BNCT优化网格设计及相关算法研究

用MCNP蒙特卡罗程序模拟了硼中子俘获治疗(BNCT)3种国际基准网格模型, 并与 修正的Snyder椭球模型进行了比较. 在此基础上, 给出了一种保质量守恒、内存量少、易于产生输入文件的4种基本材料成分的BNCT网格模型. 计算结果表明, 在4mm网格下, 新模型可以达到基准模型的精度; 根据解析模型剂量随深度的变化规律, 研究构造了多网格组合模型, 在重要区域计算精度不损失的条件下, 计算时间大大缩短. 最后研究给出了一个既保证精度、又在可接受的时间内完成剂量计算的模型、样本数和相应的算法, 它基本上满足临床BNCT的要求.     

关于均值KIRCHHOFF板非线性边界镇定问题的几点注记

对于均值K IRCHHOFF板非线性边界镇定问题给出几点注记.首先应用G reen公式对具有非线性边界反馈控制的均值K IRCHHOFF板所决定的非线性系统的能量衰减速度进行了重新推导,从而修正了前人的结果.然后应用极大单调函数的定义和分部积分技巧,对均值K IRCHHOFF板非线性边界镇定问题所决定的非线性算子A的极大单调性给出了重新证明,进而更正了已有文献中相应证明的欠妥之处.     

不同溶剂中番茄红素的荧光光谱及其特性研究

用970CRT荧光光度计测定了番茄红素在正己烷、乙酸乙酯、四氢呋喃、氯仿、丙酮和苯等6种溶剂中的荧光光谱以及番茄红素在四氢呋喃溶液中不同浓度下的荧光光谱。对所测光谱分析得出:6种溶剂中荧光光谱的最大峰值波长(λmax)分别为542.5 nm5、48.2 nm5、55.0 nm、555.7 nm、556.4 nm和565.7 nm,由于溶剂效应,随溶剂极性由小到大,荧光光谱的最大峰值波长(λmax)逐渐红移,由这些峰值波长计算得出相应的番茄红素分子在6种溶剂中的跃迁能ET分别为220.5 kJ/mol2、18.2 kJ/mol2、15.6 kJ/mol2、15.3 kJ/mol2、14.9 kJ/mol和211.5 kJ/mol,可见跃迁能ET也随溶剂极性增大而降低;当番茄红素在四氢呋喃溶液中的质量浓度低于50μg/ml时,溶液的荧光强度随溶液浓度增加而增大,当质量浓度高于50μg/ml时,由于番茄红素的激发态分子与基态分子相互作用,荧光强度反而减小;在浓度低于80μg/ml的溶液中,番茄红素的荧光光谱除最大峰值外还有三个较小峰值,据此计算得出相应的番茄红素分子的跃迁能分别为E(T1)=278.2 kJ/mol、E(T2)=260.2 kJ/mol和E(T3)=239.3 kJ/mol。     

Synergistic effect between 4-(2-pyridylazo) resorcin and chloride ion on the corrosion of cold rolled steel in 0.5 M sulfuric acid

The corrosion inhibition of 1-(2-pyridylazo)-2-naphthol (PAR) on the corrosion of cold rolled steel in 0.5 M sulfuric acid (H₂SO₄) was studied using weight loss method and potentiodynamic polarization method. Results obtained revealed that together with chloride ion, PAR is an effective corrosion inhibitor for steel corrosion in sulfuric acid. It was found that for steel corrosion inhibition in the presence of single PAR in sulfuric acid the Temkin adsorption isotherm may be used to explain the adsorption phenomenon. For the mixture of PAR and NaCl used as corrosion inhibitor, however, the Langmuir adsorption isotherm can be used to satisfactorily elucidate the adsorption of mixture of PAR and NaCl. Potentiodynamic polarization studies showed that single PAR mainly acts as a cathodic inhibitor for the corrosion of steel in 0.5 M sulfuric acid. The mixture of PAR and chloride ion, however, acts as a mixed type inhibitor that mainly inhibits cathodic reaction of the steel corrosion in sulfuric acid. By means of electrochemical polarization tests, a desorption potential at ca. −370 mV was observed for the adsorption of mixture of PAR and chloride ion, when potential reaches this value, adsorbed inhibitor molecule heavily departs from the steel surface. For the mixture of PAR and chloride ion, thermodynamic parameters such as adsorption heat, adsorption entropy and adsorption free energy were obtained from experimental data of the temperature studies of the inhibition process at four temperatures ranging from 30 to 45 °C, the kinetic data such as apparent activation energies and pre-exponential factors at different concentrations of the inhibitor were calculated, and the effect of the apparent activation energies and pre-exponential factors on the corrosion rates of cold rolled steel was discussed. The most suitable range of inhibitor concentration was discussed. The inhibitive action was satisfactorily explained by using both thermodynamic and kinetic models. Synergism between chloride ion and PAR was proposed. The results obtained from weight loss and potentiodynamic polarization were in good agreement.     

Differentiation of chiral phosphorus enantiomers by P and H NMR spectroscopy using amino acid derivatives as chemical solvating agents

The ability of commercially available amino acid derivatives, especially Fmoc-Trp(Boc)-OH, to differentiate enantiomers of chiral phosphonates, phosphinates, phosphates, phosphine oxides, and phosphonamidates is demonstrated with (31)P, (13)C, and (1)H NMR spectroscopy. The chiral differentiation provided a rapid and convenient method for measuring the enantiomeric purity of these phosphorus compounds.     

一种新型手性功能单体的合成

以手性芳胺为母体,丙烯酰氯为酰化试剂,合成了新型手性功能单体(1)。用1合成了一系列手性分子印迹聚合物。1的结构经1H NMR,IR,MS及元素分析确证。     

5 TW/40 fs级台式钛宝石激光系统研究

在TSA-25系统输出35 mJ,800 nm啁啾脉冲的基础上,建立了以钛宝石作为增益介质的二级啁啾脉冲放大(CPA)系统。使用0.6 J和1.6 J,532 nm,10 Hz Nd∶YAG激光抽运,输出脉冲能量达到500 mJ,经压缩脉冲宽度为41 fs,压缩器的能量转换效率为63%,峰值功率可达7.6 TW。通过对放大器系统的钛宝石晶体、抽运密度以及多通结构通道数的选择等实验,有效地提高了能量放大器的萃取效率。其主放大器能量萃取效率达到32%,整个系统占用尺寸不到10 m2。     

Double neutron/proton ratio of nucleon emissions in isotopic reaction systems as a robust probe of nuclear symmetry energy

The double neutron/proton ratio of nucleon emissions taken from two reaction systems using four isotopes of the same element, namely, the neutron/proton ratio in the neutron-rich system over that in the more symmetric system, has the advantage of reducing systematically the influence of the Coulomb force and the normally poor efficiencies of detecting low energy neutrons. The double ratio thus suffers less systematic errors. Within the IBUU04 transport model the double neutron/proton ratio is shown to have about the same sensitivity to the density dependence of nuclear symmetry energy as the single neutron/proton ratio in the neutron-rich system involved. The double neutron/proton ratio is therefore more useful for further constraining the symmetry energy of neutron-rich matter.     

应力对La0.83Sr0.17MnO3薄膜输运性能的影响

采用溶胶-凝胶方法在Si(111)上制备了LSMO(x=0.17)薄膜.研究了块体材料和不同厚度薄膜R -T曲线、红外光谱和X射线衍射.结果表明，LSMO薄膜属于正交晶体结构，薄膜取向与膜厚度 有关，当膜厚度为450nm或680nm时，主要取向〈200〉，而膜厚度为900nm时取向为〈020〉 ：根据离子对相互作用能和谐振子模型，得到了红外吸收与Mn—O—Mn键长和键角关系式，6 00cm^-1附近红外吸收与晶格常数b的变化有关；块体与薄膜的金属—绝缘体转变 温度(T_MI)存在较大差别，薄膜转变温度显著低于块体，并与厚度有一定关系. 认为是LSMO薄膜中的应力诱导了晶格常数变化，引起键角改变及JT效应是转变温度变化的主 要原因. 关键词： 单晶硅 晶格常数 金属—绝缘体转变温度 应力诱导     

Formation of long range ordered arrangement of quantum dots with the help of lateral centripetal flow

A simple “chimney” method was used to eliminate the voids in an arrangement of quantum dots sized 2 nm on a solid substrate, which resulted in a large well ordered superlattice of area in the order more than 1 μm². Based on the principle of speeding up the interparticle interaction of nanoparticles to overcome the particle-substrate one, a lateral centripetal force originated from a glass tube acting as a chimney in a simple evaporation device is imposed. This method allows the packing process to be controlled in a mechanical force field, that is, with the same nanogold dispersion different patterns on a substrate—from separate dots to an ordered compact monolayer or even a multilayer structure—could be easily obtained.