Affinity NMR: decoding DNA binding

We have shown that affinity NMR can be used to edit a NMR spectrum so that ligands that have affinity to DNA can be observed in the presence of other nonbinding molecules. Diffusion encoded spectroscopy (DECODES) can be used to identify the binding ligands. We were able to identify Hoechst 33342 as binding to the Drew-Dickerson dodecamer d(CGCGAATTCGCG)2 in the presence of the nonbinding molecules adenine, adenosine, and thiamine. Affinity NMR appears to be readily applicable to DNA systems for the following reasons. (1) The relaxation rate of the DNA oligonucleotides is favorable, thus the signal intensity loss due to relaxation is not severe. (2) A comparison of the patterns of the DNA cross-peaks upon binding in the two-dimensional total correlation spectroscopy and correlation spectroscopy spectrum are easily performed, and the ligand signals in the two-dimensional DECODES spectrum can be readily identified. (3) The aromatic part of the DNA spectrum is devoid of 2D cross-peaks in these correlation spectra, greatly facilitating the interpretation of the bound ligand in the DECODES spectrum.     

Surface nuclear spin relaxation of 199Hg

We report the results of a detailed study of surface relaxation of 199Hg nuclear spins in paraffin coated cells. From measurements of the magnetic field and temperature dependence of the spin relaxation rates we determine the correlation time for magnetic fluctuations and the surface adsorption energy. The data indicate that surface relaxation is caused by dipolar coupling to paramagnetic sites on the surface. We also observe changes in the spin relaxation rate caused by ultraviolet radiation resonant with the 254 nm transition in Hg.     

A Mild Isomerization Reaction for β,γ‐Unsaturated Ketone to α,β‐Unsaturated Ketone

A series of β,γ‐unsaturated ketones were isomerized to their corresponding α,β‐unsaturated ketones by the introduction of DABCO in iPrOH at room temperature. The endo‐cyclic double bond (β,γ‐position) on ketone was rearranged to exo‐cyclic double bond (α,β‐position) under the reaction conditions.     

纳秒强激光场中苯电离产生高价离子的研究

用25 ns脉冲Nd-YAG 532 nm的激光，在1010～1011 W•cm－2的光场强度下，利用飞行时间质谱对He、 N2、Ar载气条件下苯的激光电离过程进行了研究.发现当利用氩作为载气时，除观察到C2＋、C2H2+、C3H3+、C6H6+离子外，还观察到很强的Cq＋(q=1～3)高价离子.这些离子都有很高的平动能， C2＋的最可几平动能为12.9 eV， C3＋为37.5 eV.通过改变载气种类和压力及在不同光场强度条件下的实验，可以认为这些高价离子来源于含苯团簇的库仑爆炸过程.     

Enantioseparation of Amino Acid Derivatives with a Cellulose-Based Chiral Stationary Phase

Five structurally related amino acid derivatives were enantioseparated by HPLC with a commercially available chiral stationary phase, Chiralcel OD-H. The chromatographic experiments were performed in the normal phase mode. n-Hexane/polar alcohol was used as mobile phase. Excellent baseline enantioseparations could be obtained for all these solutes. The effects of the concentration of polar alcohol and the column temperature on the retentions and enantioseparations were studied in detail. From the van't Hoff plots the corresponding apparent thermodynamic parameters were derived. Mechanism aspects of chiral recognition were discussed based on the relationship between the thermodynamic parameters and the structures of the solutes. It was found that the substituent of the phenyl group on the residual group of the amino acid derivatives was close relevant to thermodynamic origin of enantioseparation. Much better enthalpy–entropy compensation effect was obtained by plotting the differential, rather than the original, thermodynamic parameters.     

Separation and determination of seven fluoroquinolones by pressurized capillary electrochromatography

In this paper, pressurized CEC was used for the separation and determination of seven fluoroquinolones (FQs). The effect of different experimental conditions, such as the concentration and pH of the buffer, the organic modifier concentration, the surfactant and ion-paring agents added to the electrolyte, and applied voltage were studied. All the seven FQs were baseline separated using mobile phase containing 27% v/v ACN, 5 mmol/L Na2HPO4 buffer (pH 4.0 adjusted using citric acid), 11 mmol/L SDS, and 0.01% TEA v/v at detection wavelength of 287 nm and at an applied voltage of -10 kV. The calibration curves were linear (r>0.9991) over a concentration range of 1.0-50.0 mg/L for norfloxacin (NFLX); 2.5-50.0 mg/L for fleroxacin (FLX), ciprofloxacin (CPFX), and lomefloxacin (LMX); and 5.0-50.0 mg/L for enoxacin (ENX), ofloxacin (OFLX), and gatifloxacin (GFLX). The detection limits (S/N = 3) for ENX, OFLX, FLX, NFLX, CPFX, LMX, and GFLX were 0.5, 0.8, 0.4, 0.2, 0.4, 0.5, and 1.0 mg/L, respectively. The method is simple, rapid, and reproducible. It was successfully applied to the analysis of fish muscle samples spiked with FQs. Mean recoveries ranged from 81.6 to 97.6%.     

Experimental and theoretical studies of rate coefficients for the reaction O(3P)+CH3OH at high temperatures

Rate coefficients of the reaction O((3)P) + CH(3)OH in the temperature range of 835-1777 K were determined using a diaphragmless shock tube. O atoms were generated by photolysis of SO(2) with a KrF excimer laser at 248 nm or an ArF excimer laser at 193 nm; their concentrations were monitored via atomic resonance absorption excited by emission from a microwave-discharged mixture of O(2) and He. The rate coefficients determined for the temperature range can be represented by the Arrhenius equation, k(T) = (2.29 +/- 0.18) x 10(-10) exp[-(4210 +/- 100)T] cm(3) molecule(-1) s(-1); unless otherwise noted, all the listed errors represent one standard deviation in fitting. Combination of these and previous data at lower temperature shows a non-Arrhenius behavior described as the three-parameter equation, k(T) = (2.74 +/- 0.07) x 10(-18)T(2.25 +/- 0.13) exp[-(1500 +/- 90)T] cm(3)molecule(-1) s(-1). Theoretical calculations at the Becke-3-Lee-Yang-Parr (B3LYP)6-311 + G(3df,2p) level locate three transition states. Based on the energies computed with coupled clusters singles, doubles (triples) [CCSD(T)]/6-311 + G(3df,2p)B3LYP6-311 + G(3df,2p), the rate coefficients predicted with canonical variational transition state theory with small curvature tunneling corrections agree satisfactorily with the experimental observations. The branching ratios of two accessible reaction channels forming OH + CH(2)OH (1a) and OH + CH(3)O (1b) are predicted to vary strongly with temperature. At 300 K, reaction (1a) dominates, whereas reaction (1b) becomes more important than reaction (1a) above 1700 K.     

Determination of chloride ion by electrochemiluminescence and investigation of the mechanism

The electrochemiluminescence (ECL) of luminol in aqueous alkaline solution was studied.Trace amounts of chloride showed significant effect on the efficiency of light emission of luminol as a posi-tive trigonometrical wave pulse was exerted on the solution. The detection limit for the chloride is5.0 ×10~(-6) mol/L and the linear calibration range extends up to 1.0 ×10~(-2) mol/L; the relative standarddeviation for 1.0 ×10~(-5) mol / L chloride is 5%. The influencing factors for chloride determination arealso discussed. The possible mechanism for the electrochemiluminescence reaction may be due to theoxidation of chloride ion in the solution to ClO~-, and the latter acts on luminol and then gives outluminescence. The method has been applied to determine the total chloride in tap water with satisfactoryresults.     

Liquefaction of corn stover and preparation of polyester from the liquefied polyol

This research investigated a novel process to prepare polyester from corn stover through liquefaction and crosslinking processes. First, corn stover was liquefied in organic solvents (90 wt% ethylene glycol and 10 wt% ethylene carbonate) with catalysts at moderate temperature under atmospheric pressure. The effect of liquefaction temperature, biomass content, and type of catalyst, such H₂SO₄, HCl, H₃PO₄, and ZnCl₂, was evaluated. Higher liquefaction yield was achieved in 2 wt% sulfuric acid, 1/4 (w/w) stover to liquefying reagent ratio; 160°C temperature, in 2h. The liquefied corn stover was rich in polyols, which can be directly used as feedstock for making polymers without further separation or purification. Second, polyester was made from the liquefied corn stover by crosslinking with multifunctional carboxylic acids and/or cyclic acid anhydrides. The tensile strength of polyester is about 5 MPa and the elongation is around 35%. The polyester is stable in cold water and organic solvents and readily biodegradable as indicated by 82% weight loss when buried in damp soil for 10 mo. The results indicate that this novel polyester could be used for the biodegradable garden mulch film production.