Minimal Modules Over Serial Rings

We investigate several model theoretic minimalities in the framework of modules over a given serial ring R.     

A biofunctional polymeric coating for microcantilever molecular recognition

An innovative route to activate silicon microcantilevers (MCs) for label free molecular recognition is presented. The method consists in coating the underivatized MCs with a functional ter-polymer based on N,N-dimethylacrylamide (DMA) bearing N-acryloyloxysuccinimide (NAS) and 3-(trimethoxysilyl)propyl-methacrylate (MAPS), two functional monomers that confer to the polymer the ability to react with nucleophilic species on biomolecules and with glass silanols, respectively. The polymer was deposited onto MCs by dip coating. Polymer coated MCs were tested in both static and dynamic modes of actuation, featuring detection of DNA hybridization as well as protein/protein interaction. In the dynamic experiments, focused on protein detection, the MCs showed an average mass responsivity of 0.4 Hz/pg for the first resonant mode and of 2.5 Hz/pg for the second resonant mode. The results of the static experiments, dedicated to DNA hybridization detection, allowed for direct estimation of the DNA duplex formation energetics, which resulted fully consistent with the nominal expected values. These results, together with easiness and cheapness, high versatility, and excellent stability of the recognition signal, make the presented route a reliable alternative to standard SAM functionalization (for microcantilevers (MCs) and for micro-electro-mechanical systems (MEMS) in general).     

A New Indirect Electroanalytical Method to Monitor the Contamination of Natural Waters with 4‐Nitrophenol Using Multiwall Carbon Nanotubes

The electrochemical detection of the hazardous pollutant 4‐nitrophenol (4‐NP) at low potentials, in order to avoid matrix interferences, is an important research challenge. This study describes the development, electrochemical characterization and utilization of a multiwall carbon nanotube (MWCNT) film electrode for the quantitative determination of 4‐NP in natural water. Electrochemical impedance spectroscopy measurements showed that the modified surface exhibits a decrease of ca. 13 times in the charge transfer resistance when compared with a bare glassy carbon (GC) surface. Voltammetric experiments showed the possibility to oxidize a hydroxylamine layer (produced by the electrochemical reduction of 4‐NP on the GC/MWNCT surface) in a potential region which is approximately 700 mV less positive than that needed to oxidize 4‐NP, thus minimizing the interference of matrix components. The limit of detection for 4‐NP obtained using square‐wave voltammetry (0.12 μmol L^?1) was lower than the value advised by EPA. A natural water sample from a dam located in São Carlos (Brazil) was spiked with 4‐NP and analyzed by the standard addition method using the GC/MWCNT electrode, without any further purification step. The recovery procedure yielded a value of 96.5% for such sample, thus confirming the suitability of the developed method to determine 4‐NP in natural water samples. The electrochemical determination was compared with that obtained by HPLC with UV‐vis detection.     

Isobaric vapor–liquid equilibria for binary and ternary mixtures with cyclohexane,cyclohexene, and morpholine at 100 kPa

Vapor–liquid equilibria (VLE) data at 100 kPa have been determinated for the ternary system cyclohexane + cyclohexene + morpholine and two constituent binary systems cyclohexane + morpholine and cyclohexene + morpholine. The thermodynamic consistency of experimental data has been verified. Both binary systems deviate moderately from ideality without the presence of an azeotrope. The VLE data have been well correlated using local composition models (Wilson, NRTL and UNIQUAC) and have been also predicted with the original UNIFAC.     

Influence of the synthetic conditions on the structural diversity of extended manganese-oxalato-1,2-bis(4-pyridyl)ethylene systems

We report herein the synthesis and physicochemical characterization of eight new manganese-oxalato compounds with 1,2-bis(4-pyridyl)ethylene (bpe): {(Hbpe)(2)[Mn(2)(μ-ox)(3)]·～0.8(C(2)H(5)OH)·～0.4(H(2)O)}(n) (1), {[Mn(μ-ox)(μ-bpe)]·xH(2)O}(n) (2), [Mn(2)(μ-ox)(2)(μ-bpe)(bpe)(2)](n) (3), [Mn(μ-ox)(μ-bpe)](n) (4a and 4b), and {[Mn(4)(μ-ox)(3)(μ-bpe)(4)(H(2)O)(4)]·(X)(2)·mY}(n) with X = NO(3)(-) (5a), Br(-) (5b), and ClO(4)(-) (5c) and Y = solvation molecules. The appropriate selection of the synthetic conditions allowed us to control the crystal structure and to design extended 2D and 3D frameworks. Compound 1 is obtained at acid pH values and its crystal structure consists of stacked [Mn(2)(μ-ox)(3)](2-) layers with cationic Hbpe(+) molecules intercalated among them. Compound 2 was obtained at basic pH values with a manganese/bpe ratio of 1:1, and the resulting 3D structure consists of an interpenetrating framework in which metal-oxalato chains are bridged by bpe ligands, leading to a microporous network that hosts a variable number of water molecules (between 0 and 1) depending on the synthetic conditions. Compound 3, synthesized with a manganese/bpe ratio of 1:3, shows a 2D framework in which linear metal-oxalato chains are joined by bis-monodentate 1,2-bis(4-pyridyl)ethylene ligands. The thermal treatment of compound 3 permits the release of one of the bpe molecules, giving rise to two new 2D crystalline phases of formula [Mn(μ-ox)(μ-bpe)](n) (4a and 4b) depending on the heating rate. The open structures of 5a-5c were synthesized in a medium with a high concentration of nitrate, perchlorate, or bromide salts (potassium or sodium as cations). These anions behave as templating agents directing the crystal growing toward a cationic porous network, in which the anions placed in the voids and channels of the structure present high mobility, as inferred from the ionic exchange experiments. Variable-temperature magnetic susceptibility measurements show an overall antiferromagnetic behavior for all compounds, which are discussed in detail.     

Voltammetric analysis of Pb(II) in natural waters using a carbon paste electrode modified with 5-mercapto-1-methyltetrazol grafted on hexagonal mesoporous silica

A hexagonal mesoporous silica (HMS) functionalized with a 5-mercapto-1-methyltetrazole derivative was employed to prepare a chemically modified carbon paste electrode for Pb(II) detection in aqueous solution by square wave adsorptive stripping voltammetry. The optimal operating conditions were 5 min preconcentration time at pH 6.5, and 120 s electrolysis time in 0.2 mol L^?1 HCl. Under these conditions, the voltammetric signal increased linearly with the preconcentration time in the range 1 to 10 min and with the Pb(II) concentration in the range 1 to 100?µg L^?1. The electrode was reproducible and sensitive. Simultaneous determination of Pb, Cd and Cu was also carried out with the electrode. The accuracy of the method was validated by analysing Pb(II) in tap water and groundwater samples.     

An SPR biosensor for the detection of microcystins in drinking water

A surface plasmon resonance (SPR) biosensor for the detection of microcystins (MCs) in drinking water has been developed. Several assay formats have been evaluated. The selected format is based on a competitive inhibition assay, in which microcystin-LR (MCLR) has been covalently immobilized onto the surface of an SPR chip functionalized with a self-assembled monolayer. The influence of several factors affecting sensor performance, such as the nature and concentration of the antibody, the composition of the carrier buffer, and the blocking and regeneration solutions, has been evaluated. The optimized SPR biosensor provides an IC₅₀ 0.67 ± 0.09 μg L⁻¹, a detection limit of 73 ± 8 ng L⁻¹, and a dynamic range from 0.2 to 2.0 μg L⁻¹ for MCLR. Cross-reactivity to other related MCs, such as microcystin-RR (88%) and microcystin-YR (94%), has also been measured. The SPR biosensor can perform four simultaneous determinations in 60 min, and each SPR chip can be reused for at least 40 assay–regeneration cycles without significant binding capacity loss. The biosensor has been successfully applied to the direct analysis of MCLR in drinking water samples, below the provisional guideline value of 1 μg L⁻¹ established by the World Health Organization for drinking water.     

In vitro evaluation of cytotoxic and inflammatory properties of silica nanoparticles of different sizes in murine RAW 264.7 macrophages

The biological response to four well-characterized amorphous silica nanoparticles was investigated in RAW 264.7 macrophages in view of their potential application as drug carriers to sites of inflammation. All silica nanoparticles-induced cell membrane damage, reduced metabolic activity, generated ROS and released various cytokines, but to different extents. Two silica nanoparticles of 34 nm (A and B) with different zetapotentials were more cytotoxic than (aggregated) 11 and 248 nm nanoparticles, while cytokines were mostly induced by the (aggregated) 11 nm and only one of the 34 nm nanoparticles (34A). The results indicate that specific silica nanoparticles may have counterproductive effects, for example when used as carriers of anti-inflammatory drugs. The physicochemical properties determining the response of nanoparticles vary for different responses, implying that a screening approach for the safe development of nanoparticles needs to consider the role of combinations of (dynamic) physicochemical properties and needs to include multiple toxicity endpoints.