A warehouse-based design model for reverse logistics

In this paper, an MILP formulation is proposed for the design of a reverse logistics network based on a warehouse location–allocation model, which optimizes, simultaneously, the forward and reverse networks. A single product model with unlimited capacity is first defined. Subsequently, the model is extended to a multi-product capacitated recovery network model, where capacity limitations and a multi-product system can be considered. The proposed model is compared to published work in the field, where different model assumptions have been proposed. Two cases are described so as to gain a better insight into the model and allow a comparative analysis.     

355nm Nd∶YAG激光在H_2中的高效一级斯托克斯转换

对脉冲Nd∶YAG激光(355 nm)在H2和H2∶He-Ar混合气体中的受激拉曼散射(SRS)进行了研究。在0.5 MPa的氢气中,同时测量到从二级反斯托克斯到三级斯托克斯的多波长输出,其总转化效率达88%;而高压下只剩下一级和二级斯托克斯输出,其中二级斯托克斯最大能量转化效率达44%(对应量子效率为63%)。由于高级斯托克斯的竞争,纯氢气中一级斯托克斯的最大能量转换效率不超过43%。通过向3 MPa氢气中掺入2 MPaAr气后,很好地抑制了二级斯托克斯的产生,从而获得了能量转换效率高达71%(对应量子效率为83%)的一级斯托克斯输出。对四波混频和级联受激拉曼散射在氢气多级斯托克斯产生中的作用以及惰性气体对它们的影响进行了讨论。     

Quantum states in fabricating poly-Si films

The quantum states are presented in these processions of fabricating poly-Si films. Amorphous silicon films prepared by PECVD has been crystallized by conventional furnace annealing (FA) and rapid thermal annealing (RTA), respectively. It is found that the thin films grain size present quantum states with the increasing of the gas flow ratios of SiH₄, H₂ mixture, substrate temperatures, frequency power, annealing temperature and time.     

k-树的补图的最小填充和树宽

一个图的最小填充问题是寻求边数最少的弦母图,一个图的树宽问题是寻求团数最小的弦母图,这两个问题分别在稀疏矩阵计算及图的算法设计中有非常重要的作用．一个k-树G的补图G称为k-补树．本文给出了k-补树G的最小填充数f(G) 及树宽TW(G)．     

A new solution of reducing polymer optical fiber losses

Polymethyl methacrylate (PMMA) is one of the most commonly used optical materials. However, the application of it in the area of optical communication is strongly limited by the intrinsic absorption loss of carbon-hydrogen stretching vibration. In this paper, we present a method to solve the problem by adopting the hollow-core fibers with cobweb cladding structure. The fibers use a single dielectric material and may solve the problem of structural support. Thus the feasibility of the “OmniGuide” fibers is improved, while a series of advantages of the “OmniGuide” hollow-core fiber are retained. It is promising that a fiber with low transmission loss, high bandwidth, large-core, and low costs can be designed and fabricated using PMMA. At the same time, a very broad range of the wavelengths (from visible to near infrared region, for instance, wavelengths at 0.65-1.12 μm, and even 1.30 μm, 1.54 μm and their neighbors) may be adopted for signal wavelength.     

Electroactive conducting polymers for corrosion control

There is an intensive effort underway to develop new corrosion control coatings for structural metals. In part, this effort has been motivated by the desire to replace chromium(VI)-containing coatings currently used for corrosion control of iron and aluminum alloys. Cr(VI) has been shown to be hazardous to the environmental and to human health, and its use in many countries will be sharply curtailed in the coming years. Electroactive conducting polymers (ECPs) represent a class of interesting materials currently being explored for use in corrosion control coating systems, possibly as a replacement for Cr(VI)-based coatings. The electroactivity and the electronic conductivity (or semiconductivity) of ECPs set them apart from traditional organic coatings. As with chromate, interesting and potentially beneficial interactions of ECPs with active metal alloys such as steel and aluminum are anticipated, with concomitant alteration of their corrosion behavior. A review of this active research area will be presented in two parts. Here in Part 1, a general introduction to the topic of corrosion control by ECPs will be presented, including an overview of corrosion and its control by traditional methods, an introduction to ECPs and their properties, and a discussion of the processing issues surrounding the use of ECPs as coatings. Part 1 also includes a review of the literature on the use of ECPs as coatings (or components of coatings) on non-ferrous active metals, principally aluminum and aluminum alloys, although some work on zinc, copper, silver, titanium and silicon will also be described. In Part 2 of this review (to be published in the next issue of this journal), the rather extensive literature on the use of ECPs for the corrosion control of ferrous alloys (steels) will be reviewed. Electronic Publication     

The polar ionosphere at Zhongshan station on May 11, 1999, the day the solar wind almost disappeared

The solar wind almost disappeared on May 11, 1999: the solar wind plasma density and dynamic pressure were less than 1cm⁻³ and 0.1 nPa respectively, while the interplanetary magnetic field was northward. The polar ionospheric data observed by the multi-instruments at Zhongshan Station in Antarctica on such special event day was compared with those of the control day (May 14). It was shown that geomagnetic activity was very quiet on May 11 at Zhongshan. The magnetic pulsation, which usually occurred at about magnetic noon, did not appear. The ionosphere was steady and stratified, and the F₂ layer spread very little. The critical frequency of day-side F₂ layer, f₀F₂, was larger than that of control day, and the peak of f₀F₂ appeared 2 hours earlier. The ionospheric drift velocity was less than usual. There were intensive auroral E_s appearing at magnetic noon. All this indicates that the polar ionosphere was extremely quiet and geomagnetic field was much more dipolar on May 11. There were some signatures of auroral substorm before midnight, such as the negative deviation of the geomagnetic H component, accompanied with auroral E_s and weak Pc3 pulsation.

     

Quadratic data envelopment analysis

Data Envelopment Analysis (DEA) offers a piece-wise linear approximation of the production frontier. The approximation tends to be poor if the true frontier is not concave, eg in case of economies of scale or of specialisation. To improve the flexibility of the DEA frontier and to gain in empirical fit, we propose to extend DEA towards a more general piece-wise quadratic approximation, called Quadratic Data Envelopment Analysis (QDEA). We show that QDEA gives statistically consistent estimates for all production frontiers with bounded Hessian eigenvalues. Our Monte-Carlo simulations suggest that QDEA can substantially improve efficiency estimation in finite samples relative to standard DEA models.     

Effective dimensionality approach to the RKKY interaction in multilayer systems

We consider RKKY interaction in a quasi 2D system with nonparabolic dispersion. In our paper we calculate the RKKY range function assuming the in-layer confinement via effective dimensionality approach. We show, that indirect magnetic exchange in our system can be modelled by the effective spectral dimension which equals one.     

CsNiCl3晶体的光谱精细结构、零场分裂参量及Jahn-Teller效应

应用不可约张量理论构造了三角对称晶场中3d²/3d⁸态离子的45阶可完全对角化的微扰哈密顿矩阵，研究了CsNiCl₃晶体的光谱精细结构、晶体结构、零场分裂参量、Jahn-Telller效应以及自旋单重态对Ni²⁺离子基态能级的影响，理论与实验相符合.在此基础上，进一步研究了以前工作中被忽略的自旋-自旋耦合作用和Trees修正对CsNiCl₃晶体的光谱精细结构和零场分裂参量的影响，发现有四种机理会影响零场分裂参量：1)自旋-轨道耦合机理，2)自旋-自旋耦合机理；3)自旋-轨道与自旋-自旋联合耦合机理；4)自旋-轨道与Trees修正联合耦合机理，其中自旋-轨道耦合机理是最主要的，其他三种机理也是不可忽略的. 关键词： 基态能级 精细结构 零场分裂 自旋-自旋耦合