非晶钛酸铋的晶化过程

利用差热分析、X射线衍射和透射电子显微镜等技术对溶胶-凝胶法合成的凝胶的晶化过程进行了分析，实验结果表明，Bi₄Ti₃O₁₂非晶凝胶晶化过程经历了四个过程：首先在433℃先形成了Bi₂O₃和TiO₂亚稳相，然后在488℃时TiO₂亚稳相与Bi₂O₃反应形成Bi，Ti复合氧化物亚稳相Bi₂T 关键词： 钛酸铋 铁电材料 溶胶凝胶 非晶 晶化过程     

Study on anti-emission materials for non-emitting grid applications in microwave power tubes

Hafnium and platinum were deposited onto molybdenum grids by ion-beam assisted deposition method. Electron-emission characteristics from molybdenum grids with Hf and Pt films, which were contaminated by active electron-emission substances (Ba, BaO) of the cathode, were measured using analogous diode method. The surfaces of grids were analyzed by X-ray diffraction. The results revealed that the reaction between BaO and Hf formed BaHfO₃ compound, which greatly reduced the accumulation of BaO on the surface and accordingly decreased grid emission. In contrast, Ba were formed by the decomposition of BaO on the surface of Pt film under high temperature and re-evaporated from its surface, which reduced the active electron-emission substances on the surface of the grid and effectively restrained grid emission. Their mechanisms for grid-emission suppression are discussed and a good method to develop new grid-coating materials is suggested.     

铟封前后透射式GaAs光电阴极光谱响应特性的测试与分析

利用自行研制的光谱响应测试仪工程化样机,对透射式GaAs光电阴极在高温激活结束、低温激活结束以及铟封成管后的光谱响应特性进行了测试。结果显示,铟封后阴极整个响应波段的光谱响应下降,长波响应受到最显著的影响,表现为800~815 nm之间长波响应大幅度衰减,截止波长和峰值波长向短波移动,峰值响应和积分灵敏度减小,最终的光谱响应曲线变得平坦。阴极参量的计算结果反映铟封后阴极的表面逸出几率降低,说明铟封引起阴极表面激活层发生变化,使得能量较低的长波段光生电子不容易逸出,阴极长波响应和灵敏度随之降低。进一步分析了铟封过程中影响阴极表面激活层的因素。     

超声波声孔效应中气泡动力学的研究

在超声快速制取组织细胞病理切片的过程中，发现激励信号对切片制取效果有明显的影响.为了掌握超声激励信号对组织细胞的影响规律，达到快速制取病理切片的最佳状态，从气泡空化模型入手，通过改变激励信号频率、声压、气泡初始半径和液体黏滞系数等参量，研究了声孔效应中气泡动力学激励机制.数值计算表明：空化泡振动随激励声压增强而升高，随液体黏滞系数增强而减弱；一定频率范围内空化泡振动能保持在膨胀、收缩和振荡的稳定空化状态，存在空化泡稳态振动的最佳激励频率；一定初始半径能保证空化泡产生稳定的振动，存在空化泡稳态振动幅度最大的初始半径.实际操作中，在频率、声压、初始半径和黏滞系数综合作用的若干空化阈内，声孔效应使超声快速法制取细胞组织切片获得最佳效果. 关键词： 声孔效应 超声空化 气泡振动 稳态空化域     

Preparation, characterization and photocatalytic activity of polycrystalline Bi2O3/SrTiO3 composite powders

Bi₂O₃/SrTiO₃ composite powders have been prepared and their photocatalytic activities were investigated by photooxidation of methanol. These powders were characterized by UV-Visible diffuse reflectance spectra, SEM and X-ray diffraction (XRD). The results revealed that all the Bi₂O₃/SrTiO₃ composite powders exhibited higher photocatalytic activity than pure SrTiO₃, Bi₂O₃ and TiO₂ (P25) under visible light irradiation (λ>440 nm). The effects of the Bi₂O₃ contents on the photocatalytic activities of the composite powders were examined, the photocatalytic activities increased with the content of Bi₂O₃ increasing to a maximum of 83% and then decreased under visible light irradiation. The effects of the calcination temperatures on the photocatalytic activities of the composite powders were also investigated.     

The prediction of the peak width at half height in HPLC

The prediction of the peak width at half height is an important aspect in the optimization of the chromatographic operating conditions. In this paper, a linear relationship, between the peak widths at half height and the retention values with various isocratic elution is observed. In gradient elution, however, the relationship between the peak widths at half height and the so-called invented retention values that correspond to the mobile phase composition by eluting the solute from the column end is developed. We believe that there is almost the same band width at half height inside the column (in unit of length) for different solutes. The peak width at half height in the chromatogram (in unit of time) is mainly determined by the capacity factor of the solute when it is eluted from the column end. The larger the capacity factor of a solute eluted from the column end, the more slowly will be the solute eluted from the column end and the wider will be the peak width at half height. It is possible to predict the peak width at half height in various isocratic and gradient elutions by using this linear relationship.     

位置参数估计量的损失函数之估计

本文考虑损失函数的估计问题,分别对于球对称分布和均匀分布情形给出了其参数的J-S型估计量的损失之估计,它们满足[1]中提出的条件(Ⅰ)和(Ⅱ).     

宽带折反射式紫外光刻物镜的设计

本文设计了一种新系列的紫外或远紫外激光光刻物镜,它与国内外已有的紫外物镜相比,在365nm以下的光谱区,具有更宽的光谱工作带宽和较高的数值孔径.以宽带准分子激光或短弧汞氙灯做光源,无需另加色散补偿光学元件,可以进行同轴对准.