50 μM, with a lower detection limit of approximately 50 nM. Preliminary work was presented in which a Ru-bipy derivative was attached to bovine serum albumin and detected electrochemically. Although the combination of Ru-bipy, oxalate and ITO electrode has been used before for electrochemiluminescent detection of Ru-bipy and oxalate, as well as electrochemical detection of oxalate, its utility in amplified voltammetric detection of Ru-bipy as a potential electrochemical label has not been reported previously.     

两个DEA的逆问题的解法的探讨

文[1]提出了两个DEA的逆问题，并用搜索法来解．而本文根据所证的定理，对每个问题一般只要解二、三个线性规划问题就能得到答案．     

Rigidity and flexibility of virtual polytopes

All 3-dimensional convex polytopes are known to be rigid. Still their Minkowski differences (virtual polytopes) can be flexible with any finite freedom degree. We derive some sufficient rigidity conditions for virtual polytopes and present some examples of flexible ones. For example, Bricard's first and second flexible octahedra can be supplied by the structure of a virtual polytope.     

Activation of peroxyl and molecular oxygen using bis -benzimidazole diamide copper (II) compounds

New tetradentatebis-benzimidazole ligands have been synthesized and utilized to prepare copper (II) complexes. Some of these copper (II) complexes have been characterized structurally. The copper (II) in these complexes is found to possess varying geometries. A distorted octahedral geometry is found with a highly unsymmetrical bidentate nitrate group. An unusual polymeric one-dimensional structure is observed where copper (II) is in a distorted square pyramidal geometry with a monodentate nitrate ion, having long Cu-O bond, while a distorted triagonal bipyramidal geometry is found with two carbonyl O atoms and a Cl atom in the equatorial plane, and two benzimidazole imine N atoms occupy the axial position. These compounds are found to activate the cumylperoxyl group, and this has been utilized in the facile oxidation of aromatic alcohols to aldehydes, where they act as catalysts with large turnovers. The yields of the respective products vary from 32 to 65%. The role of molecular oxygen has been studied and an attempt has been made to identify the “active copper species”. Activation of molecular oxygen has also been observed and has been used for oxidative dealkylation of a hindered phenol, producing di-butyl quinones with yields of 20–25% and 10–12 fold catalytic turnover. Dihydroxybenzenes and substituted catechols are also readily oxidized to the corresponding quinones, in oxygen-saturated solvents. Yields of 84% have been observed with 34-fold catalyst turnover, with di-t-butylcatechol. The activity of these copper (II) —bis-benzmidazolediamide compounds is reminiscent of the functioning of copper centres in galactose oxidase, tyrosinase and catechol oxidase.     

Viscoelastic properties of amorphous polymers 3: low molecular weight poly(methylphenylsiloxane)

By making creep and recoverable creep measurements of a nearly monodisperse low molecular weight poly(methyl phenyl siloxane) sample, we have found on decreasing temperature towardsT _g that there is continuously a change in the viscoelastic spectrum concomitant with a decrease of the steadystate recoverable compliance. This behavior is exactly the same as previously observed in low molecular weight poly(styrene), proving that this spectacular anomaly in the viscoelasticity of low molecular weight polymers is general and deserves an explanation. Photon correlation spectroscopic measurements performed on the same sample have extended the observation of the viscoelastic response to shorter times and the result corroborates the trend of variation established by the creep data.Dedicated to Prof.Dr. E. W. Fischer on his 65th Birthday. Prof.Dr. Fischer is known for his valuable contribution to fosterine, international collaboration of research in polymer science. This work is an example of his contribution because it would not be possible without him bringing us together. One of us (KLN) would like to take this opportunity to thank Prof. Dr. Fischer for his unwaiving support of the 1st (Crete) and the 2nd (Alicante) International Discussion Meeting on Relaxations in Complex Systems