熔盐电解合成希土六硼化物的研究——REBO3、LiBO2和LiF体系熔盐电解合成RER6

本文在800℃和空气中电解REBO₃-LiBO₂-LiF熔盐体系合成了单相的REB₆.石墨川埚兼作容器和阳极.耐火金属棒如Cu和Mo等被悬吊在电解质中作为阴极.根据似二元体系LiBO₂-LiF和LiBO₂-LaBO₃的低熔点组成以La₂O₃、B₂O₃、Li₂CO₃和LiF为原料找到了具有较低熔点的熔盐体系.根据X射线粉末衍射,该熔体是由REBO₃、LiBO₂和LiF三个物相组成.     

环己硅烷类液晶化合物的量子化学研究

运用AM1和PM3两种SCF-MO方法，通过能量梯度全优化计算，给出20种环己硅烷类（苯基乙烷系）液晶化合物的稳定几何构型、电子结构和基本性质．联系有机电子结构理论进行了细致的讨论．     

Application of diaza-18-crown-6-capped beta-cyclodextrin bonded silica particles as chiral stationary phases for ultrahigh pressure capillary liquid chromatography

Two bonded chiral stationary phases (CSPs), 8-aminoquinoline-2-ylmethyl- and 8-aminoquinoline-7-ylmethyl-diaza-18-crown-6-capped [3-(2-O-beta-cyclodextrin)-2-hydroxypropoxy]propylsilyl silica particles (non-porous, 1.5 microm), have been prepared and evaluated using capillary liquid chromatography at high pressures (> or = 8000 p.s.i.). High column efficiency (up to 400 000 plates m(-1)) was achieved for chiral separations. These CSPs with two recognition sites, i.e. substituted-diaza-18-crown-6 and beta-cyclodextrin combined with high chromatographic efficiency provide good resolution of a variety of enantiomers and positional isomers in relatively short times under reversed-phase conditions. After inclusion of a Ni (II) ion from the mobile phase, the positively charged crown ether-capped beta-cyclodextrin facilitates specific static, dipolar, and host-guest complexation interactions with solutes.     

Development of a modified beta-cyclodextrin based fluorosensor for dipyridamole

2,6-O-diethyl-β-cyclodextrins were prepared and immobilized onto silica gel to develop a fluorosensor for dipyridamole. The analytical performance characteristics of the proposed sensor for analysis of dipyridamole were as follows: the detection limit was 0.8 nmol/L with a relative standard deviation of 1.4% for 10 determinations of 50 nmol/L of dipyridamole. The modification of β-CD improved the sensitivity and selectivity for measuring dipyridamole. The recommended method has been successfully tested for the determination of dipyridamole in clinical samples (urine and pharmaceutical preparations).     

苏丹Ⅰ与牛血清白蛋白的相互作用特征

利用荧光技术研究了在人体生理酸度条件下,苏丹Ⅰ与牛血清白蛋白相互作用,发现苏丹Ⅰ对牛血清白蛋白有较强的荧光猝灭作用,用Stern-Volmer和Line Weaver-Burk方程处理荧光猝灭数据,得到了反应的结合常数、结合热力学性质和结合位点等参数。根据热力学常数确定了该药物与血清白蛋白之间的作用力类型,在此基础上依据F rster非辐射能量转移机理探讨了苏丹Ⅰ与BSA相互结合时其供体-受体间的距离。     

冷态德士古气化炉流场与停留时间分布的研究

测定了德士古气化炉的冷态速度分布和停留时间分布。结果表明：德士古气化炉内在轴向２．５～３．０倍直径范围内存在回流，最大回流量为射流量的３．５倍左右；在平均停留时间之前，已有５０％左右的物料逸出炉外。本文指出，德士古气化炉中存在的问题，如结渣、耐火砖寿命短、有效气体成分偏低均与炉内流场有关。     

CeO2-ZrO2-Y2O3对Pt-Rh型三效催化剂性能的影响

采用共沉淀法技术制备了Ce0.35Zr0.55Y0.10固溶体,并对其进行了比表面积、储氧量的测试和XRD的表征.将其用于低贵金属Pt-Rh型三效催化剂的制备,考察了CeO2-ZrO2-Y2O3对三效催化剂性能的影响.结果表明,Ce0.35Zr0.55Y0.10具有与Ce0.50Zr0.50O2相似的立方结构和相近的储氧量,经高温(1000 ℃)后仍能保持较大的比表面积(38.66 m2·g-1).和含Ce0.50Zr0.50O2的三效催化剂相比,含CeO2-ZrO2-Y2O3的三效催化剂经高温老化后,C3H8,CO,NO仍具有较高的转化率和较低的起燃温度.     

Photocatalytic Oxidation of Aniline in the Gas Phase Using Porous TiO2 Thin Films

The gas-phase photocatalytic oxidation of aniline on a new kind of porous nano-TiO₂ composite films is investigated. The composite film was prepared on glass fiber with the water glass as binders and dilute H₂SO₄ solution as solidifying reagent. The surface characters were observed by scanning electron microscope. The photocatalytic degradation of aniline on the composite films was carried out in a TiO₂/UV system. Some important factors affecting the photodegradation, such as the concentration of TiO₂, the initial concentration of aniline, and the existing water vapor, are also studied. The product of photocatalytic oxidation was detected by Fourier transform-Infrared. The partial intermediate products were absorbed on TiO₂ surface, which resulted in catalyst deactivation. But when it was irradiated under UV illumination or solar irradiation for some time, the catalyst could be reused without loss of catalytic activity. Translated from the Journal of Wuhan University (Natural Science Edition), 2005, 51(2) (in Chinese)     

The interfacial dilational properties of hydrophobically modified associating polyacrylamide studied by the interfacial tension relaxation method at an oil-water interface

The interfacial dilational viscoelastic properties of hydrophobically associating block copolymer composed of acrylamide (AM) and a low amount of 2-phenoxylethyl acrylate (POEA) (<1.0 mol%) at the octane-water interfaces were studied by means of the interfacial tension relaxation method. The dependencies of interfacial dilational elasticity and viscous component on the dilational frequency were investigated. The interaction of hydrophobically associating block copolymer [P(AM/POEA)] with sodium dodecyl sulfate (SDS) has been explored. The results show that at lower frequency, the dilational elasticity for different concentration copolymer is close to zero; at higher frequency, the dilational elasticity shows no change with increased frequency; At moderate frequency (10(-3)-1 Hz), the dilational elasticity decreased with a decrease in the dilational frequency. The results show that the hydrophobic groups of [P(AM/POEA)] chains can be associated by inter- or intrachain liaisons in water solution. The dilational viscous component for P(AM/POEA) comes forth a different maximum value at different frequencies when the polymer concentration is different. It is generally believed that the dilational viscous component reflects the summation of the various microscopic relaxation processes at and near the interface and different relaxation processes have different characteristic frequencies. The spectrum of dilational viscous component may appear more than once maximum values at different frequencies. The influence of SDS on the limiting dilational elasticity and viscous component for polymer solution was elucidated. For 5000 ppm polymer solution, the limiting dilational elasticity decreased with an increase in SDS concentration. The dilational viscous component passed through a maximum value with a rise in the dilational frequency, which appeared at different frequency when SDS concentration is different; and the higher is the concentration, the lower is the dilational frequency. It can be explained that macromolecules may be substituted by SDS molecules in the interface and the interaction of molecules decrease, which makes the limiting dilational elasticity decrease. For 200 ppm polymer solution, the limiting dilational elasticity increased firstly and then decreased with SDS concentration increasing. This may be explained that the interfacial polymer concentration is so low that SDS molecules absorbed in the interface dominate dilational properties of the interfacial film even at very low SDS concentration. However, SDS molecules can gradually substitute the polymer molecules in the interface with a rise in SDS concentration, which results in the decrease in the limiting dilational elasticity.