硅探测器的数字化脉冲形状甄别

介绍了利用硅探测器的脉冲形状甄别进行粒子鉴别的原理。详细叙述了基于数字化方法的脉冲形状甄别的实现。采样频率和位数是数字化方法的两个重要参数。对于硅探测器信号,采用100 MS/s,12 bit的Digitizer可以满足脉冲形状甄别法对时间分辨的要求。同时对该方法粒子鉴别的特征和能量阈值做了简要的分析和对比。粒子背面入射硅探测器的所得的阈值低于正面入射的情况。例如对于氖周围的同位素,背面入射情况的阈值约为100 MeV,为正面入射情况下鉴别阈值的二分之一,相当与ΔE-E方法中ΔE探测器厚度约为60 μm情况下的阈值。最后定性讨论了硅探测器的电阻率不均匀性和沟道效应对粒子鉴别性能的影响。In this paper Pulse Shape Discrimination(PSD) for silicon detector has been briefly introduced. The emerging digital method successfully applied to detector signal processing makes digital PSD method one of the most promising particle identification methods. Sampling frequency and the number of bits are two key parameters of digital method. For silicon detector signal, adopting 100 Ms/s, 12 bit Digitizer can satisfy the time resolution requirement of PSD method. The identification characteristic and energy threshold of this method have been discussed and compared with both front injection and rear injection cases. Energy threshold with rear injection usually is much lower than that with front injection. For example, around for Neon isotope energy threshold with rear injection is about 100 MeV which is only half of the threshold with front injection, also equivalent to thickness of about 60 μm silicon detector threshold in ΔE-E method. At the end the impact of silicon detector's resistivity nonuniformity and channel effect on the identification capacity of PSD method has been discussed in detail.     

Research on the resolution of micro stereo lithography

Micro stereo lithography is a kind of technology utilizing the solidified effect that photo curable polymer will appear under ultraviolet （UV） laser exposure. It is widely used in three-dimensional （3D） micro fabrication. We get the experimental values of a pair of UV laser curing coefficients, absorption coefficient and critical curing energy, of curable resin by fitting the calculation results of the Gaussian beam theory and experimental curing results. The theoretical relation between the curing unit＇s shape and the exposure features of time and intensity of convergent Gaussian beam is presented. The calculation and experimental results of curing unit under different conditions agree well with each other. This research offers a steady base for further research about the improvement of resolution.     

Hugoniot实验的粒子速度测量不确定度分析

 不确定度评定是Hugoniot实验的一项重要工作,针对飞片撞击法和对比法两类主要Hugoniot实验进行了粒子速度的测量不确定度分析。根据直接测量量和间接输入量及其不确定度,用不确定度传递律表述了粒子速度的不确定度,并给出了冲击压强（p）、压缩密度（ρ）和压缩比容（v）的评定方法。对于样品和基板为不同材料的非对称碰撞及对比法实验,不确定度评定除A类评定外还应包括B类评定,应考虑用Hugoniot镜像线近似二次冲击绝热线或卸载线而导入的不确定度。在Hugoniot实验中应尽量避免涉及B类评定的其它因素,如同种材料初始密度的显著差异、飞片击靶前的温升等情况。     

宽脉冲网络信号源及应用

 通过对电探针工作原理的分析,提出采用宽脉冲网络源代替传统窄脉冲网络源的技术措施,以解决时常遇到的“提前导通”问题。模拟计算和实验测量结果表明：尽管受到提前导通的影响,采用宽脉冲网络源的电探针信号仍然能够分辨出冲击波或飞片、自由面到达观测点的时间信息,从而给出真实可信的时间测量值。     

二级轻气炮发射过程中前冲气体的初步研究

 在二级轻气炮发射过程中,靶室内的残存气体和绕行到弹丸前方的推进气体都有可能对实验结果造成影响。利用石英传感器测量并得到了二级轻气炮高速弹丸发射时前冲气体的压力信号,并计算得到了相应的压力。实验结果表明：二级轻气炮发射时确实存在前冲气体现象,但其压力幅值较小,约为10^-2 GPa量级,不会对高压物理实验的结果造成明显的影响。     

磷酸铝镍介孔催化材料的低热固相合成及形成机理

以十六烷基三甲基溴化铵为模板,通过二水磷酸二氢钠、六水氯化铝与六水氯化镍的固相反应直接合成了磷酸铝镍(NiAlPO)介孔材料。用X-射线衍射、高分辨透射电镜、N₂脱附-吸附、红外光谱仪等分析技术对材料进行了物相与表面织构表征,通过电感耦合等离子发射光谱仪对材料的元素组成进行分析;探讨了磷酸铝镍介孔材料的形成机理。结果表明,金属镍已进入了磷酸铝骨架,镍的含量为5.15wt%;所得介孔材料呈蠕虫状、无定形的六面体结构;其BET比表面积为157.3 m²·g^-1,孔径分布中心为3.65和5.3 nm。P(Al)-O-Ni键伸缩振动所产生的吸收峰为983.7 cm^-1。     

大气弱湍流下星地光链路衰落特性影响因素分析

研究了弱湍流条件下星地光通信链路的衰落概率、平均衰落次数以及平均衰落时间3个重要参数的统计特性,并通过数值仿真分析了链路天顶角、光波长以及接收机海拔高度对链路衰落特性的影响。结果表明:减小天顶角和提高接收机探测灵敏度可以改善链路的衰落特性;1.55 m激光较0.85 m、1.06 m激光更适合于星地光通信;地面接收机应尽量建在2 000 m以上的高海拔地区。     

表面张力对Rayleigh-Taylor不稳定性谐波的影响

Using the method of the parameter expansion up to the third order, explicitly investigates surface tension effect on harmonics at weakly nonlinear stage in Rayleigh-Taylor instability (RTI) for arbitrary Atwood numbers and compares the results with those of classical RTI within the framework of the third-order weakly nonlinear theory. It is found that surface tension strongly reduces the linear growth rate of time, resulting in mild growth of the amplitude of the fundamental mode, and changes amplitudes of the second and third harmonics, as is expressed as a tension factor coupling in amplitudes of the harmonics. On the one hand, surface tension can either decrease or increase the space amplitude; on the other hand, surface tension can also change their phases for some conditions which are explicitly determined.     

动态发射率与辐射亮度同时测量实验中的时间精确同步技术

分析了轻气炮实验中飞片速度漂移带来的冲击波到达样品/窗口界面时刻漂移问题、主要影响因素以及动态发射率与辐射亮度同时测量实验中的时序要求,采用镀膜光纤探针作为同时测量实验中动态发射率测量照明光源的触发装置,设计了光纤探针-样品之间的距离,并对设计余量进行了简单分析,解决了同时测量实验中的时间精确同步问题。在2发动态考核实验中,设计的飞片速度为4.1km/s,实测飞片速度漂移量分别为70和210m/s,动态发射率测量信号按照实验预期叠加在了样品/窗口界面热辐射信号平台之上,时序控制能够满足动态发射率与辐射亮度同时测量实验中的时间精确同步要求。     

反应气体驱动二级轻气炮发射特性实验及数值计算北大核心CSCD

通过实验确定了20/57mm构型反应气体驱动二级轻气炮的气体装填参数与弹丸动能的关系。实验结果表明,反应气体驱动二级轻气炮的弹丸动能与气体反应化学能之间基本满足二次函数关系,系统发射稳定性满足加载实验要求。发展了基于气体爆轰模型的计算方法,通过数值计算获得了反应气体驱动二级轻气炮的发射特性,弹丸速度的计算结果与实测结果吻合较好。