Fabrication high-purity Fe nanochains with near theoretical limit value of saturation magnetization of bulk Fe

High-yield purity chain-like one-dimensional nanostructures consisting of single crystal Fe nanoparticles have been produced by using solution dispersion approach. Room temperature magnetic measurement shows that the as-fabricated Fe nanochains are ferromagnetic with a high saturation magnetization (203 emu/g) whereas the nanoparticles are single magnetic domains, which indicate that the as-synthesized products have superparamagnetism behavior with the saturation magnetization of about 28 emu/g. Maybe this results from the directional alignment of the nanoparticles. The excellent characteristic may have led to the potential applications in spin filtering, high density magnetic recording, and nanosensors.     

Measurements of the cross section for e(+)e(-) --> hadrons at center-of-mass energies from 2 to 5 GeV

We report values of R = sigma(e(+)e(-)-->hadrons)/sigma(e(+)e(-)-->mu(+)mu(-)) for 85 center-of-mass energies between 2 and 5 GeV measured with the upgraded Beijing Spectrometer at the Beijing Electron-Positron Collider.     

虚拟仪器技术及乐音的频谱分析

阐述了虚拟仪器技术的概念和特点,精确测量了３ 种乐音信号的波形、频谱和频率     

单胶子交换梯形近似下Bethe－Salpeter方程赝标解

将在动量空间具有积分形式的单胶子交换梯形近似下Ｂｅｔｈｅ－Ｓａｌｐｅｔｅｒ方程化为微分方程，求出该方程在四动量为零时的赝标解全部分量，其中第一分量为已知的Ｇｏｌｄｓｔｅｉｎ解．     

A note on regularity for a class of quasilinear elliptic equations

The following regularity of weak solutions of a class of elliptic equations of the form are investigated.     

CDS器件在TDI-CCD视频信号处理中的应用

本文是对国家863-2计划中某项目的部分工作所做的总结。文中对CCD的噪音和新型TDI-CCD输出视频信号的特性进行了分析,提出了对于各种噪音的处理方法,尤其详细介绍了采用相关双采样(CDS)技术处理kTC噪音和复位噪音的方法,并通过实验进行了验证,最后分析了系统的信噪比。     

傅里叶变换轮廓术中新的相位及高度算法分析

在传统傅里叶变换轮廓术三维面型测量中,为了准确得到被测物体的高度分布,必需保证投影仪出射光瞳和摄像机入射光瞳的连线与参考面平行并且在同一水平面,否则存在较大的误差。着眼于更普通的情况,讨论双瞳连线与参考面成某一夹角时的高度计算,推导出了非平行时的参考面光场及物面变形条纹光场的表达式,并给出了高度映射公式。因而,传统的傅里叶变换轮廓术测量成为角度α=0时的特例。该方法使傅里叶变换轮廓术的测量条件得到了放宽;易于通过移动投影装置或成像装置获取全场条纹;并为在难以实现双瞳与参考面平行的特殊环境下的测量提供了可行的方法。计算机模拟及实验均证实了该方法的有效性。     

Highly stable and efficient KTP-based intracavity optical parametric oscillator with a diode-pumped passively Q-switched laser

We present in this paper a highly stable and efficient KTP-based intracavity optical parametric oscillator with a diode-end-pumped Nd:YVO₄/Cr:YAG passively Q-switched laser. At the incident diode pump power of 4 W, the signal (1.57 μm) and idler (3.29 μm) average output powers up to 580 and 100 mW, respectively, have been achieved. The corresponding conversion efficiency from the input diode pump power to the output signal power is 14.5%, while that to the total OPO output (signal+idler) reaches 17%. To the best of our knowledge, these are the highest conversion efficiencies reported to date. After more than four hours of investigation, the OPO power stability better than 2% has been obtained. In addition, efficient cavity dumping of the IOPO has inevitably led to the short pulse duration (1.6 ns) and high peak power output (8.3 kW) at the signal wave. Additionally, the amplitude and repetition rate fluctuations of the signal pulses are well within 5%. PACS 42.55.Xi; 42.60.Gd; 42.60.Lh; 42.65.Yj