A lithiation approach to cordycepin analogues variously substituted at the C-8 position

Several 8-substituted cordycepins were prepared via LDA lithiation of 2′,5′-bis-O-(t-butyldimethylsilyl)-cordycepin and successive reactions of its C-8 lithiated species with various types of electrophiles. Wittig reaction of the 8-formyl derivative was also examined.     

Comparison of PAMAM-Au and PPI-Au nanocomposites and their catalytic activity for reduction of 4-nitrophenol

Dendrimer-Au nanocomposites are prepared in aqueous solutions using poly(amidoammine)dendrimers (PAMAM) (generation 2, 3, and 5) and poly(propyleneimine)dendrimers (PPI)(generation 2, 3, and 4) by wet chemical NaBH(4) method. The Au nanoparticles thus obtained are 2-4 nm in diameter for both dendrimers and no generation dependence on the particle size is observed, whereas the generations of the dendrimers are increased as stabilization of Au-nanoparticles is achieved with lower dendrimer concentrations. Studies of the reduction reaction of 4-nitrophenol using these nanocomposites show that the rate constants for the PAMAM dendrimers (generations 2 and 3) are higher than those for the PPI dendrimers (generations 2 and 3), while a distinct difference in the rate constants is not seen for the PAMAM dendrimer (generation 5) or the PPI dendrimer (generation 4). In addition, the rate constants for the reduction of 4-nitrophenol involving all the dendrimers decrease with increases in dendrimer concentrations.     

Ring transformation of 6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine. IV (1). Reduction and reaction of 5a-acetyl-6a-ethoxycarbonyl-5a,6a-dihydro-6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine-3-carbonitriles with primary amines

The reaction of 5a-acetyl-6-ethoxycarbonyl-5a,6a-dihydro-6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine-3-carbonitrile ( 1a ) with benzylamine gave ethyl l-benzyl-5-cyano-8a,9-dihydro-2-methyl-1H-pyrrolo[3,4-e]-pyrazolo[1,5-a]pyrimidine-8a-carboxylate ( 2a ), in addition to 5-acetyl-3-benzylamino-1-(4-cyanopyrazol-3-yl)- 2-pyridone ( 3 ). Reaction of 1a with aniline gave ethyl 6-acetyl-8-anilino-3-cyano-7,8-dihydro-4H-pyrazolo-[1,5-a][1,3]diazepine-8-carboxylate ( 4 ), in addition to ethyl 3-cyano-7-methyl-6-pyrazolo[1,5-a]pyrimidine-acrylate ( 5 ). On the other hand, the same reactions of 1b with benzylamine or aniline gave 2b or 8b , respectively. Though catalytic hydrogenation of 1a over 5% palladium-carbon proceeded by ring fission of cyclopropane ring to give 9 , 1a (or 1b ) afforded 4,5-dihydro derivatives ( 13 or 15 ) by catalytic hydrogenation over platinum oxide. The reactivity of 5-methoxy-4,5,5a,6a-tetrahydro-6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine ( 16 ), which are related analogs of 1a,b , is also described.     

Synthesis and central nervous system stimulant activity of 5,8-methanoquinazolines fused with imidazole,thiadiazole, pyrimidine and 1,3,5-triazine

5,8-Methanoquinazolines fused with imidazoles 4a-4b , thiadiazoles 5–6 , pyrimidines 7, 9, 11 and 12 , and 1,3,5-triazine 13 were prepared starting from (5R,8S)-2-amino-8,9,9-trimethyl-5,6,7,8-tetrahydro-5,8-methanoquinazoline 3 . Most compounds possessed central nervous system stimulant activities.     

Synthesis and Characterization of Ge(II), Sn(II), and Pb(II) Monoamides with -NH2 Ligands

The synthesis and characterization of the first divalent germanium, tin, and lead monoamide derivatives of the parent amide group -NH(2) are presented. They have the general formula (ArMNH(2))(2) (M = Ge, Ar = Ar'(C(6)H(3)-2,6-Pr(i)(2)) or Ar* (C(6)H(3)-2,6(C(6)H(2)-2,4,6-Pr(i)(3))); M = Sn, Ar = Ar*; M = Pb, Ar = Ar*). For germanium and tin, they were obtained by reacting the corresponding terphenyl halides of the group 14 elements with liquid ammonia in diethyl ether. The lead amide derivative (Ar*PbNH(2))(2) was synthesized by reaction of LiNH(2) with Ar*PbBr in diethyl ether. The compounds were characterized by IR and multinuclear NMR spectroscopies and by X-ray crystallography in the case of the (Ar'GeNH(2))(2) or (Ar*SnNH(2))(2) derivatives. They possess dimeric structures with two -NH(2) groups bridging the germanium and tin centers. For lead, the reaction with ammonia led to isolation of a stable ammine complex of formula Ar*PbBr(NH(3)) which was characterized by IR and NMR spectroscopies and by X-ray crystallography. It is the first structural characterization of a divalent lead ammine complex.     

Kinetic study of the electron-transfer oxidation of the phenolate anion of a vitamin E model by molecular oxygen generating superoxide anion in an aprotic medium

Electron-transfer reduction of molecular oxygen (O2) by the phenolate anion (1-) of a vitamin E model, 2,2,5,7,8-pentamethylchroman-6-ol (1H), occurred to produce superoxide anion, which could be directly detected by a low-temperature EPR measurement. The rate of electron transfer from 1- to O2 was relatively slow, since this process is energetically unfavourable. The one-electron oxidation potential of 1- determined by cyclic voltammetric measurements is sufficiently negative to reduce 2,2-bis(4-tert-octylphenyl)-1-picrylhydrazyl radical (DOPPH*) to the corresponding one-electron reduced anion, DOPPH-, suggesting that 1- can also act as an efficient radical scavenger.     

Aqueous Titanate Sols from Ti Alkoxide-α-Hydroxycarboxylic Acid System and Preparation of Titania Films from the Sols

Aqueous titanate sols were prepared by reactions of titanium tetraisopropoxide (TIP) with -hydroxycarboxylic acids in water. IR and Raman spectra, and elemental analyses of the precipitates obtained from the sols revealed that the carboxylates were chelated to titanium but the Ti species were polymerized to form a cluster that had a colloidal nature. Spin-coating of titania (TiO₂) thin films from these sols was also examined. Interestingly, it was found that (004) preferentially oriented anatase films with refractive index of 2.54 were obtained from TIP-lactic acid-NH₃ (1:1:1, molar ratio) aqueous sol. This crystallographic orientation was characteristic of the TIP-lactic acid-NH₃ (1:1:1) system, and was not affected by the kinds of substrates used and the heating rate of the film. TEM observation indicated that small anatase grains had already formed at 200°C. Therefore, the crystallographic orientation might depend strongly on the structure of the chemical species of the precursor solutions.     

Quantitative estimation of NH3 partial pressure in H2 desorbed from the Li-N-H system by Raman spectroscopy

The partial pressure of NH3 gas estimated by Raman spectroscopy indicates that approximately 0.1% NH3 inevitably contaminates the H2 desorbed from a hydrogen storage material composed of LiH and LiNH2 at any temperature up to 400 degrees C in a closed system.     

Azobenzene-containing polyamic acid with excellent Langmuir-Blodgett-Kuhn film formation behavior suitable for all-optical switching

To generate command surfaces for all-optical switching, highly ordered polymeric Langmuir-Blodgett-Kuhn (LBK) multilayers were fabricated onto silicon substrates and gold-coated optical glass slides from novel azobenzene-bearing polyamic acid systems. Pronounced Bragg peaks and well-defined Kiessig fringes observed in the X-ray reflectivity measurement for samples on silicon substrates indicate that these films possess a regularly repeated Y-type LBK multilayer structure and ultrasmooth surfaces. Fourier transform infrared (FT-IR) spectra taken by grazing incidence reflection suggest specific orientations of the functional groups in the layers. The excellent film-forming properties of the polyamic acid allow for a smooth buildup of several hundreds of layers of the LBK films onto gold-coated glass slides, which in turn allows for determining the geometrical thickness and the anisotropic refractive indices of the films by using optical waveguide spectroscopy. Interestingly, the probe laser beam induced a distinct fluorescence signal from the films, which remained even after the film underwent a thermal imidization process at 160 degrees C for 8 h in vacuo. LBK films fabricated from these compounds can be successfully applied for all-optically switching the alignment of liquid crystals by irradiation with light of different wavelengths.     

Evaluation of a dual electrospray ionization/atmospheric pressure chemical ionization source at low flow rates (∼50 µL/min) for the analysis of both highly and weakly polar compounds

The atmospheric pressure ionization (API) source for a commercial mass spectrometer was modified to operate as a dual source in both the electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) techniques by simultaneously utilizing the electrospray probe and the corona discharge needle. A switching box was designed to operate in either manual or programmable modes to permit rapid switching between ionization techniques without changing sources, probes, or breaking vacuum. The source can be operated using the following ionization techniques: ESI only, APCI only, ESI/APCI simultaneously, and ESI/APCI alternatingly. The optimum operating conditions for these ionization techniques were similar to the manufacturer’s original specifications except that the APCI flow rate was lower (～50 µL/min versus 1000 µL/min) and externally heated nebulizing gas was found to be desirable. A four-component mixture, introduced by flow injection, was used to demonstrate the versatility of the dual ESI/APCI source.