Application of microcrystalline cellulose as an efficient and cheap sorbent for the extraction of metoprolol from plasma and wastewater before HPLC–MS/MS determination

A dispersive solid-phase extraction method based on a new sorbent has been performed on plasma and wastewater samples to determine metoprolol by high-performance liquid chromatography–tandem mass spectrometry. In this study, the analyte was adsorbed from the samples onto microcrystalline cellulose as a green and efficient sorbent and then eluted for use in the determination step. In the mass spectrometer, the analyte was detected in the positive mode and selectivity of the analysis was increased by sequential mass analysis through multiple reaction monitoring. All of the effective parameters in the extraction of metoprolol from plasma and wastewater were optimized. Under optimal conditions the method was linear in the ranges of 1–1,000 and 0.1–1,000 ng/ml in plasma and wastewater samples, respectively. The detection limits of the method were 0.30 and 0.03 ng/ml in plasma and wastewater samples, respectively. The data showed that the method provides low detection limit, wide linear range, good precision and high extraction recovery. Finally several plasma and wastewater samples were successfully analyzed using the method. The use of a small amount of a green and inexpensive sorbent and a low volume of plasma without the need for further pretreatment steps are the main advantages of the method.     

Trends in the detection of pharmaceuticals and endocrine-disrupting compounds by Field-Effect Transistors (FETs)

Field-effect transistors (FETs) are one of the most widely-used electronic sensors for continuous monitoring and detection of contaminants such as pharmaceuticals and endocrine-disrupting compounds at low concentrations. FETs have been successfully utilized for the rapid analysis of these environmental pollutants due to their advantageous material properties like the disposability, rapid responses and simplicity. This paper presented an up-to-date overview of applied strategies with different bio-based materials in order to enhance the analytical performances of the designed sensors. Comparison and discussion were made between characteristics of recently engineered FET bio-sensors used for the detection of famous and selected pharmaceutical compounds in the literature. The recent progress in environmental research applications, comments on interesting trends, current challenge for future research in endocrine-disrupting chemicals’ (EDCs) detection using FETs biosensors were highlighted.     

从废水到新能源:光催化燃料电池的优化与应用

随着经济的飞速发展,社会对能源的需求日益扩大,对工业废水的无害化处理也提出了更高的要求。光催化燃料电池 (photocatalytic fuel cell, PFC) 在燃料电池中引入半导体光催化材料作为电极,实现了有机污染物高效降解和同步对外产电的双重功能,在废水无害化与资源化利用方面具有潜在的应用价值。半导体光催化电极是PFC系统高效运行的核心组件,增强其可见光响应和光生载流子分离是提高PFC性能的关键策略。反应器结构设计和运行参数优化也有利于改善PFC性能。本文从PFC基本原理和应用入手,综述了PFC在环境污染物资源化处理中的研究进展,并详细阐述了提高PFC的污染控制性能和产电效率的优化手段,为进一步设计高效稳定的PFC系统并实现其在水污染控制和清洁能源生产中的应用提供理论指导。     

Surface and interfacial properties of PVDF/acrylic copolymer blends before and after UV exposure

Morphological and chemical properties of both the surface and interface of poly(vinylidene fluoride)/poly(methyl methacrylate)-co-poly(ethyl acrylate) (PVDF/PMMA-co-PEA) blend films have been investigated before and after the samples were exposed to ultraviolet (UV) irradiation using a xenon arc lamp at 50 °C and 9% relative humidity (RH) for 7 months. Surface and interfacial morphologies were studied by atomic force microscopy (AFM). Chemical composition information was obtained by confocal Raman microscopy, attenuated total reflection-FTIR spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS), and contact angle measurements. Results show an enrichment of the PVDF material at the air surface, while the acrylic copolymer enriches the interface. Blends having greater than 50% mass fraction of PVDF show little change in the surface morphology after UV exposure for 7 months. However, for a lower PVDF content, blends exhibit significant degradation of PMMA-co-PEA copolymer and a much rougher surface after UV exposure. Microstructural changes in the PVDF spherulites are also observed after UV degradation. It is found that the surface and interfacial morphologies are correlated with the chemical properties.     

着生刚毛藻处理富营养化湖泊水

分别研究了室内和露天条件下在鹅卵石上着生的刚毛藻Cladophora oligoclona对富营养化湖水中氮(N)和磷(P)的净化效果及其对水华藻类生长的抑制能力,同时对处理后湖水的藻类生长潜力进行了测试.结果显示,刚毛藻在原始浓度总氮(TN)10.512 mg/L和总磷(TP)0.856 mg/L的富营养化湖水中能维持正常的生长代谢,并能有效去除水体中的N、P养分.在室内12 d培养期间,刚毛藻对TN、氨氮(NH4-N)、TP和无机磷(PO4-P)的平均去除率分别达53.13%,44.40%,35.71%和30.53%.在室外6 d培养期间,刚毛藻对TN、NH4-N、TP和PO4-P的日均减少量分别为1.643 5±0.413 9,1.350 3±0.352 4,0.113 7±0.041 1,0.074 2±0.033 0 mg/L,总去除率分别高达93.81%,94.62%,79.67%和77.66%.刚毛藻对水华微囊藻生长的抑制率达99.63%,处理后湖水的藻类生长潜力较原湖水下降了40.17%.据此认为,刚毛藻在净化污染水体、修复受损湖泊及防治水体富营养化等方面具有潜在的应用前景.     

高固体分羟基丙烯酸树脂的合成

以过氧化二苯甲酰（BPO）／过氧化二异丙苯（DCP）（质量比为2：3）为复合引发剂，二甲苯为溶剂，选用适量含羟基单体和分子量调节剂，以减缓树脂合成聚合反应中的自动加速现象，合成了分子量为3000-4000，多分散性指数d〈2的高固体分羟基丙烯酸树脂．该树脂与缩二脲多异氰酸酯（HDI）的配漆实验证明，所得漆膜鲜映性好、丰满度高、色泽好、雾影值低、综合性能较好．     

功能性丙烯酸/MBAM体系共聚产物的研制

以丙烯酸和MBAM为主要原料，经聚合，合成了一种高性能的具有良好保水性能的聚合产物，其保水量达到750～1000倍．50℃以下有良好的保水性能，28℃以下有极好的保水性能，并研究了工艺条件对该产品性能的影响因素．     

Hydrophilic and hydrophobic copolymer systems based on acrylic derivatives of pyrrolidone and pyrrolidine

This article deals with the synthesis of hydrophilic methacrylic monomers derived from ethyl pyrrolidone [2‐ethyl‐(2‐pyrrolidone) methacrylate (EPM)] and ethyl pyrrolidine [2‐ethyl‐(2‐pyrrolidine) methacrylate (EPyM)] and their respective homopolymers. For the determination of their reactivity in radical copolymerization reactions, both monomers were copolymerized with methyl methacrylate (MMA), the reactivity ratios being calculated by the application of linear and nonlinear mathematical methods. EPM and MMA had ratios of r_EPM = 1.11 and r_MMA = 0.76, and this indicated that EPM with MMA had a higher reactivity in radical copolymerization processes than vinyl pyrrolidone (VP; r_VP = 0.005 and r_MMA = 4.7). EPyM and MMA had reactivity ratios of r_EPyM = 1.31 and r_MMA = 0.92, and this implied, as for the EPM–MMA copolymers, a tendency to form random or Bernoullian copolymers. The glass‐transition temperatures of the prepared copolymers were determined by differential scanning calorimetry (DSC) and were found to adjust to the Fox equation. Total‐conversion copolymers were prepared, and their behavior in aqueous media was found to be dependent on the copolymer composition. The swelling kinetics of the copolymers followed water transport mechanism case II, which is the most desirable kinetic behavior for a swelling controlled‐release material. Finally, the different states of water in the hydrogels—nonfreezing water, freezing bound water, and unbound freezing water—were determined by DSC and found to be dependent on the hydrophilic and hydrophobic units of the copolymers. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 395–407, 2003     

甜菜糖蜜酒精废液生产菌体蛋白饲料初探

甜菜糖蜜酒精废液含有大量的有机物，pH值低，BOD、CDO值高，直接排和会造成环境的严重污染，又损失了一些有机物，在此废液中可直接接入酵母菌，使其大量繁殖，生产出的菌体粗蛋白含量达41．7％，CDO值降低了20％以上，减轻了环境污染。     

活性污泥法处理城市污水中鼓风和纯氧两种曝气方法的比较

对活性污泥法处理城市污水中鼓风曝气和纯氧（或富氧）曝气这两种方法，从曝气设备结构、特点、工艺技术指标、运行管理及经济性等方面进行了分析和比较。