An improved LC–MS/MS method for determination of docetaxel and its application to population pharmacokinetic study in Chinese cancer patients

Because of its unpredictable side effects and efficacy, the anticancer drug docetaxel (DTX) requires improved characterisation of its pharmacokinetic profiles through population pharmacokinetic studies. A sensitive and rugged LC–MS/MS method for the detection of DTX in human plasma was developed and optimised using paclitaxel as an internal standard (IS). The plasma samples underwent rapid extraction using hybrid solid-phase extraction-protein precipitation. The analyte and IS were separated with an isocratic system on a Zorbax Eclipse Plus C₁₈ column using water containing 0.05% acetic acid along with 20 μM of sodium acetate and methanol (30/70, v/v) as the mobile phase. Quantification was performed using a triple quadrupole mass spectrometer through multiple reaction monitoring in positive mode, using the m/z 830.3 → 548.8 and m/z 876.3 → 307.7 transitions for DTX and paclitaxel, respectively. The range of the calibration curve was 1–500 ng/mL for DTX, and the linear correlation coefficient was >0.99. The accuracies ranged from −4.6 to 4.2%, and the precision was no higher than 7.0% for the analytes. No significant matrix effect was observed. Both DTX and the IS showed considerable recovery. This method was finally applied to the establishment of a population pharmacokinetic model to optimise the clinical use of DTX.     

Optical fiber acoustic sensing multiplexing system based on TDM/SFDM

We propose a system of time-division multiplexing(TDM) and spatial frequency-division multiplexing(SFDM). Extrinsic Fabry–Perot interferometric sensors are applied to detect weak acoustic signals. The broadband source is employed, the light from it is modulated by a pulse signal sequence and is efficiently amplified by semiconductor optical amplifiers. Experimental results show that the equivalent noise pressure spectrum level is-97.2 d B re 1 rad/√Hz below 1250 Hz, and the cross talk between two sensors in one TDM channel is-32.7 d B with a cavity length difference of 60 μm. The number of sensors in this multiplexing system can theoretically reach 160.     

80.5 MeV/u碳离子诱发铜靶的放射性剩余产物测量

高能重带电粒子能直接穿透靶原子核外电子层,与原子核发生直接碰撞,发生散裂反应,产生一系列具有放射性的剩余产物核.重带电粒子诱发靶材放射性剩余核与辐射防护和人员安全有着密切联系,当前,大部分剩余核产额主要依靠蒙特卡罗粒子输运程序进行模拟计算,其准确程度亟需通过实验测量进行准确评估.本文利用能量为80.5 MeV/u的(12)^C⁶⁺粒子对薄铜靶开展了辐照实验与伽玛射线测量,结合伽玛谱学分析方法,得出了辐照产生的18种放射性剩余产物的初始活度和产生截面值,并与PHITS模拟结果进行对比.结果表明,PHITS模拟程序对放射性剩余核种类的估计具有较高可靠性,在其绝对产额方面,与实验测量仍具有较大偏差.     

Fast Liquid Phase Epitaxial Growth for Perovskite Single Crystals

Semiconductors grown by the solution-processed method have shown low-cost,facile fabrication process and comparable performance.However,there are many reasons why it is difficult to achieve high quality films.For example,lattice constant mismatch is one of the problems when photovoltaic devices made of organ metallic perovskites.In this work,MAPbBr^{MA=CH3NH3^+}perovskites single crystals grown on the surface of MAPbBr2.5 CI0.5 perovskites single crystals via liquid epitaxial growth method is demonstrated.It is found that when the lattice constants of the two perovskite single crystals are matched,another crystal can be grown on the surface of one crystal by epitaxial growth.The whole epitaxy growth process does not require high heating temperature and long heating time.X-ray diffraction method is used to prove the lattice plane of the substrate and the epitaxial grown layer.A scanning electron microscope is used to measure the thickness of the epitaxial layer.Compared with perovskite-based photodetectors without epitaxial growth layer,perovskite-based photodetectors with epitaxial growth layer have lower dark current density and higher optical responsibility.     

山东大学(威海)开展的核物理研究

综述了山东大学威海校区原子核物理研究团队在原子核精细谱学、核天体物理、探测器研制和高能核物理等方向开展的研究工作及最新进展；尤其重点介绍了$A\sim 110$核区原子核的形状共存和带交叉延迟，“订书机”和“雨伞”模式转动带，碳氮氧循环过程中关键核反应的测量进展，中子星参数化的状态方程及双中子星并合引力波研究，带电粒子探测器的设计与制作，相对论重离子碰撞物理中量子输运理论和高阶反常输运等研究工作，并展望了下一步的工作重点。     

Et2Zn-mediated stoichiometric C(sp)-H silylation of 1-alkynes and chlorosilanes

A first example of an Et₂Zn mediated silylation of 1-aklynes is reported. A series of functional groups are tolerated in this reaction. Mechanistic studies support Zn alkynilides as intermediates in the reaction. This reaction protocol provides a practical method for the preparation of alkynylsilanes and expands the application of organometallic zinc in organic synthesis.     

杂多酸催化合成乙酸乙酯

回流吸附法制备的负载型12-钨磷酸(HPW/C)是合成乙酸乙酯的高效催化剂。最佳反应条件下乙醇转化率达96％,酯化选择性100％。催化剂的高活性是由于HPW在活性炭上高度分散,使活性位增多,有效酸量增大。HPW/C还具有热稳定性高和不易流失等优点。     

Ag+掺杂的立方相Y2O3:Eu纳米晶体粉末发光强度研究

采用化学自燃烧法制备了不同Ag⁺掺杂浓度的Y₂O₃:Eu纳米晶体粉末样品(［Y³⁺］∶［Eu³⁺］∶［Ag⁺］=99∶1∶X，X=0—3.5×10^-2)，以及通过退火处理得到了相应的体材料.根据X射线衍射谱确定所得纳米和体材料样品均为纯立方相.实验表明在纳米尺寸样品中随着Ag离子浓度的增加，荧光发射强度随之增加，当X=2×10^-2时达到最大值，其发光强度比X=0时提高了近50%.当Ag离子浓度继续增加，样品发光强度保持不变.在相应的体材料样品中则没有观察到此现象.通过对各样品的发射光谱，激发光谱，X射线衍射图谱，透射电镜(TEM)照片和荧光衰减曲线的研究，分析了引起纳米样品荧光强度变化的原因是由于Ag离子与表面悬键氧结合，从而使这一无辐射通道阻断，使发光中心Eu³⁺的量子效率提高；Ag⁺的引入所带来的另一个效应是使激发更为有效.这两方面原因使发光效率得到了提高.