Effect of solvent on the cation-sensitive fluorescence of polyanions bearing 4′-acryloylbenzo-18-crown-6 Units

Changes in the fluorescence intensity of polyanions bearing 4-acryloylbenzo-18-crown-6 units on the addition of cations were studied in a mixed solvent of methanol and water at 30°C. The sensitivity of the change in fluorescence intensities of the polymers toward cations was strongly enhanced compared to that of the corresponding model compound. When alkali metal cations were added, the fluorescence intensity of the polymers decreased in the orders Li⁺>Na⁺>Cs⁺>Rb⁺>K⁺ in a methanol-water (19) mixture and Li⁺>Na⁺>Rb⁺>K⁺Cs⁺ in a methanol-water (91) mixture. Alkaline earth metal cations and alkylamine hydrochlorides decreased the fluorescence intensity of the polymers in a methanol-water (19) mixture. The cation-dependent decrease in the fluorescence intensity of the polymers was affected by the water fraction in a mixed solvent of methanol and water.     

Identification of Shiga toxins in Shiga toxin-producing Escherichia coli using immunoprecipitation and high-performance liquid chromatography-electrospray ionization mass spectrometry

We developed a rapid and reliable identification method for Shiga toxins in Shiga toxin-producing Escherichia coli (STEC) using immunoprecipitation and high-performance liquid chromatography-electrospray ionization mass spectrometry (HPLC-ESI-MS). Polyclonal antisera specific for Shiga toxin 1 (Stx1) and Shiga toxin 2 (Stx2) were raised in rabbits so as to be used for the immunoprecipitation. The immunoprecipitaion was carried out by mixing sample solutions with 50 microl each of the antisera to Stx1 and Stx2 followed by allowing the mixed solutions to stand for 30 min. The quantity required to obtain the immunoprecipitate was more than 0.5 microg of Shiga toxins. HPLC-ESI-MS analysis of the resulting immunoprecipitates provided accurate molecular weight information on Shiga toxins, leading to direct evidence for the presence of these toxins. It requires at most two days to perform our procedure from toxin extraction to measurement of HPLC-ESI-MS whereas the previous method using isolation procedures required about two weeks to complete. The usefulness of the present method has been demonstrated by identifying Stx1, Stx2 and a variant of Stx2 (Stx2e) in the immunoprecipitates prepared from STEC strains.     

Total synthesis of merrilactone A

Merrilactone A (1) has been shown to possess neurotrophic activity and thus is expected to hold therapeutic potential in the treatment of neurodegeneration diseases. In this paper, we report the total synthesis of (+/-)-1, employing, as key steps, a novel desymmetrization protocol of meso-diketone to construct the core cis-bicyclo[3.3.0]octyl system of 1 (3 --> 2) and a radical cyclization to install the highly congested C9-quaternary carbon (16 --> 17).     

Isolation, characterization, and theoretical study of La2@C78

A new metallofullerene, La2@C78, has been synthesized by DC arc discharge method, isolated by high-performance liquid chromatography, and characterized by laser desorption time-of-flight mass spectrometry, UV-vis-NIR absorption, differential pulse voltammetry, 13C NMR spectroscopy, and theoretical calculations. The La2@C78/CS2 solution is dark violet and presents several characteristic absorption features at 647, 561, 533, and 386 nm, with an onset around 1000 nm. With respect to empty D3-C78, the capability of La2@C78 as an electron acceptor or donor is stronger. Addition of 1,1,2,2-tetrakis(2,4,6-trimethylphenyl)-1,2-disirane to La2@C78 photochemically, as well as thermally, affords bis- and mono-adducts. Theoretical studies and 13C NMR spectroscopic analysis of La2@C78 indicate that it possesses a D3h-C78 cage (78:5).     

Polydimethylsiloxane connection for quartz microchips in a high-pressure system.

An interconnecting technique, the "PDMS connection method", for quartz microchips in a high-pressure system is presented. The connection between quartz microchips is an essential technology for modular microfluidic devices, such as microchip-HPLC. PDMS was applied to the seal material, being spread on the seal side of the chips, and set into the metal housing. The characteristics of the PDMS connection method concerning pressure resistance and the extension of the peak were examined. The experimental results showed a good seal at 5 MPa, which seem to be sufficient for realizing microchip-HPLC utilizing a monolithic silica capillary column as a separation medium. The influence of the extra column effect on chromatographic separation was almost the same as in the case using a commercial union fitting. In addition, the PDMS connection enabled the detachability of chip-based modules with user-friendliness. Our experimental findings suggest that the novel PDMS connection method can possibly be applied as a generic technology in high-pressure microTAS.     

Smectic layer structure of ferroelectric liquid crystal formed between fine polymer fibres

This paper describes the alignment of ferroelectric liquid crystal (FLC) structures formed between aligned polymer fibres, where the FLC smectic layers are determined by polarising microscopy and X-ray diffraction. The FLC/polymer composite films were formed from a nematic phase FLC/monomer solution using a photopolymerisation-induced phase separation method. It was found that bending of the FLC smectic layers was induced in both the film plane and the cross-sectional plane at the phase transition from smectic A to chiral smectic C of the FLC material. The light transmittance properties of the composite film between crossed polarizers was analysed by light propagation simulation in several optical anisotropic media, based on the evaluated smectic layer model.     

Supramolecular hydrogels and organogels based on novel l-valine and l-isoleucine amphiphiles

New low-molecular-weight gelators based on l-valine and l-isoleucine gelators, which have a positively charged terminal group, can gel not only pure water and aqueous solutions containing inorganic acids and salts but also some organic solvents and oils.     

STRUCTURE AND STABILITY OF γ-CRYSTALLINS-V. COVALENT AND NONCOVALENT PROTEIN-PROTEIN INTERACTIONS IN PHOTOSENSITIZED REACTIONS

Abstract— Irradiation of γ-crystallins with 300 nm light or with the photosensitizers riboflavin or methylene blue (MB) leads to intermolecular cross-linking and insolubilization. Sodium dodecyl sulfate polyacrylamide gel electrophoresis studies reveal that these cross-links are composed of nondisulfide covalent bonds. The water-insoluble phase is stabilized by noncovalent forces, as denaturants readily dissolve it. High-performance liquid chromatography and electrophoresis results further indicate that the higher multimers are part of this water-insoluble fraction only, with the exception of MB-sensitized reactions, which are also able to produce a water-soluble, high-molecular-weight protein of at least 1 million. Labeling the external sulfhydryl groups with iodoacetamide does not prevent the photoreac-tions; however, a reducing agent such as dithiothreitol does. A mechanism involving initial oxidation and interaction of sulfhydryl groups (forming an intramolecular disulfide) buried within the protein as a necessary precursor to polymerization and precipitation has been proposed in the preceding paper. The present study provides support for this mechanism.     

pH-regulated formation of amyloid-like beta-sheet assemblies from polyglutamate grafted polyallylamine

A novel artificial protein with simple primary structure, poly(gamma-methyl-L-glutamate)-grafted polyallylamine, has been prepared and the resultant peptide has shown a unique property of pH-regulated conformation and morphology.