Abnormal Li diffusion in β-LiGa by the formation of defect complex

The diffusion coefficients of Li in the NaTl-type Li intermetallic compound of β-LiGa have been measured by using a short-lived radioactive diffusion tracer. As the tracer, the α-emitting radioisotope of ⁸Li delivered as the energetic and pulsed beam from Tokai Radioactive Ion Accelerator Complex (TRIAC) was implanted into the β-LiGa compounds with the composition in the range of about 43 to 54 at.% Li. By analyzing the time-dependent yields of the α-particles measured according to the repetition cycle of the beam, the tracer diffusion coefficients were extracted over the wide range of Li composition. Abnormal composition-dependence of Li diffusion coefficients in β-LiGa was observed; the stoichiometric β-LiGa showed the highest diffusivity of Li. By referring to the composition-dependent diffusivity of Li in the iso-structural β-LiAl and β-LiIn, we could identify the abnormal diffusion of Li in very Li-poor composition of β-LiGa. The anomaly has been discussed qualitatively in terms of the formation of defect complex and the interaction between the constitutional defects.     

Polymerization of Acrylamide in Aqueous Solution of Poly(N‐isopropylacrylamide) at Lower Critical Solution Temperature

Acrylamide (AAm) was found to polymerize in a solution of poly(N‐isopropylacrylamide) (PNIPAAm) in water at around its lower critical solution temperature (LCST) (32°C) without any initiators. This phenomenon was specifically observed in aqueous solutions of the polymers having LCST such as PNIPAAm and poly(methylvinylether) (PMVE). AAm polymerized only when PNIPAAm and AAm were dissolved in water below LCST of PNIPAAm and then the solution was warmed up to the polymerization temperature (40°C). On the other hand, the polymerization of AAm did not proceed when AAm was added into aqueous PNIPAAm solution during and after the phase separation above 32°C. Furthermore the polymerizability of AAm was remarkably affected by the concentration and molecular weight of the PNIPAAm additives. Under the condition of lower PNIPAAm concentration (0.30 mol/L), the increase in the molecular weight of PNIPAAm considerably increased the molecular weight of the resulting PAAm but decreased the yield of PAAm. Under the condition of higher PNIPAAm concentration (0.60 mol/L) the polymerizability was not so affected by the molecular weight of PNIPAAm, while the molecular weight of PAAm formed by using higher molecular weight PNIPAAm was higher than those of PAAm formed by using lower molecular weight PNIPAAm. Moreover, the molecular weight of PAAm formed by the PNIPAAm induced polymerization of AAm was much higher than that of the polymer obtained by the radical polymerization using AIBN in THF or VA‐ 061 in water.     

Voltammetric Determination of Boric Acid Using the Ternary Complexation System with Salicylaldehyde and H‐Acid

A square‐wave voltammetric method for the determination of boric acid in water has been described based on the new understanding of the electrochemical behavior of boric acid‐Azomethine H complexation. Salicylaldehyde and H‐acid were used as the starting materials of boric acid‐Azomethine H complex and their concentrations were optimized for boric acid determination in water. A glassy carbon electrode, instead of a conventional mercury electrode, was used in the measurement. The detection limit of the proposed method was 0.10 mg B dm^?3. The proposed method was successfully used for boric acid determination in the water from a seawater desalination RO plant.     

Universal fluorescent labeling of amplification products using locked nucleic acids

Amplification/hybridization‐based genetic analyses using primers containing locked nucleic acids (LNAs) present many benefits. Here, we developed a novel design for universal fluorescent PCR using LNAs. Universal fluorescent PCR generates intermediate nonlabeled fragments and final fluorescent fragments in a two‐step amplification process that uses locus‐specific primers with universal tails and universal fluorescent primers. In this study, a few standard nucleotides were replaced with LNAs only in the fluorescent universal primers. The sequence of the fluorescent universal primer significantly affected the amplification efficiency. For primers with three LNAs, the fluorescent primers with stable M13(‐47) sequences provided the most efficient signal (approximately tenfold higher than the primers with M13(‐21) sequences at lower Tm values). Moreover, AT‐rich LNA substitutions in the fluorescent primers produced much lower amplification efficiencies than GC‐rich substitutions. GC‐rich LNAs produced greater differences in Tm values among primers, and resulted in the preferential production of fluorescently labeled amplicons. The specificity and sensitivity of LNA‐containing fluorescent primers were assessed by genotyping eight STRs in Japanese individuals, and full STR profiles could be generated using as little as 0.25 ng of genomic DNA. The method permitted clear discrimination of alleles and represents sensitive STR genotyping at a reduced cost.     

Concentration dependences of dielectric properties at 105 Hz and 106 Hz for aqueous solutions of hydroxypropyl cellulose

The concentration dependences of dielectric properties measured at 10⁵ Hz and 10⁶ Hz are reported for aqueous solutions of hydroxypropyl cellulose. Phase behaviour of the solutions was also observed with a polarizing optical microscope. For solutions with concentrations well above 40 wt %, polydomain textures, including the banded texture, were observed after a prehistory of deformation. No significant discontinuous changes in the dielectric constant, ε_r′, and loss factor, ε_r″, were found at the concentrations around the onset of the isotropic–cholesteric phase transition and in the biphasic region. In contrast, the steeper changes in ε_r′ and ε_r″ were found at the critical concentration for the fully developed cholesteric phase transition with the polydomain textures.     

Bimetallic Co–Pd alloy nanoparticles as magnetically recoverable catalysts for the aerobic oxidation of alcohols in water

Co–Pd bimetallic alloy nanoparticle catalysts were prepared from CoCl₂, Pd(OAc)₂ and several capping agents with Li(C₂H₅)₃BH. The nanoparticle catalysts were applied to the aerobic oxidation of a variety of alcohols in water to give the corresponding carbonyl products. The catalyst was magnetically recovered and reused for further oxidation. The nanoparticle catalysts were characterized with TEM, ICP, and XPS analyses.     

In vivo estimation of optical properties of rat liver using single-reflectance fiber probe during ischemia and reperfusion

Optical Review - To quantify the changes in optical properties of in vivo rat liver tissue, we applied diffuse reflectance spectroscopy (DRS) system using single-reflectance fiber probe during...     

One-dimensional beam ordering of protons in a storage ring

The ordering of protons has been observed at a new storage ring, S-LSR, at Kyoto University. Abrupt jumps in the momentum spread and the Schottky noise power were observed for protons for the first time at a particle number of approximately 2000, upon applying electron cooling with electron currents of 25, 50, and 100 mA. The transition temperature was 0.17 and 1 meV in the longitudinal and transverse directions, respectively. The transverse temperature of the proton beam was much below that of electrons at the transition, which played an essential role in the ordering of protons.