有机锆交联剂的制备及其性能

随着油田深部调剖应用的不断推广，以及环保要求的提高，适用于深部调剖调驱体系的低污染有机锆交联剂逐渐受到关注。以ZrOCl₂·8H₂O、乳酸、乙二胺、硫脲为原料，制备了有机锆交联剂和HPAM-锆交联凝胶，其结构和性能经SEM和岩心驱替装置表征。并利用正交实验法优化了制备条件。结果表明：制备有机锆交联剂的最佳条件为：氧氯化锆、乳酸、乙二胺及硫脲的质量比为7.8/1/6.7/5，反应温度为70 ℃，反应时间为3 h。交联温度为60 ℃，HPAM浓度为2 g·L^-1、聚锆比为30/1时，聚合物凝胶成胶强度达到24968 mPa·s，成胶时间约8 h，凝胶体系可维持90 d不破胶。在级差为3.9的双管驱替岩心实验中，两管的岩心分流率均接近50%，剖面改善率达到66.77%。     

CBMT测井数值模拟及水泥环第二界面成像

目前针对第一界面的固井质量评价技术已经很成熟,但第二界面固井质量评价仍存在很多问题.该文在中海油服自主研发的扇区水泥胶结成像测井仪器CBMT基础上,采用反褶积等算法,对数值模拟的CBMT仪器贴井壁测量的全波波形进行水泥环第二界面成像处理,并分析第一界面、第二界面不同胶结情况下的成像效果.通过成像分析得出,在水泥环第一界...     

改性超支化破乳剂的合成及其破乳性能评价

采用新癸酰氯(C₁₀H₁₉CIO)对超支化聚乙烯亚胺(HPEI)进行改性,合成了双亲性超支化破乳剂HPEI-C₁₀,并对其化学组分、热稳定性及润湿性进行了表征。考察了破乳剂的质量浓度、破乳温度、沉降时间以及pH对HPEI和HPEI-C₁₀的破乳效率的影响,并借助偏光显微镜观察破乳过程。结果表明：在质量浓度为50 mg·L^-1、破乳温度为20℃、沉降时间为30 min以及pH为6的条件下,HPEI-C₁₀破乳效率可达91.95%。HPEI-C₁₀在破乳温度为20～60℃时的破乳效率均大于90.00%。与HPEI相比,HPEI-C₁₀具有添加量少、适用温度范围广和沉降时间短等优势,为HPEI-C₁₀的广泛应用提供了数据支撑。     

Displacement of yield-stress fluids in a fracture

We consider a displacement of several yield-stress fluids in a Hele-Shaw cell. The topic is relevant to the development of a model for the flow of multiple phases inside a narrow fracture with application to hydraulically fracturing a hydrocarbon-bearing underground formation. Existing models for fracturing flows include only pure power-law models without yield stress, and the present work is aimed at filling this gap. The fluids are assumed to be immiscible and incompressible. We consider fluid advection in a plane channel in the presence of density gradients. Gravity is taken into account, so that there can be slumping and gravitational convection. We use the lubrication approximation so that governing equations are reduced to a 2D width-averaged system formed by the quasi-linear elliptic equation for pressure and transport equations for volume concentrations of fluids. The numerical solution is obtained using a finite-difference method. The pressure equation is solved using an iterative algorithm and the Multigrid method, while the transport equations are solved using a second-order TVD flux-limiting scheme with the superbee limiter. This numerical model is validated against three different sets of experiments: (i) gravitational slumping of fluids in a closed Hele-Shaw cell, (ii) viscous fingering of fluids with a high viscosity contrast due to the Saffman–Taylor (S–T) instability in a Hele-Shaw cell at microgravity conditions, (iii) displacement of Bingham fluids in a Hele-Shaw cell with the development of fingers due to the S–T instability. Good agreement is observed between simulations and laboratory data. The model is then used to investigate the joint effect of fingering and slumping. Numerical simulations show that the slumping rate of yield-stress fluid is significantly less pronounced than that of a Newtonian fluid with the same density and viscosity. If a low-viscosity Newtonian fluid is injected after a yield-stress one, the S–T instability at the interface leads to the development of fingers. As a result, fingers penetrating into a fluid with a finite yield stress locally decrease the pressure gradient and unyielded zones develop as a consequence.     

黏弹性聚合物溶液在突扩孔道内的流动特性

采用上随体Maxwell本构方程,描述油藏条件下以第一法向应力差为主要特征的聚合物溶液的流变性.利用有限体积法对黏弹性聚合物溶液在突扩孔道内的流动特征进行数值模拟.绘制了流函数和速度的等值线图.研究了黏弹性的变化对微观波及效率的影响.数值模拟结果表明,聚合物溶液的黏弹性是影响波及效率的主要因素.凹角处的流动区域随着弹性的增加在不断增大,因此滞留区域不断减小,微观波及效率不断增大.具有黏弹特性的聚合物溶液相比于纯黏性的牛顿流体更利于提高驱油效率.这一结论有助于驱油工业上聚合物溶液的设计和优选.     

超声脉冲窄带激励的水泥环第二界面探测方法*

如何评价水泥环的第二界面固井质量一直是声波测井领域的世界性难题。本文利用有限元方法研究了基于超声脉冲反射法的水泥环第二界面固井质量探测方法。数值模拟了不同声源脉冲宽度及不同声阻抗地层对第二界面超声反射回波的影响。研究结果表明采用窄带的激励信号源可有效的提高水泥环第二界面反射波回波幅度,有望解决水泥环第二界面固井质量评价问题。制作了水泥环第二界面具有胶结缺陷的实验室样品及大型固井质量刻度井,在此基础上开展了基于窄带超声脉冲激励的实验室及刻度井群实验研究。实验结果表明满足水泥环第一界固井质量良好条件,采用窄带的超声脉冲回波技术可有效评价水泥环第二界面固井质量。     

Bactericidal effect of an electrodialysis system on E. coli cells

Using a new electrodialysis system with both cation- and anion-exchange membranes, the bactericidal effect on Escherichia coli has been investigated in detail from the standpoint of electrochemistry. Various electrolyte solutions containing E. coli (10⁸ cells/cm³) were passed through a desalting chamber at a flow rate of 3 cm³/min under varying current densities, and the viability of the cell (%) and the pH changes in the effluents were measured. When a 0.1 M NaCl aqueous suspension was used, a disinfection effect emerged in the vicinity of the limiting current density (LCD 0.81 A/dm²) and increased with an increase in the current density. The pH value of the suspensions decreased owing to the dissociation of water to H⁺ and OH⁻ ions by the well-known “neutrality disturbance phenomenon” in the region beyond the LCD. These tendencies were also observed when other electrolyte suspensions were used. Concerning the effect of the various species on the disinfection of E. coli cells, ionic systems in which a LCD was easily attained were found to have a strong effect.The germicidal effect may be due to a synergistic effect of acidic H⁺ and basic OH⁻ ions which are produced on the anion-exchange membrane and cation-exchange membrane, respectively, of the desalting chamber.     

含O2高温高压CO2环境中3Cr钢腐蚀产物膜特征

采用高温高压反应釜分别开展3Cr钢在CO2和O2共存、单独CO2和单独O2三种气体条件下的腐蚀实验,利用X射线衍射仪(XRD)、扫描电子显微镜(SEM)、能量色散X射线能谱(EDS)和电化学方法研究了3Cr钢在高温高压含有O2的CO2环境中的腐蚀产物膜特征.结果表明,在含有O2的CO2的条件下,3Cr钢表面腐蚀产物膜疏松多孔,主要成分为FeCO3、Fe3O4和Fe2O3,腐蚀产物中未见明显Cr元素富集,3Cr钢表现出点蚀的腐蚀形态.3Cr钢在高温高压含O2的CO2腐蚀条件下内外膜层电阻(Rf1、Rf2)和电荷传递电阻Rt均比仅含有CO2腐蚀环境的低,双电层电容(Cdl)和内外膜层电容(Cf1、Cf2)均比仅含有CO2腐蚀环境的高.含有O2的CO2条件下,其保护性显著低于单一CO2条件下形成的腐蚀产物膜.提出了在含O2的CO2气体条件下,3Cr钢表面存在由多种物质组成的腐蚀产物,这导致腐蚀产物疏松多孔,不会形成单一CO2条件下存在的显著提高腐蚀产物膜保护性的Cr(OH)3层,从而促进了3Cr钢的析氢腐蚀和酸性介质中的吸氧腐蚀的机理.     

Unsteady longitudinal flow of a generalized Oldroyd-B fluid in cylindrical domains

Considering a fractional derivative model the unsteady flow of an Oldroyd-B fluid between two infinite coaxial circular cylinders is studied by using finite Hankel and Laplace transforms. The motion is produced by the inner cylinder which is subject to a time dependent longitudinal shear stress at time t = 0⁺. The solution obtained under series form in terms of generalized G and R functions, satisfy all imposed initial and boundary conditions. The corresponding solutions for ordinary Oldroyd-B, generalized and ordinary Maxwell, and Newtonian fluids are obtained as limiting cases of our general solutions. The influence of pertinent parameters on the fluid motion as well as a comparison between models is illustrated graphically.     

基于MPC8270的处理器板卡设计

随着海洋地震勘探发展,为了实现海洋地震勘探采集数据的实时传输和处理,设计了一种基于MPC8270的地震数据采集处理板卡;根据海洋地震数据采集处理的实时性和大数据量要求以及MPC8270处理器的特性,设计了基于MPC8270和FPGA的CPCI总线通信结构,能够实现地震数据的高速实时传输;详细介绍了MPC8270的关键外围电路、FPGA及CPCI总线电路的硬件设计及实现方法,并在实际应用中给出了板卡嵌入式操作系统VxWorks配置的实现方式;板卡以MPC8270作为核心处理器,以FPGA为控制核心电路,以VxWorks为实时操作系统,实现地震数据的高速处理和CPCI总线实时传输功能;经过多次实验室内部测试及海上实际生产应用,结果表明地震数据采集处理板卡能够实现地震数据的高速处理和实时传输,并且板卡性能稳定可靠;板卡的设计简单,结构通用,对数据处理、总线控制和信息交换等领域相关系统的开发具有一定的参考价值。